光纤光栅感温火灾探测报警系统在原油罐区的应用

通过对现有罐区火灾自动报警技术的认真考察、对比,在石西集中处理站原油罐区安装了光纤光栅感温火灾探测报警系统.该报警系统的传感信号是光的波长变化,传感器及其探测系统是靠光缆连接而进入被测现场,它具有高安全性、高可靠性、高绝缘性、高抗电磁干扰性、防潮耐蚀、寿命长等其他传统火灾探测报警系统无法比拟的优越性能.阐述了其系统构成和运行效果.该系统在石西集中处理站运用效果良好.     

相关条件下基于N-P准则的分布式检测理论研究

本文针对并行网络、二元局部判决的情况,研究了在相关条件下基于N-P准则的分布式检测融合算法,给出了在联合概率密度已知和未知两种情况下的最优融合规则的理论推导及相应的解决方案,并在实验仿真的基础上,得到了部分有益的结论。     

一种的四进制CPM调制器的设计与FPGA实现

设计并实现了一种基于FPGA的四进制连续相位调制器（PCM）。该调制器的基带调制模块通过查表法实现，复杂度较低。仿真结果验证了设计的正确性。     

Pack cementation process for the formation of refractory metal modified aluminide coatings on nickel-base superalloys

The vapour phase compositions of a series of pack powder mixtures containing elemental Al and Hf or W powders as depositing sources and CrCl₃·6H₂O or AlF₃or CrF₃as activators were analysed in an attempt to further develop the pack cementation process to codeposit Al and Hf or W to form diffusion coatings on nickel base superalloys. The results suggested that Al could be codeposited with Hf, but not with W, from the vapour phase. Compared with both AlF₃and CrF₃, CrCl₃·6H₂O has been shown to be a more suitable activator for codepositing Al with Hf. The optimum coating temperature was identified to be in the range of 1050°C to 1150°C. Based on the thermochemical analysis, a series of coating deposition studies were undertaken, which confirmed that codeposition of Al and Hf could be achieved at a deposition temperature of 1100°C in the CrCl₃·6H₂O activated packs containing elemental Al and Hf powders. The coating obtained had a multilayer structure consisting of a Ni₇Hf₆Al₁₆top layer and a NiAl layer underneath, followed by a diffusion zone, which revealed that the coating was formed by the outward Ni diffusion. It is suggested that the compositions suitable for codeposition of Al and Hf could be effectively identified by comparing the vapour pressures of HfCl₄and HfCl₃with that of AlCl in the packs activated by chloride salts. It has also been experimentally demonstrated that, although W could not be deposited from the vapour phase, a high volume of fine W particles can be entrapped into the outer NiAl coating layer formed by the outward Ni diffusion using a modified pack configuration. This leads to the formation of a composite coating layer with W particles evenly distributed in a matrix of NiAl. It is suggested that this modified pack process could be similarly applied to develop nickel aluminide coatings containing other refractory metals that may not be codeposited with Al from the vapour phase.     

Breaking a remote user authentication scheme for multi-server architecture

Lin et al., (2003) proposed a remote user authentication scheme for multi-server architecture. In this paper, we breaks this scheme by giving an attack. Our attack allows an adversary to impersonate any user in the system, as long as a single authentication message of that user is observed.     

TEM Studies of High Temperature Corrosion Behaviour of TiAl Intermetallics with Surface Modifications

The oxidation/sulphidation behaviour of a Ti‐46.7Al‐1.9W‐0.5Si alloy with a TiAl₃ diffusion coating was studied in an environment of H₂/H₂S/H₂O at 850^oC. The kinetic results demonstrate that the TiAl₃ coating significantly increased the high temperature corrosion resistance of Ti‐46.7Al‐1.9W‐0.5Si. The SEM, EDX, XRD and TEM analysis reveals that the formation of an Al₂O₃ scale on the surface of the TiAl₃‐coated sample was responsible for the enhancement of the corroison resistance. The Ti‐46.7Al‐1.9W‐0.5Si alloy was also modified by Nb ion implantation. The Nb ion implanted and as received sampels were subjected to cyclic oxidation in an open air at 800^oC. The Nb ion implantation not only increased the oxidation resistance but also substantially improved the adhesion of scale to the substrate.     

Performance limitation due to statistical Raman crosstalk in a WDM system with multiple-wavelength bidirectionally pumped Raman amplification

A general theoretical model of statistical Raman crosstalk and its impact on system performance in a multiwavelength bidirectionally pumped Raman fiber amplifier (RFA) is developed for the first time, where we have taken modulation statistics, dispersion-induced pulse walk-off and signal-induced pump depletion into account. Two kinds of statistical Raman crosstalk, from signal-induced forward-pump depletion and from signal-signal Raman interaction, are included in one model. Formulas for normalized Raman crosstalk, Raman crosstalk-induced relative intensity noise spectral density, and its variance and system performance impact in terms of Q penalty are presented for both a single-span system and a dispersion-compensated multispan wavelength-division-multiplexed (WDM) link. Based on these formulas, we numerically investigate the impact of Raman crosstalk on system performance in a three-wavelengths bidirectionally pumped 40 /spl times/ 40-Gb/s WDM system for various fiber types. In addition, Raman crosstalk in a four-wavelength bidirectionally pumped RFA was experimentally measured. The results agree well with our theory.     

求解二维结构-声耦合问题的一种直接方法

本文基于传递矩阵法(TMM)和虚拟边界元法(VBEM)，提出了一种求解在谐激励作用下二维结构-声耦合问题的直接法。文中对任意形状的二维弹性环建立了一阶非齐次运动微分方程组，便于用齐次扩容精细积分法求解，对于含有任意形状孔穴的无穷域流体介质的Helmholtz外问题，采用复数形式的Burton-Miller型组合层势法建立了虚拟边界元方程，保证了声压在全波数域内存在唯一解。根据叠加原理并结合最小二乘法，提出了一种耦合方程的直接解法，由于该方法不存在迭代过程，因而具有较高的计算精度和效率。文中给出了二个典型弹性环在集中谐激励力作用下声辐射算例，计算结果表明本文方法较通常采用的混合FE／BE法更为有效。     

井下套管阀研究及室内试验

随着欠平衡钻井技术的深入研究和推广应用,全过程欠平衡钻井技术已成为研究热点。除了常规的欠平衡装备外,全过程欠平衡钻井还需配备井下套管阀,为此,研制了一种双液控井下套管阀。为检验该阀的使用可靠性,进行了全面的室内试验和测试,试验内容包括压力密封能力,高压、有流动情况下阀板关闭的动作准确性,模拟现场阀板下憋压时打开阀板的作业程序,检测在各种密封压力时阀的微泄漏量。试验结果表明,该阀达到设计要求,能够满足全过程欠平衡作业的工艺要求。     

A call admission and rate control scheme for multimedia support over IEEE 802.11 wireless LANs

Quality of service (QoS) support for multimedia services in the IEEE 802.11 wireless LAN is an important issue for such WLANs to become a viable wireless access to the Internet. In this paper, we endeavor to propose a practical scheme to achieve this goal without changing the channel access mechanism. To this end, a novel call admission and rate control (CARC) scheme is proposed. The key idea of this scheme is to regulate the arriving traffic of the WLAN such that the network can work at an optimal point. We first show that the channel busyness ratio is a good indicator of the network status in the sense that it is easy to obtain and can accurately and timely represent channel utilization. Then we propose two algorithms based on the channel busyness ratio. The call admission control algorithm is used to regulate the admission of real-time or streaming traffic and the rate control algorithm to control the transmission rate of best effort traffic. As a result, the real-time or streaming traffic is supported with statistical QoS guarantees and the best effort traffic can fully utilize the residual channel capacity left by the real-time and streaming traffic. In addition, the rate control algorithm itself provides a solution that could be used above the media access mechanism to approach the maximal theoretical channel utilization. A comprehensive simulation study in ns-2 has verified the performance of our proposed CARC scheme, showing that the original 802.11 DCF protocol can statically support strict QoS requirements, such as those required by voice over IP or streaming video, and at the same time, achieve a high channel utilization. Hongqiang Zhai received the B.E. and M.E. degrees in electrical engineering from Tsinghua University, Beijing, China, in July 1999 and January 2002 respectively. He worked as a research intern in Bell Labs Research China from June 2001 to December 2001, and in Microsoft Research Asia from January 2002 to July 2002. Currently he is pursuing the PhD degree in the Department of Electrical and Computer Engineering, University of Florida. He is a student member of IEEE. Xiang Chen received the B.E. and M.E. degrees in electrical engineering from Shanghai Jiao Tong University, Shanghai, China, in 1997 and 2000, respectively, and the Ph.D. degree in electrical and computer engineering from the University of Florida, Gainesville, in 2005. He is currently a Senior Research Engineer at Motorola Labs, Arlington Heights, IL. His research interests include resource management, medium access control, and quality of service (QoS) in wireless networks. He is a Member of Tau Beta Pi and a student member of IEEE. Yuguang Fang received a Ph.D degree in Systems and Control Engineering from Case Western Reserve University in January 1994, and a Ph.D degree in Electrical Engineering from Boston University in May 1997. From June 1997 to July 1998, he was a Visiting Assistant Professor in Department of Electrical Engineering at the University of Texas at Dallas. From July 1998 to May 2000, he was an Assistant Professor in the Department of Electrical and Computer Engineering at New Jersey Institute of Technology. In May 2000, he joined the Department of Electrical and Computer Engineering at University of Florida where he got the early promotion with tenure in August 2003 and has been an Associate Professor since then. He has published over one hundred (100) papers in refereed professional journals and conferences. He received the National Science Foundation Faculty Early Career Award in 2001 and the Office of Naval Research Young Investigator Award in 2002. He is currently serving as an Editor for many journals including IEEE Transactions on Communications, IEEE Transactions on Wireless Communications, IEEE Transactions on Mobile Computing, and ACM Wireless Networks. He is also actively participating in conference organization such as the Program Vice-Chair for IEEE INFOCOM’2005, Program Co-Chair for the Global Internet and Next Generation Networks Symposium in IEEE Globecom’2004 and the Program Vice Chair for 2000 IEEE Wireless Communications and Networking Conference (WCNC’2000).