热作模具钢表面激光堆焊耐磨合金层的研究

本文主要通过在H13钢上用大功率CO_2激光束进行堆焊,阐述了激光堆焊工艺变化对堆焊组织和性能的影响,在本试验条件下,得到了高密度弥散金属化合物组织的激光堆焊层,平均硬度为HV800,与基体呈冶金结合,耐磨性比H13模具钢提高149%。     

A Neural Network Approach for Signal Detection in Digital Communications

In this paper, we propose a new approach for signal detection in wireless digital communications based on the neural network with transient chaos and time-varying gain (NNTCTG), and give a concrete model of the signal detector after appropriate transformations and mappings. It is well known that the problem of the maximum likelihood signal detection can be described as a complex optimization problem that has so many local optima that conventional Hopfield-type neural networks fail to solve. By refraining from the serious local optima problem of Hopfield-type neural networks, the NNTCTG makes use of the time-varying parameters of the recurrent neural network to control the evolving behavior of the network so that the network undergoes the transition from chaotic behavior to gradient convergence. It has richer and more flexible dynamics rather than conventional neural networks only with point attractors, so that it can be expected to have much ability to search for globally optimal or near-optimal solutions. After going through a transiently inverse-bifurcation process, the NNTCTG can approach the global optimum or the neighborhood of global optimum of our problem. Simulation experiments have been performed to show the effectiveness and validation of the proposed neural network based method for the signal detection in digital communications.     

LDD方法在提高电路工作电压中的应用研究

研究了利用轻掺杂漏结构来制作高电源电压器件的工艺方法。分析了ＬＤＤ结构参数对器件击穿特性的影响，并结合实验结果对Ｎ＾－区的注入剂量，长度及引入的串联电阻进行了优化设计。     

Reduction of sodium-accelerated oxidation of silicon nitride ceramics by aluminium implantation

Norton NBD 200 silicon nitride ceramics were implanted with sodium to a dose of 7.0×10¹⁵cm^-2 at 72 keV (1 at% peak sodium content at 100 nm). The sodium-implanted samples were further implanted with aluminium to 7.3×10¹⁵cm^-2 at 87 keV (1 at% peak aluminium content at 100 nm). The implanted and unimplanted samples were oxidized in 1 atm dry oxygen at 1100 and 1300°C for 2–6 h. Profilometry and scanning electron microscopy measurements indicated that sodium implantation led to up to a two-fold increase in the oxidation rate of silicon nitride. The sodium effect was effectively neutralized when aluminium was co-implanted. The opposite effects of sodium and aluminium on the oxidation resistance of silicon nitride can be attributed to their different roles in modifying the structure and properties of the oxide formed. This revised version was published online in November 2006 with corrections to the Cover Date.     

存在噪声和未建模动态系统传递函数的渐近无偏估计

存在未建模动态时，如何去除系统传递函数估计中噪声引起的偏差是系统辨识关心的重要问题。本文将我们已提出的ＢＥＬＳ方法进行推广得出：当系统未建模动态可用－ＦＩＲ模型描述时，应用本文的方法可得到系统传递函数的无偏辨识，而不需知道有关噪声和未建模动态概率分布函数的先验知识。     

二过碘酸合银（Ⅲ）钾引发丙类酸甲酯在淀粉上接枝共聚合反应的研究

研究了由二过碘酸合银（Ⅲ）钾（简称Ag(Ⅲ））与可溶性淀粉组成的氧化还原体系，于碱性介质中引发淀粉的接枝共聚合反应，得到高接枝效率的接枝共聚物，测定了引发剂浓度、单体浓度、pH值和反应温度对接枝参数的影响，并探讨了引发机理。     

现场总线技术在城市污水处理与气象中的应用

文章主要讨论了LonWorks现场总线技术在城市污水处理厂和气象指数预报中的应用。采用IPC和PLC控制结构对现场的各种设备实现控制和数据的采集，通过现场总线网络传输数据到中心控制室或远程终端，实现污水处理的自动控制和气象信息的实时采集和处理。     

软X射线对血液有形成分表面电荷的影响——2、淋巴细胞和血小板膜电荷的变化

软X射线不仅能引起红细胞表面电荷的变化,同时也能导致淋巴细胞和血小板表面电荷下降,表现为照射后它们的电泳率下降。低剂量范围内,这种电荷的变化是暂时性的,照后4小时降到最低点,24小时后恢复到对照的水平。细胞电泳率的下降与辐射剂量相关。淋巴细胞是一个复杂的细胞群,正常状态下,按细胞在电场中泳动速度的快慢,可分为两个组分:快峰为T细胞,慢峰为B细胞。软X射线照射以后,T和B细胞的电泳率皆减慢,频数分布峰值下降,离散度加大。血小板成分单一,电泳率较一致。 从照射浓集的血小板再加回自身血浆中电泳率的下降较照射血浆再加到血小板中的电泳率下降大得多;受照射的血小板在磷酸缓冲液中电泳率下降较在血浆悬液中严重得多;2000 rad照后,悬浮于血浆中的血小板电泳率能恢复,而悬浮于磷酸缓冲液中则不能恢复,三个方面来看,血浆中可能存在抗辐射因子。超氧化物岐化酶能有效地预防血小板电泳率的下降,从而可阻止血小板的凝聚。     

编码解码芯片HD3-6408-9及其应用

编码解码芯片HD3 64 0 8 9是一种高性能的CMOS器件。这种大规模芯片主要由编码器和解码器两部分组成。在数据传输应用中 ,采用两个独立的单片机系统 ,利用编码解码芯片 (HD3 64 0 8 9)组成数字信号的接收、发送及显示部分来完成数据传输功能