On the behavior of microstructures with multiple length scales

The current study aims to provide fundamental insight into the behavior of microstructures containing grain sizes that span multiple length scales. A commercial 5083 Al alloy was selected as the material of interest to facilitate comparison with recently published data. The materials studied here were prepared via the thermal consolidation of powders that were cryomilled for different times (i.e., 0, 2, 4, and 8 hours). Following consolidation, the resultant microstructure was characterized by an equiaxed grain morphology with a size distribution centered around 200∼300 nm. Dispersed among the 200- to 300-nm grains were coarse-grained regions or ligaments with a grain size ranging from 600 nm to 2 μm. The occurrence of coarse-grained regions is rationalized on the basis of recrystallization or subgrain coarsening, whereas the occurrence of equiaxed fine regions is proposed to be a result of continuous grain growth. Two types of microstructures were selected for study, containing coarse-grained volumes of approximately 28 pct and 43 pct that corresponded to an ultimate tensile strength (UTS) of 566 MPa and 535 MPa, and a fracture strain of 3.2 pct and 3.5 pct, respectively. The observed ductility and the relevant toughening mechanisms were discussed in light of the presence of multiple length scales.     

Model concrete beam-column joints subjected to cyclic loading at two rates

Small-scale models of reinforced concrete beam-column joint were subjected to large cyclic displacements at two rates: 2.5×10⁻³ and 1.0 Hz. To assess damage, free-vibration tests were conducted. The reliability of the modelling techniques was established by comparison of the results for the slower rate with those obtained from the full-scale tests on prototype. The higher rate of loading caused a greater damage than that at the lower rate. This was evidenced by the measurements of the energy absorbed in the hysteresis loops, equivalent damping, and the stiffness and damping obtained from the free-vibration test. The relatively greater extent of damage appears to result from the different bond behaviour at different rates of loading.     

A reliability model for a k-out-of-N:G redundant system with multiple failure modes and common cause failures

The paper presents a reliability model of a k-out-of-N:G redundant system with M mutually exclusive failure modes and common cause failures. Failed system repair times are arbitrarily distributed. The system is in a failed state when (N−k+1) units failed or a common cause failure occurred. Laplace transforms of the state probabilities and the availability of the system are derived. Finally, the system steady-state availability is also reported.     

Factor structure of the SOCRATES in a clinical sample of adolescents.

This study investigated the Stages of Change Readiness and Treatment Eagerness Scale (SOCRATES: W. R. Miller & J. S. Tonigan, 1996) in adolescents presenting for treatment of alcohol use disorder (AUD). The participants were 80 males and 43 females (mean age=16.8 years) who presented for AUD treatment (95.1% outpatient, 4.9% inpatient). Participants completed assessments at baseline and 1 year and provided information on alcohol use and related variables monthly between these 2 assessments. Principal-components and confirmatory factor analyses of the baseline SOCRATES identified 2 factors, Taking Steps and Recognition, which showed good internal consistency and concurrent and predictive evidence of validity. The results were interpreted as supporting the use of the SOCRATES with clinical samples of adolescents. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

A systematic design method to obtain broadband characteristics for singly-fed electromagnetically coupled patch antennas for circular polarization

We present a systematic, empirical design technique to obtain optimum broadband impedance, axial-ratio (AR) and gain bandwidths for a singly-fed electromagnetically coupled patch antenna for circular polarization. Our investigation has also revealed tradeoffs amongst obtainable AR, impedance bandwidth and AR bandwidth. Using two design examples at different frequency bands and for different senses of circular polarization, we have demonstrated the effectiveness of the proposed knowledge-based tuning method. We have obtained at C-band measured values of impedance bandwidth (VSWR/spl les/2) equal to 43%, 3-dB AR bandwidth of 8%, AR of less than 0.3 dB and a mean gain level of 7 dB. For the Ku-band element, a 40% impedance bandwidth and a 17.3% of 3-dB AR bandwidth have been obtained with a peak gain of 7.2 dBic.     

Proton-exchanged LiNbO/sub 3/ optical waveguides using stearic acid

Proton-exchanged optical waveguides have been fabricated in z-cut LiNbO/sub 3/ using a new proton source: stearic acid. These waveguides were characterized optically and were found to exhibit a step index profile with Delta n=0.118 measured at 0.633 mu m. The propagation losses were typically around 1.5 dB/cm, and the diffusion constant and the activation energy for the proton-exchange process were measured to be 5*10/sup 6/ mu m/sup 2//h and 69 kJ/mol, respectively.<>     

Spectral characteristics of vertical-cavity surface-emitting lasers with external optical feedback

The measurement of the effects of external optical feedback on the spectra of VCSELs (vertical-cavity surface-emitting lasers) is reported. It is surprising that VCSELs have a sensitivity to optical feedback comparable to that of conventional edge-emitting lasers such as DFBs despite their significantly different structures. This is because the extremely short cavity length of VCSELs negates the effects of their highly reflective output mirrors. As in edge-emitting lasers, VCSELs exhibit well-defined regimes of feedback effects in their spectra. Since optical isolators cannot be easily applied to VCSELs due to their array structure, these lasers may be most useful in applications which are not sensitive to the spectral qualities of the light source.<>     

p53 protein expression in extrahepatic bile duct cancer

p53 mutations, a tumor suppressor gene located on chromosome 17p, are the most common genetic alterations found in human cancers. Although the p53 expression or mutation has been investigated in a variety of cancers there have been very few studies in extrahepatic bile duct cancers. In this study, we investigated the immunohistochemical expression of p53 in formalin fixed paraffin embedded archival specimens of 36 extrahepatic bile duct cancers in which p53 expression was found in eighteen (50%) cases. There was no significant difference in age, gender, size of tumor, histologic grade, extent of tumor involvement, lymph node metastasis and tumor resectability according to p53 immunoreactivity. Comparison of survival duration according to p53 expression showed no significant difference. In conclusion, we reported 50 percent of p53 expression in extrahepatic bile duct cancers by immunohistochemical staining and we found no prognostic significance of p53 expression in dinicopathologic parameters.     

A novel technique for profiling the lateral n- dopingconcentrations of submicron LDD MOS devices

This paper reports a simple I-V method for the first time to determine the lateral lightly-doped source/drain (S/D) profiles (n^- region) of LDD n-MOSFETs. One interesting result is the direct observation of the reverse-short-channel effect (RSCE). It is observed that S/D n^- doping profile is channel length dependent if reverse short-channel effect exists as a result of the interstitial imperfections caused by Oxide Enhanced Diffusion (OED) or S/D implant. Not only the lateral profiles for long-channel devices but also for short-channel devices can be determined. One other practical application of the present method for device drain engineering has been demonstrated with a LATID MOS device drain engineering work. It is convincible that the proposed method is well suited for the characterization and optimization of submicron and deep-submicron MOSFETs in the current ULSI technology