Aggregate and concrete microfracture

Thin sections cut from cast concrete cylinders have been examined in transmitted light to investigate the significance of coarse aggregate type in “primary” microfracturing. Concretes manufactured with crushed-rock aggregates and gravel aggregates were studied and, in every case, the dominant fracture type was a parting of the aggregate-matrix bond. Bond cracking was least severe with the marble aggregate where epitaxial calcite over-growth was indicated. The ability of bond cracks to maintain continuity by bridging surface irregularities, via mortar cracks, reduced the inhibiting influence of rough-surfaced aggregate on bond-crack development.     

Assessment of nitrification in groundwater filters for drinking water production by qPCR and activity measurement

In groundwater treatment for drinking water production, the causes of nitrification problems and the effectiveness of process optimization in rapid sand filters are often not clear. To assess both issues, the performance of a full-scale groundwater filter with nitrification problems and another filter with complete nitrification and pretreatment by subsurface aeration was monitored over nine months. Quantitative real-time polymerase chain reaction (qPCR) targeting the amoA gene of bacteria and archaea and activity measurements of ammonia oxidation were used to regularly evaluate water and filter sand samples. Results demonstrated that subsurface aeration stimulated the growth of ammonia-oxidizing prokaryotes (AOP) in the aquifer. Cell balances, using qPCR counts of AOP for each filter, showed that the inoculated AOP numbers from the aquifer were marginal compared with AOP numbers detected in the filter. Excessive washout of AOP was not observed and did not cause the nitrification problems. Ammonia-oxidizing archaea grew in both filters, but only in low numbers compared to bacteria. The cell-specific nitrification rate in the sand and backwash water samples was high for the subsurface aerated filter, but systematically much lower for the filter with nitrification problems. From this, we conclude that incomplete nitrification was caused by nutrient limitation.     

Toxicity, accumulation and elimination studies of α-hexachlorocyclohexane (α-HCH) with freshwater organisms of different trophic levels

A short- and long-term toxicity study with α-hexachlorocyclohexane (α-HCH) was carried out with freshwater organisms of different trophic levels (algae, crustaceae and fishes). In this study mortality, immobilization, growth, reproduction, histopathologic changes and enzyme activities were chosen as criteria.Furthermore accumulation and elimination processes were investigated in separate organisms as well as the uptake of α-HCH by one organism and through a food-chain.Finally a tentative method for deriving an “ecological limit” for χ-HCH in surface water is described.     

The depositional environment of zinc, lead and cadmium in reservoir sediments

Despite low water retention dams and intervening reservoirs, reservoirs located downstream from a lead-zinc mining and milling area contain relatively higher concentrations of zinc, lead and cadmium than reservoirs in other areas. These metals are also concentrated in reservoir bottom sediments relative to surrounding soils. The zinc and lead content closely correlates to depth of water, organic content and percentage of clay-sized sediments. Zinc is preferentially weathered and transported from its source relative to lead. A model is developed in which the zinc and lead are transported by ionic and/or organo-metallic solution into reservoirs. Because of the relatively long residency time of water in reservoirs, the zinc and lead in the water is removed by clay minerals. Most of the zinc and lead content of the sediments is shown to be associated with sediments of specific gravity between 2·0 and 2·9. The efficiency of these reservoirs as a sink for zinc and lead results in the removal of an average 0·3 ppm zinc and 0·04 ppm lead from waters passing through Fort Gibson Reservoir.     

Oscillations of Foundations Installed on the Ground and Cast-in-Place Piles Subject to Kinematic Effects

Results are presented for experimental investigations on the traffic-induced oscillations of two full-scale foundations of a metallic tunnel, one of which is installed directly on the ground, and the other on cast-in-place piles. The foundations are close to one another with respect to mass and the load applied to them. Differences are revealed between the parameters of the actual oscillations of these foundations and their computed values.     

Coping with COPA II: Actions to Improve Effluent Quality

The paper outlines some of the actions taken by Severn Trent Water to achieve compliance with consent limits since the implementation of the Control of Pollution Act (Part II) in 1985.
Prior to and since 1985, Severn Trent Water has undertaken an extensive programme to analyse the reasons for failure and carry out remedial work. A major feature of this programme, which has been further stimulated by privatization, has been the need to reduce the lead time for carrying out improvements.
The paper discusses the means by which this has been achieved, including the introduction of the 'fast-track'initiative and the 'process matrix'.
Other aspects are outlined including initiatives to develop more robust processes, computerized work scheduling, extensive training programmes and best practice studies.     

Upgrading the Activated-Sludge Process for Total Nitrogen Removal in Hong Kong

In order to protect the sensitive waters in Tolo harbour (Hong Kong), Sha Tin and Tai Po sewage-treatment works were first designed to remove 70% of the nitrogen load from the sewage. Since then, due to continuing serious eutrophication problems in the harbour, both plants have been modified to increase the removal efficiency to 90%.
The modifications were based on the Bardenpho process. However, the designers of the two plants adopted different approaches to process intensity, complexity and control of bacterial foam. At Sha Tin, the average monthly results have shown an increase of total nitrogen removal from 60–70% to about 80% since its completion. The addition of methanol was found to be ineffective on further enhancement of the denitrification rate due to difficulties in the apportioning of the second anoxic zone. The overall monthly results for Tai Po have also shown an increase in the removal rate to about 80%, even though 90% was achieved for a short period of time. The major problem encountered at the latter plant was that the process design did not provide an effective control on bacterial foaming, which had affected the smooth operation of the process.     

The direct measurement of ppm levels of uranium in soils using high-resolution Ge(Li) gamma-ray spectroscopy

The direct determination of ²³⁸U in various soil samples was done by measuring the 63.3-keV transition from the decay of the first daughter ²³⁴Th. Potential errors resulting from the chemical non-equilibrium of ²³⁸U with its daughters are thus avoided. The method sensitivity is 1 ppm compared to the 35 ppm obtainable by employing the 1001-keV gamma ray. A Ge(Li) gamma-ray spectrometer is the only analytical tool required. Examples are offered that demonstrate the usefulness of the technique for routine, inexpensive environmental monitoring of uranium. The technique also has the capability of providing information on the ²³⁸U/²³⁵U isotopic ratio.     

Experience with the preconstruction of thawing of soils in the foundation bed of the main building of the Neryungrinsk state area power plant

Conclusions 1. The scheme that we developed is efficient and ensures thawing over a period of 40–45 days. 2. To accelerate thawing by 8–10 days when using two electric heaters in each hole, it is necessary to raise the heaters by 3–4 m after 25 days and continue thawing. 3. An 8–10-day reduction in the thaw time is also possible by using three 1.25-kW electric heaters in each hole in place of two heaters of the same capacity, installing them at depths of 20, 14, and 8 m from the surface. Taking the results of the experimental work account, the State Institute for Special Design developed a plan for the production preconstruction thawing of soils over a area of 12,380 m². The volume of soil thawed was 324,400 m³. Translated from Osnovaniya, Fundamenty i Mekhanika Gruntov, No. 3, pp. 7–8. May–June, 1982.