新型超润湿性自吸聚合物在压裂液体系中的应用

研制了一种具有润湿性的新型压裂液体系,并对聚合物进行XRD和TGA分析.流变学和扫描电镜实验表明,压裂液具有致密的网状结构.通过SEM测试得到破胶液的微观结构,表明交联作用更加明显.NFW压裂液在90℃时具有良好的流变性能,破胶液的表面张力较低,为20 mN·m-1.因此,这种具有润湿性的压裂液可作为致密油气藏开发的替代品.     

Effects of structural parameters on water film properties of transpiring wall reactor

Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.     

紫色马铃薯酒发酵工艺优化及主发酵期花青素与色泽的动态变化

以紫色马铃薯为原料，在单因素的基础上，通过响应面法对紫色马铃薯酒的发酵工艺参数进行优化。最佳发酵工艺参数为:马铃薯与面粉比1:0.6、料水比1:1 (g/mL)、α-淀粉酶添加量8.5 U/g、酒曲添加量0.45%。此工艺在28 ℃下发酵14 d，得到的紫色马铃薯酒酒精度13.5%vol，花青素含量166.34 mg/mL，酒体澄清透明呈紫红色，酸甜适中，有独特酒香，综合感官评定得分90分。测定主发酵期花青素和色泽的动态变化，分析表明，紫色马铃薯酒在发酵过程中花青素呈现先上升后下降的趋势，色度呈现先下降后趋于平缓的趋势，色调则与之相反。聚合色度和褐变指数总体均呈现逐渐上升的趋势。试验结果为工业化生产紫色马铃薯酒提供理论依据。     

Numerical Investigation of the Capture of Polydisperse Particles by Charged Droplets

The capture of particles by charged droplets was simulated by considering the electrostatic interactions of droplet-droplet and droplet-particle. The results indicate that the electrostatic repulsion between droplets leads to a dynamic accumulation mode of particles. However, the droplet spacing has an insignificant effect on the capture efficiency when the electrostatic deposition predominates. The increase of droplet charge remarkably improves the capture efficiency, in which the capture of fine particles accounts for the largest proportion. Compared to the droplet charge, the droplet size shows a limited improvement in the capture efficiency. Reducing the droplet velocity prolongs the capture time instead of enhancing the capture capacity per unit time, thereby improving capture efficiency.     

基于小波变换的分数阶微分算法在肝脏肿瘤CT图像纹理增强中的应用

图像纹理增强过程中容易丢失平滑区域纹理细节，而分数阶微分增强虽然能够非线性保留平滑区域纹理细节，但对频率分辨率敏感。针对这个问题，提出一种基于小波变换的分数阶微分纹理增强算法，应用于平扫计算机断层扫描（CT）图像的肝脏肿瘤区域的纹理增强。首先，通过小波变换将图像感兴趣区分解成多个子带分量；其次，基于分数阶微分定义构造一个带补偿参数的分数阶微分掩膜；最后，使用该掩膜与每个高频子带分量进行卷积并利用小波逆变换重组图像感兴趣区。实验结果表明，该方法在使用较大分数阶次显著增强肿瘤区域的高频轮廓信息的同时，有效地保留了低频平滑的纹理细节：增强后的肝细胞癌区域与原区域相比，信息熵平均增加36.56%，平均梯度平均增加321.56%，平均绝对差值平均为9.287；增强后的肝血管瘤区域与原区域相比，信息熵平均增加48.77%，平均梯度平均增加511.26%，平均绝对差值平均为14.097。     

冷链条件下气调包装酱卤鸭肉制品货架期预测模型的建立

目的 以气调包装酱卤鸭肉制品为研究对象,在冷链温度范围内建立一套准确、高效的货架期预测模型。方法 利用选择性培养基测定不同温度下产品各微生物数量,确定4~25℃条件下产品优势腐败菌。对乳酸菌数量与感官评定值进行了回归分析确定最小腐败量Ns。分别采用修正的Gompertz方程和平方根方程建立一、二级模型,并通过预测值与实测值对比验证模型的可靠性。结果 确定了4~25℃条件下产品优势腐败菌为乳酸菌,最小腐败量Ns=6.14(lg(cfu /g))。一、二级模型拟合度均良好,三种温度下模型预测值与实际值间的差异均在30％左右,波动幅度在10%以内。结论 实现了对4~25℃内任何时间点产品剩余货架期的预测,为冷链条件下气调包装酱卤鸭肉制品品质的变化提供了理论指导。     

赤红球菌组氨酸激酶的融合表达和功能分析

对赤红球菌的组氨酸激酶基因进行密码子优化，将优化后的组氨酸激酶基因（rhks）构建重组表达质粒pGEX-4T-2-rhks。将此质粒导入到大肠杆菌BL21（DE3）中进行异源表达。在25 ℃和1 mmol/L异丙基-β-D-硫代吡喃半乳糖苷诱导条件下，组氨酸激酶融合蛋白（GST-RHK）获得成功表达，并具有催化活性。经谷胱甘肽琼脂糖亲和层析纯化，获得电泳纯的GST-RHK，其中纯化倍数为3.1，得率为19.5%。该蛋白大小约为72.75 kDa，Km、Vmax和Kcat值分别为20.92 μmol/L、0.17 μmol/（L·min）和1.4 min－1。野生型赤红球菌、组氨酸激酶基因增强株sdrhkE和组氨酸激酶基因敲减株sdrhkD在分别含有苯酚、甲苯、氯苯、异辛烷4 种有机溶剂的培养基中培养，菌株sdrhkD的生长情况都优于野生型赤红球菌，菌株sdrhkE的生长情况都低于野生型赤红球菌。本研究为进一步揭示赤红球菌SD3中组氨酸激酶涉及的信号转导途径与赤红球菌有机溶剂耐受性的关联机制提供一定参考依据。     

Crystallographic characteristics and microwave dielectric properties of Ni-modified MgTa2O6 ceramics

Ni²⁺ modified MgTa₂O₆ ceramics with a trirutile phase and space group P4₂/mnm were obtained. The correlations between crystallographic characteristics and microwave dielectric performance of MgTa₂O₆ ceramics were systematically studied based on the chemistry bond theory (PVL theory) for the first time. The results indicate that the introduction of Ni²⁺ causes a change in polarizability and the Mg–O bond ionicity, which contributes to the variation of dielectric constant. Moreover, the lattice energy, and packing fraction, full width at half maximum of the Raman peak of Ta–O bond, as the quantitative characterization of crystallographic parameters, regulate the dielectric loss of MgTa₂O₆ ceramics in GHz frequency band. In addition, the study of sintering behavior shows that the densification and micromorphology are the crucial factors affecting the microwave dielectric performance. Typically, Ni²⁺ doping on the A-site of MgTa₂O₆ can effectively promote the Q × f values to 173,000 GHz (at 7.43 GHz), which ensures its applicability in 5G communication technology.     

Investigation of crystal characteristics,Raman spectra,and microwave dielectric properties of Mg1-xZnxTa2O6 ceramics

Mg_(1-x)Zn_xTa₂O₆ (x = 0.00?0.08) dielectric ceramics were synthesized via the traditional solid-state reaction method. We used XRD and Rietveld refinement to demonstrate that a pure Mg_(1-x)Zn_xTa₂O₆ phase with trirutile structure was formed. Zn²⁺ substitution helped to decrease the Raman full width at half width of the A_1g mode at 703 cm^?1, which resulted in an increase in the order and rigidity of the TaO₆ octahedron, this in turn contributed to improving the Q×f values. Additionally, the introduction of Zn²⁺ significantly promoted grain growth and increased the dense, and the molecular polarizability, these factors lead to a higher permittivity. Moreover, enhanced Ta-O bond energy resulted in a more stable TaO₆ octahedron in the Mg_(1?x)Zn_xTa₂O₆ system, which contributed to enhanced τ_f values via substitution of Zn²⁺ doped on the A-site. Correspondingly, the microwave dielectric properties were significantly improved for 0.04-doped samples, obtaining: ε_r = 27, Q × f = 185,000 GHz (at 7.47 GHz), τ_f =32 ppm/°C.