Applying secondary ion mass spectrometry to the analysis of elements in goblet cells of conjunctiva

We investigated the location of elements in the goblet cells of rat conjunctiva by analyzing ion images produced by secondary ion mass spectrometry (SIMS) and comparing them with those produced by energy dispersive X-ray analyser (EDX). Conjunctivas of normal Spraque-Dawley rats were quenched in propane prechilled liquid nitrogen. Semi-thin sections were made with a cryo-ultramicrotome, freeze-dried, carbon-coated and observed under a light microscope, SIMS and scanning electron microscope (SEM). In the element analysis by SIMS, images of positive ions were examined with an O2+ primary ion source and images of negative ions with a Ga+ ion source. The same sections were observed and analysed with SEM-EDX. Morphological features and images of elements with SIMS and EDX were compared. Na, Mg, K, and Ca were detected as positive ions and OH, CN, P, S, and Cl as negative ions with SIMS, but C, N, O, Na, Mg, P, S, Cl, K, and Ca were detected with EDX. The spatial resolution of SIMS in element location was higher than that of EDX. Many elements were clearly located in the goblet cells on ion images by SIMS. Element ion images were demonstrated more densely in goblet cells than in other parts within conjunctiva and by SIMS compared to EDX. SIMS is a useful method for the detection of elements and their locations in ocular tissues and cells.     

Nanotribology of Si oxide layers on Si by atomic force microscopy

Atomic force microscopy (AFM) has been used for tribological studies of Si surfaces covered by oxide layers of various kinds: chemical oxides prepared by the SC1 (NH4OH/H2O2/H2O) and the SC2 (HCl/H2O2/H2O) treatments and a thermal oxide. In the case of the SC1 chemical oxide, the oxide layer was scratched and the underlying Si substrate was ploughed by the Si3N4 AFM tip. On the other hand, no wear of the sample was noted on the other surfaces: the AFM often produced elevated patterns in the shape of the scanned area, which were no longer visible after HF etching. By annealing the SC1-treated surface in N2 gas at above 200 degrees C for 30 min, the oxide layer could not be scratched any more. By soaking the thermal oxide in KOH, the oxide layer was then scratched. It is concluded that the presence of OH bases is the necessary condition for the nano-scratching of the oxide layers.     

Atomic surface characterisation and modification of the layered compounds Bi2Se3, Bi1.9Sb0.1Se3 and Bi1.6Sb0.4Se3

In this work, we show atomic STM images of the layered compound Bi2Se3. We study the effect in the surface of the substitution of 5% and 20% of the Bi atoms for Sb in Bi1.9Sb0.1Se3 and Bi1.6Sb0.4Se3. The images of the three samples show similar trigonal structures corresponding probably to the van der Waals Se atoms. The distance measured between surface atoms in Bi2Se3 is 4.04 A, in Bi1.9Sb0.1Se3 is 4.16 A and in Bi1.6Sb0.4Se3 is 4.26 A. In Bi1.6Sb0.4Se3 some atomic sites appear brighter than others. The effect is accentuated at higher tunnelling currents and is not observed in the other compounds. Nanoscopic range depressions on the sample might be related to the skeletal crystal structure since the images show atomic corrugations that align slightly in one direction. We explain the results as the effects of the interactions between tip and sample, and discuss two interpretations: on the one hand, localised depression of the individual atomic sites, and on the other the possible elevation of the atoms of the surface due to a phase transition of the compounds induced by STM.     

Numerical prediction of sound generated from flows with a low Mach number

Numerical computations of sound generated from flows with a low Mach number are presented based on Lighthill’s acoustic analogy with an assumption that sound does not alter the flow field from which it is generated. The source fluctuations of the flow field are computed by a large-eddy simulation (LES) with Dynamic Smagorinsky Model (DSM) and they are fed to the following acoustical computation as input data. An explicit/implicit finite element method with second order accuracy both in time and space is used for flow field discretization. The method is applied to the prediction of sound in three different classes of problems: far-field sound generated from flow around a bluff body, sound resulting from blade-stator interaction of turbomachinery and sound due to a turbulent boundary layer on an aerofoil. The computed frequency spectra of the sound show a fairly good agreement with the measured spectra for all the cases.     

Investigation of gas-liquid interface in atmospheric-pressure micro plasma with solution

An atmospheric-pressure glow-discharge micro plasma in contact with liquid paraffin is stably generated by using a capacitively coupled plasma method with a mesh electrode. When characteristics of the plasma are measured in the boundary between the micro plasma (gas-phase) and liquid paraffin (liquid-phase) using optical emission spectroscopy, spectrum peaks of the emission of CH and C₂ which dissociate from paraffin are observed. The result indicates that solution can feed particles to the plasma at gas-liquid interface and this plasma is accordingly expected to promote an attractive plasma process for creating materials consisting of elements in various solutions.     

Applied Genetic Algorithm for Solving Rich VRP

In this article, we present a study of the effectiveness of a genetic algorithm (GA) to solve a combinatorial problem, that is, a vehicle routing problem (VRP). We propose a new selection method, called “rank and select,” based on selection rate, and we compare it with roulette wheel selection. In this article, we use two types of crossover method and two types of mutation method. These are applied for comparing the best fitness at the end of a generation. The problem solved in this study is how to generate feasible route combinations for a rich VRP and meet all the requirements with an optimum solution. Initial test results show that the route produced by the GA was effectively used for solving rich VRP and especially for a large number of customers, depots, and vehicles. Fuel consumption by proposed routes was lower by about 20.38% compared to that of an existing route.     

Surface acoustic wave based sensors employing ionic liquid for hydrogen sulfide gas detection

This paper describes a new type hydrogen sulfide (H₂S) gas sensor using ionic liquid (IL). In this sensor, a reservoir for the IL was integrated on a surface acoustic wave (SAW) resonator. The IL serves as an absorber for H₂S gas. Mass change due to this absorption is detected as shift in the resonant frequency. In this study, we fabricated and demonstrated the sensor using the lithium niobate (LiNbO₃) SAW resonator with the resonant frequency of 38 MHz. The integrated reservoir was filled by the IL 1-butyl-3-methylimidazolium hexafluorophosphate ([bmim]-[PF₆]). As an experimental result, we observed the linear correlation between the frequency-shift and the exposure time of the sensor to the H₂S gas.     

The influence of mesoscale eddies on a commercial fishery in the coastal waters of the Andaman and Nicobar Islands,India

Mesoscale eddies enhance the productivity in a stratified coastal environment by upwelling. The seas around the Andaman and Nicobar Islands have been found to have frequent mesoscale eddy activity. Commercial fishing grounds coincide with upwelling areas associated with cyclonic and anticyclonic eddies and also with areas between two adjacent eddies. There are different eddy zones supporting different types of fishing gears and fish. The current study aims at identifying the different zones of mesoscale eddies in the Andaman Sea and compares the productivity and fishing activity in each of them. Data collected from 454 commercial fishing trips in the Andaman Sea along with maps of sea level anomaly and Moderate Resolution Imaging Spectroradiometer (MODIS) global level 3 mapped thermal infrared (IR) daytime sea surface temperature (SST) from the Aqua and Terra satellites were used for the study. Known upwelling areas such as the periphery of anticyclonic and the core of cyclonic eddies showed higher catches in longlines, ring seines among the fishing gears, and among all the fish species groups. Downwelling areas such as the periphery of cyclonic and the core of anticyclonic eddies showed lower catches with ring seines and the fish species groups. Areas in between adjacent eddies were explored in this study and the fish captures in such areas were found to be different with types of fishing and the target fish group. The study shows results that link eddy activity with the performance of a fishery.     

Amphiphilic Poly(Amino Acid) Nanoparticles Induce Size‐Dependent Dendritic Cell Maturation

Size‐regulated amphiphilic poly(amino acid) nanoparticles (NPs) composed of poly(γ‐glutamic acid) (γ‐PGA) and the hydrophobic amino acid derivative, L ‐phenylalanine ethyl ester (Phe) are prepared to evaluate the effects of particle size on dendritic cell (DC) uptake of NPs and their immune stimulatory activities as delivery carriers and adjuvants. The size of the Phe‐conjugated γ‐PGA NPs (γ‐PGA–Phe NPs) is easily controlled by regulating the aggregated γ‐PGA–Phe numbers. Each of the differently sized γ‐PGA–Phe NPs could efficiently encapsulate ovalbumin (OVA), and the amount of encapsulated OVA per milligram of NPs is almost the same despite the differences in size. The DC uptake of small NPs is lower than for the larger NPs, but the effect of DC activation by NPs is high in the small sizes. The DC activation is significantly affected by the size of the NPs, which suggests that not only the uptake process of the NPs, but also the surface interactions between the NPs and DCs, is important for the induction of DC maturation. The precisely size‐controllable γ‐PGA–Phe NPs have significant potential as an antigen carrier and vaccine adjuvant. These results should provide guidelines for adjuvant design in the development of an effective vaccine.     

Reduction of nitric oxide with activated PAN fibres

The reductive removal of nitric oxide from flue gases by reaction with polyacrylonitrile-based active carbon fibres (PAN-ACF) activated with sulphuric acid has been studied at 423–632 K, using a circulating flow reactor. Nitric oxide (0.67 mmol) was completely removed via reduction with 1 g activated carbon under optimum conditions in 210 and 60 min at 423 and 623 K, respectively. N₂ was formed as NO was removed. Some oxygen remained on the carbon surface at 423 K, but was desorbed as CO or CO₂ on subsequent heating to 623 K. The bimolecular reaction of NO reduction over PAN-ACF, and the possible active sites of oxygen surface groups are discussed in the light of a kinetic study and a comparison of the fibre activation at different temperatures.