PGNAA技术对铜精矿元素及水分进行在线检测的应用研究

目前对铜精矿元素含量及水分的检测大多基于试验室取样分析，存在取样代表性差，分析时间长等问题。针对上述问题，采用基于瞬发γ中子活化分析（PGNAA）技术设计的在线分析仪对国内某铜精矿样品进行主要元素含量及水分在线检测研究。结果表明：铜精矿中各主要元素含量及水分检测量线性相关性良好，满足指导铜精矿生产的要求。     

Disappearance and recovery of colossal permittivity in (Nb+Mn) co-doped TiO2

We investigate the effects of doping and annealing on the dielectric properties of metal ions doped TiO₂ ceramics. Colossal permittivity (CP) above 10⁴ was observed in single Nb ion doped TiO₂, which was dominated by electron transport related interfacial polarization. Moreover, the CP can be dropped to 120 when simultaneously introducing Mn ion into the sample. The disappearance of CP behaviors maybe due to the multivalence of Mn which would inhibit the reduction of Ti⁴⁺ to Ti³⁺, and thus reduce delocalized electrons. Interestingly, the CP was recovered for the (Nb+Mn) co-doped TiO₂ after post-sintering heat treatment in N₂ atmosphere. The recovery of CP in the sample after annealing can be ascribed to the semiconducting grain and the insulating grain boundary, according to impedance spectroscopy. We therefore believe that this work can help us understand the mechanism of CP from a new perspective.     

Efficient PL Emission from p-type Porous Silicon: A Comparative Study for Selection of Effective Anodization Parameters

The physical mechanism of highly efficient photoluminescence (PL) emission from p-type silicon is described by a comparative study of the effectiveness of the etching parameters in an electrochemical anodization technique. Two series of porous silicon samples were prepared in a combination of anodization current and time, to maintain the total amount of anodic charge transfer constant. Photoluminescence studies show that irrespective of the amount of charge transfer, the samples prepared with comparatively higher current density show an efficient PL as well as stronger blueshift in the emission energy vis-à-vis the samples prepared for longer durations. An overall decrease in crystallite size, as estimated by Raman spectral analysis, was observed for both series of samples with the progress of charge transfer. Comparative analysis shows a marginal difference in crystallite size for both series of samples in the initial state of charge transfer, whereas major differences arise at higher values. This is explained with the formation of silicon suboxide on the porous surface at higher current density, leading to initiation of side wall reaction, and higher reduction rate in crystallite size as well as strong luminescence due to the carrier quantum confinement effect.     

酸性服役管线管BNS力学及耐腐蚀性能研究

文章介绍了包钢钢管公司酸性服役管线管BNS成分设计要求,对材料的拉伸性能、冲击性能、组织以及耐腐蚀性能进行了检测和分析,正火处理后,材料具有良好的力学性能和抗腐蚀性能.试验结果表明,设计的BNS完全能满足酸性服役条件下管线管性能要求.     

A facile method for preparation of PGS@ZB‐N and gas‐sol alternating synergistic effect for fire resistance of EVA

Through the simple precipitation of palygorskite (PGS) by zinc borate (ZB) (to make PGS@ZB) and the decoration of PGS@ZB by dodecylamine (N), a novel organic‐inorganic@inorganic hybrid flame retardant of PGS@ZB‐N was prepared and was incorporated with ethylene vinyl acetate copolymer (EVA) to improve its flame retardance. The structure and morphology of PGS@ZB‐N were characterized by Fourier transform infrared (FTIR) spectroscopy, X‐ray diffraction (XRD), and scanning electron microscopy (SEM), and it was confirmed that the PGS@ZB‐N hybrid had been successfully prepared. The flame retardancy and burning behavior of EVA/PGS@ZB‐N/EG (EG = expandable graphite) composite were studied through thermogravimetric analysis (TGA), limiting oxygen index (LOI), UL‐94 (by the vertical burning test), and cone calorimeter test (CCT) characterizations. The prepared EVA/PGS@ZB‐N/EG composite obtained an LOI value of 41.2% with the addition of 30 wt% PGS@ZB‐N/EG. It was found that EVA/PGS@ZB‐N/EG was protected through a gas phase and condensed phase alternating synergistic effect mechanism.     

国家科技部“十三五”重点研发计划地热专项全部完成立项

根据科技部“十三五”科技战略部署,于2018、2019两年时间顺利完成“干热岩能量获取及利用关键科学问题研究”、“深部碳酸盐岩热储层强化增产与利用综合评价技术”及“砂岩热储采灌增效技术与装备”三项重点研发计划项目从申报、函审、视频答辩到立项的工作。     

Matrix Transformation in Boron Containing High-Temperature Co–Re–Cr Alloys

An addition of boron largely increases the ductility in polycrystalline high-temperature Co–Re alloys. Therefore, the effect of boron on the alloy structural characteristics is of high importance for the stability of the matrix at operational temperatures. Volume fractions of ε (hexagonal close-packed—hcp), γ (face-centered cubic—fcc) and σ (Cr₂Re₃ type) phases were measured at ambient and high temperatures (up to 1500 °C) for a boron-containing Co–17Re–23Cr alloy using neutron diffraction. The matrix phase undergoes an allotropic transformation from ε to γ structure at high temperatures, similar to pure cobalt and to the previously investigated, more complex Co–17Re–23Cr–1.2Ta–2.6C alloy. It was determined in this study that the transformation temperature depends on the boron content (0–1000 wt. ppm). Nevertheless, the transformation temperature did not change monotonically with the increase in the boron content but reached a minimum at approximately 200 ppm of boron. A probable reason is the interplay between the amount of boron in the matrix and the amount of σ phase, which binds hcp-stabilizing elements (Cr and Re). Moreover, borides were identified in alloys with high boron content.