Aerosol lidar intercomparison in the framework of the EARLINET project. 3. Raman lidar algorithm for aerosol extinction, backscatter, and lidar ratio

An intercomparison of the algorithms used to retrieve aerosol extinction and backscatter starting from Raman lidar signals has been performed by 11 groups of lidar scientists involved in the European Aerosol Research Lidar Network (EARLINET). This intercomparison is part of an extended quality assurance program performed on aerosol lidars in the EARLINET. Lidar instruments and aerosol backscatter algorithms were tested separately. The Raman lidar algorithms were tested by use of synthetic lidar data, simulated at 355, 532, 386, and 607 nm, with realistic experimental and atmospheric conditions taken into account. The intercomparison demonstrates that the data-handling procedures used by all the lidar groups provide satisfactory results. Extinction profiles show mean deviations from the correct solution within 10% in the planetary boundary layer (PBL), and backscatter profiles, retrieved by use of algorithms based on the combined Raman elastic-backscatter lidar technique, show mean deviations from solutions within 20% up to 2 km. The intercomparison was also carried out for the lidar ratio and produced profiles that show a mean deviation from the solution within 20% in the PBL. The mean value of this parameter was also calculated within a lofted aerosol layer at higher altitudes that is representative of typical layers related to special events such as Saharan dust outbreaks, forest fires, and volcanic eruptions. Here deviations were within 15%.     

Aerosol lidar intercomparison in the framework of the EARLINET project. 1. Instruments

In the framework of the European Aerosol Research Lidar Network to Establish an Aerosol Climatology (EARLINET), 19 aerosol lidar systems from 11 European countries were compared. Aerosol extinction or backscatter coefficient profiles were measured by at least two systems for each comparison. Aerosol extinction coefficients were derived from Raman lidar measurements in the UV (351 or 355 nm), and aerosol backscatter profiles were calculated from pure elastic backscatter measurements at 351 or 355, 532, or 1064 nm. The results were compared for height ranges with high and low aerosol content. Some systems were additionally compared with sunphotometers and starphotometers. Predefined maximum deviations were used for quality control of the results. Lidar systems with results outside those limits could not meet the quality assurance criterion. The algorithms for deriving aerosol backscatter profiles from elastic lidar measurements were tested separately, and the results are described in Part 2 of this series of papers [Appl. Opt. 43, 977-989 (2004)]. In the end, all systems were quality assured, although some had to be modified to improve their performance. Typical deviations between aerosol backscatter profiles were 10% in the planetary boundary layer and 0.1 x 10(-6) m(-1) sr(-1) in the free troposphere.     

Thermofraktographie zur Schnellanalyse von Kunststoffen. 4. Mitt.: Identifizierung der Basiskomponenten von Epoxidharzen

Thermofractography is suitable for the rapid identification of the basic components of epoxy resins. 2–3 mg of the polymer sample are being heated in the temperature gradient of 200 to 450°C. The thus forming decomposition products are being transferred as a starting line onto the separating thin layer by means of a carrier gas. After development the thermofractogram (TFG) shows in the temperature range of 200 to approx. 350°C the free oligomeres. The resulting phenols and their subsequent products appear on the TFG from 350°C. A cycloaliphatic type does not give phenolic fragments. The degradation mechanisms of epoxy resins are being discussed in regard to the TFG results and are being confirmed by establishing TGA curves. For the rapid evaluation of the thermofractograms of epoxy resins a questioning scheme is given as an evaluation key.     

Chromosome analysis in patients with sarcoidosis

Chromosome analysis of lymphocytes from the peripheral blood of 20 patients with sarcoidosis and 10 healthy controls showed a significantly greater number of hypomodal cells among the patients. Two patients receiving systemic treatment with glucocorticoids had many chromosomal aberrations.     

On-road measurement of particle emission in the exhaust plume of a diesel passenger car

Particle size distributions were measured under real world dilution conditions in the exhaust plume of a diesel passenger car closely followed by a mobile laboratory on a high speed test track. Under carefully controlled conditions the exhaust plume was continuously sampled and analyzed inside the mobile laboratory. Exhaust particle size distribution data were recorded together with exhaust gas concentrations, i.e., CO, CO2, and NO(x), and compared to data obtained from the same vehicle tested on a chassis dynamometer. Good agreement was found for the soot mode particles which occurred at a geometric mean diameter of approximately 50 nm and a total particle emission rate of 10(14) particles km(-1). Using 350 ppm high sulfur fuel and the standard oxidation catalyst a bimodal size distribution with a nucleation mode at 10 nm was observed at car velocities of 100 km h(-1) and 120 km h(-1), respectively. Nucleation mode particles were only present if high sulfur fuel was used with the oxidation catalyst installed. This is in agreement with prior work that these particles are of semivolatile nature and originate from the nucleation of sulfates formed inside the catalyst. Temporal effects of the occurrence of nucleation mode particles during steady-state cruising and the dynamical behavior during acceleration and deceleration were investigated.     

Application of mid-infrared spectroscopy: measuring hydrogen peroxide concentrations in bleaching baths

The presented work applies mid-infrared attenuated total reflection (ATR) spectroscopy to the measurment of hydrogen peroxide in aqueous matrices. The performance of different ATR crystals mounted in flow cells was investigated in the presence of aqueous hydrogen peroxide solutions. Quantitative determination has been achieved by evaluation of specific OH stretching and deformation vibrations with linear correlation between peak areas or peak heights and hydrogen peroxide concentration in the range of 1-10% (weight in water). Important aspects such as chemical stability of the waveguide material and influences of pH and ionic strength on the performance are discussed. Feasibility for the investigation of real world samples is demonstrated by measuring industrial bleaching solutions with known concentrations of hydrogen peroxide fitting well with calibration graphs established with neat hydrogen peroxide solutions. The presented sensor system is capable of determining hydrogen peroxide within complex matrices and clearly corroborates the potential of providing an in situ measurement concept for on-line hydrogen peroxide detection.     

Classification of rheumatoid joint inflammation based on laser imaging

We describe a classification system for a novel imaging method for arthritic finger joints. The basis of this system is a laser imaging technique which is sensitive to the optical characteristics of finger joint tissue. From the laser images acquired at baseline and follow-up, finger joints can automatically be classified according to whether the inflammatory status has improved or worsened. To perform the classification task, various linear and kernel-based systems were implemented and their performances were compared. Based on the results presented in this paper, we conclude that the laser-based imaging permits a reliable classification of pathological finger joints, making it a sensitive method for detecting arthritic changes.