浅埋地下建筑风冷热泵空调系统传热模型与试验研究

本文在浅埋地下建筑风冷热泵空调系统围护结构传热动态模拟的基础上，通过对南京市太园地下旅社围护结构传热的实时测试，验证动态传热模型及计算机模拟方法的可行性和正确性，为浅埋地下建筑风冷热泵空调系统的装机容量、节能指标和设计计算提供一定的理论依据。     

A compact LTCC branch-line coupler UsingModified-T equivalent-circuit modelfor transmission line

In this letter, a compact branch-line coupler is proposed by making good use of the three-dimensional layout capability of the low-temperature co-fired ceramic (LTCC) substrate. This branch-line coupler is accomplished by using lumped-inductors and lumped-capacitors to realize the modified-T equivalent-circuit model for the transmission line so that the circuit size may drastically be reduced. Specifically, a very compact LTCC branch-line coupler with a size of 0.079/spl lambda//spl times/0.0717/spl lambda/ is implemented and carefully examined, where /spl lambda/ is the wavelength of the multilayer structure at the operating frequency f/sub 0/.     

Dynamic RSVP protocol

RSVP is a resource reservation setup protocol that can be used by a host to request specific QoS for multicast multimedia flows on the Internet. Multiprotocol label switching (MPLS) architecture also needs RSVP. The fact that the resolutions of the display system used in different receiver nodes might have different, multi-resolution characteristics is supported in the MPEG-4 standard, and the EZW compression algorithm can cease decoding at any point in the bitstream. However, RSVP does not provide a more flexible mechanism. In this article we propose an extension of RSVP to provide the needed mechanism, coined dynamic RSVP (DRSVP), to dynamically adjust reserved resources on nodes without much effort. It provides different video resolutions to different receiver nodes with different needed reserved resources. Therefore, it does not waste precious Internet resources to transmit unnecessary multimedia packets.     

A novel technique for profiling the lateral n- dopingconcentrations of submicron LDD MOS devices

This paper reports a simple I-V method for the first time to determine the lateral lightly-doped source/drain (S/D) profiles (n^- region) of LDD n-MOSFETs. One interesting result is the direct observation of the reverse-short-channel effect (RSCE). It is observed that S/D n^- doping profile is channel length dependent if reverse short-channel effect exists as a result of the interstitial imperfections caused by Oxide Enhanced Diffusion (OED) or S/D implant. Not only the lateral profiles for long-channel devices but also for short-channel devices can be determined. One other practical application of the present method for device drain engineering has been demonstrated with a LATID MOS device drain engineering work. It is convincible that the proposed method is well suited for the characterization and optimization of submicron and deep-submicron MOSFETs in the current ULSI technology     

Accurate quasi-TEM spectral domain analysis of single and multiplecoupled microstrip lines of arbitrary metallization thickness

The quasi-TEM spectral domain approach (SDA) is extended to rigorously and efficiently analyze single and multiple coupled microstrip lines of arbitrary metallization thickness. The charge distributions on both the horizontal and vertical conductor surfaces are modeled by global basis functions. This results in a relatively small matrix for accurate determination of the line parameters of coupled thick microstrips. A convergence study is performed for the results of a pair of coupled lines with crucial structural parameters to explore the conditions for obtaining reliable solutions using the technique. Results for thick microstrips are validated through comparison with those from available measurements and another theoretical technique. The soundness of the technique is further demonstrated by looking into the trend of the results obtained by a simplified model in which the structural parameters are pushed, step by step, to the numerical extremities. Variations of circuit parameters of a four-line coupled microstrip structure due to the change of finite metallization thickness are presented and discussed     

椭球反射镜膜厚均匀性

本文分析了椭球反射镜膜层厚度均匀性对反射率的影响,从理论上得到膜厚计算公式。根据计算的膜厚分布设计了遮蔽板,获得较好的反射特性。     

Low-voltage BiCMOS dynamic minimum circuit using a parallelcomparison algorithm for fuzzy controllers

The authors present a low-voltage BiCMOS dynamic minimum circuit using a parallel comparison algorithm for VLSI implementation of fuzzy controllers. Using low-voltage BiCMOS dynamic circuits and a parallel comparison algorithm, a four-4-bit-input minimum circuit designed, based on a 1μm BiCMOS technology, shows a 9.5ns comparison time, which is a ×2.5 improvement in speed as compared to that based on CMOS technology     

Adaptive control of arterial blood pressure with a learningcontroller based on multilayer neural networks

The authors discuss a two-model multilayer neural network controller for adaptive control of mean arterial blood pressure (MABP) using sodium nitroprusside. A model with an autoregressive moving average (ARMA), representing the dynamics of the system, and a modified backpropagation training algorithm are used to design the control system to meet specified objectives of design (settling time and undershoot/overshoot) and clinical constraints. The controller is associated with a weighting-determinant unit (WDU) to determine and update the output weighting factor of the parallel two-model neural network for adequate control action and a control-signal modification unit (CMU) to comply with clinical constraints and to suppress the effect of adverse noise and to improve the WDU performance. Extensive computer simulations indicate satisfactory performance and robustness of the proposed controller in the presence of much noise, over the full range of plant parameters, uncertainties, and large variations of parameters     

Erbium-doped fiber amplifier second-order distortion in analog links and electronic compensation

The authors study the second-order distortion when an erbium-doped fiber amplifier (EDFA) is used to amplify the analog optical AM cable TV (CATV) multiple carrier signal from a directly modulated distributed feedback (DFB) semiconductor laser. Experimentally, it was seen that this second order distortion depends critically on the gain of the EDFA fiber amplifier. The authors attribute this distortion to the interaction between the frequency chirping of the DFB laser and the variable gain with wavelength of the amplifier. The authors describe an electronic predistorter that compensates the nonlinearity produced by the DFB-laser-EDFA combination. As a result, the high power advantage of the EDFA can be fully realized in spite of the potential for second-order distortion in the system.<>     

Single nucleotide polymorphism data analysis - State-of-the-art review on this emerging field from a signal processing viewpoint

The basic structural units of the genome are nucleotides. A single nucleotide polymorphism (SNP) is a mutation at a single nucleotide position. This paper discusses several major problems in SNP data analysis and review some existing solutions in this work. Generally speaking, a rich set of SNP analysis problems are cast in the signal processing framework. Our objective is to offer a state-of-the art review on this topic from a signal processing viewpoint so that researchers in the signal processing field can grasp the important domain knowledge to overcome the barrier between the two fields