Radiation effects in a model ceramic for nuclear waste disposal

The safe immobilization of nuclear waste in geological repositories is one of the major scientific challenges facing humanity today. Crystalline ceramics hold the promise of locking up actinides from nuclear fuel and excess weapons plutonium in their structure thereby isolating them from the environment. This paper presents the atomistic details of radiation damage in a model ceramic, zircon.     

大角度倾转法在碳化物研究中的应用

蠕变过程中碳化物形貌，类型，数量和分布状态的变化直接影响着材料的高温性能，因而在材料的蠕变得到了广泛的重视，介绍了一种在碳膜萃取复型样品上利用Ｈ－８００透射电子显微镜的双倾样品台进行了大角度倾转，来观察碳化物形貌并鉴定其类型的试验方法。     

双曝光全息干涉测量

本文论述了双曝光全息干涉测量技术的基本理论和实际应用方法。并进而推论了条纹形状和物体微小位移之间的定量关系。最后给出了实验装置和实验结果。     

微光机电系统的微绞链研制

本文讨论了非硅微机械工艺和微绞链的研制工艺。我们研制的非硅表面微机械工艺采用两次或三次掩模电镀层，聚酰亚胺和光刻胶分别作为底层和第二、第三层的牺牲层。用这套工艺，研制成功了三种不同种类的微绞链。微绞链能在基片表面作０—１８０度自由转动。     

贝氏体钢内水冷穿孔顶头的粘钢及防止措施

从顶头生产工艺控制的角度,分析了贝氏体钢内水冷穿孔顶头产生粘钢的原因、特点和机制,指出掉鼻、缺肉是顶头粘钢的另一种更为严重的失效形式,强化熔炼工艺控制和保证夹杂物总量在A0.5B1C0.5D1级水平,粘钢问题可以得到有效控制。     

Sliding wear behavior of salt bath nitrocarburized medium carbon steel

Salt bath nitrocarburizing is a well-known thermochemical diffusion process for enhancing the tribological and corrosion properties of ferrous components. The current work describes the role of a compound layer developed during nitrocarburizing, both in the ferritic and austenitic regimes of Fe-N-C system, on the sliding wear behavior of a medium carbon steel. The wear behavior of the nitrocarburized steel discs was assessed by the pin-on-disc tests (ASTM G 99-99) under different normal loads running against a hardened SAE52100 pin. It was observed that the compound layer on the surface not only controlled the wear rate but also resisted the adhesive wear/transfer of material from pin to disc, aside from providing low-friction coefficients.     

应用ATV71变频器有效解决给粉机变频器低电压跳闸问题

本文分析了给粉机变频器低电压跳闸的原因和解决办法，为解决给粉机变频器低电压跳闸，消除设备隐患提供了经验。     

高能超声处理Al-1Si合金凝固组织分析

采用高能超声处理Al-1Si合金熔体,借助金相显微镜和电子探针进行组织分析,并测定合金的熔化潜热,分析了熔体中超声空化效应和声流效应影响凝固过程的机理。结果表明,试样晶粒平均尺寸由超声处理前的94μm减小到超声处理后的34μm;合金试样的熔化吸热量由263.90J/g降低为159.81J/g,在熔体中施加高能超声显著改善了合金成分的均匀性并细化了晶粒。     

Variable-gain up-converter with current reuse for 5-GHz WLAN applications

A variable-gain up-conversion mixer for 5-GHz WLAN applications is presented, whose input stage is based on a novel variable gain transconductor. The proposed topology features reduced power consumption by exploiting dc current reuse for mixer biasing. Moreover, a new low-consumption control circuit is introduced, which achieves a temperature-stable and linear-in-dB characteristic, providing a 40-dB dynamic range within ±1 dB gain error.