Analysis of the detectivity for triple-layer heterojunction GaSb/GaInAsSb infrared detectors

In this paper, the detectivity is calculated and analyzed with the front-or backside illuminated case for both N-GaSb/p₂-Ga_0.8In_0.2As_0.19Sb_0.81/p₁-Ga_0.9In_0.1As_0.09Sb_0.91 and N₁-GaSb/n₂-Ga_0.9In_0.1As_0.09Sb_0.91/p-Ga_0.8In_0.2As_0.19Sb_0.81 infrared photovoltaic detectors, respectively. The analysis results show that the main absorption appears in the p-type Ga_0.8In_0.2As_0.19Sb_0.81 material with either front- or backside illuminated case for above two structures. In each structure, the carrier concentration obviously affects the detectivity. The carrier concentration in the wide-bandgap material for the isotype heterojunction should be reduced as low as possible to reduce the tunneling rate at the isotype heterointerface. Moreover, the change of the detectivity with the p-side surface recombination velocity for the N₁-n₂-p structure is more sensitive than that with the p₁-side surface recombination velocity for the N-p₂-p₁ structure. In the N-p₂-p₁ structure with the incident light from the p₁-side surface, two-color detection is achieved.     

奥氏体耐热钢21-4N碳化物析出行为研究

通过对奥氏体耐热钢21-4N碳化物析出行为的研究,探讨了对性能的影响,提出了改善其综合性能的措施和方法.     

Densitometry determination of dioxins using gold nanoparticlemodified dioxin response element probes

This study aims to develop a rapid and sensitive densitometry bioassay of dioxins. It is known that dioxin ligand can bind heterodimeric aryl hydrocarbon receptor (AhR) and trigger the formation of the complex of dioxin-AhR, AhR nuclear translocator (Arnt), and dioxin-responsive element (DRE). We have established a rapid and sensitive method using nanoparticle-modified DRE probes based on dioxin-dependent binding of DRE to AhR complex. Dioxins can trigger the binding of nanoparticle-modified DRE probe to AhR complex. The nanoparticle-modified DRE probes in the dioxin-AhR-Arnt-DRE complexes immobilized on the microplates were detected by measuring optical density after silver enhancement. Results showed that as little as 0.01 pM of TCDD could be detected. Dioxins could be quantified accurately with the linear range from 1 nM to 0.01 pM. The coefficient of variation was 5≈8% in this bioassay. The optical density of nanoparticle-based silver enhancement was produced in a dose- and time- dependent manner. The dioxin concentrations in fly ash samples determined by this bioassay were comparable with that by the standard HRGC/HRMS. Thus this bioassay is a sensitive and convenient cell-free bioassay of dioxin that is suitable for screening of dioxins in environmental or food matrices.     

现代模具技术及其进展

论述了现代模具种类和学科特点、模具工业特点、模具领域新技术、模具CAD/CAM集成化技术的发展及展望。     

填充料细度对水工沥青混凝土性能的影响

近年来沥青混凝土作为防渗材料，在我国水工建筑中得到了广泛应用。与道路工程的沥青混凝土不同的是，水工沥青混凝土具有良好的粘弹性及抗渗性。目前，国家规范对填充料的细度尚无明确规定，通过调整沥青混凝土的填充料细工，对沥青混凝土的各项性能进行了系统的试验和分析，研究表明：适宜的填充料细度及掺量，能有效地改善沥青混凝土性能，提高其抗渗性。     

乳胶厚度对卤化银反射全息图衍射特性的影响

实验研究了自制的超细颗粒卤化银乳剂SDUF－1分别在AAC显影、改进的R－10漂白处理及改进的GP－8溶解物理显影处理条件下，其乳胶厚度对反射全息图衍射特性的影响。实验结果表明，在这两种不同处理条件下衍射效率与胶厚的关系有相当大的差别，合适的乳胶厚度分别为12μm和6μm左右。     

秦山核电厂气载放射性释放的环境影响

本文评价了秦山核电厂气载放射性流出物对环境的影响。应用现场及风洞大气扩释实验结果和厂址周围的人口与食谱调查资料,估算了秦山核电厂在正常运行和事故条件下释放的气载放射性流出物对公众产生的个人有效剂量当量和集体有效剂量当量。计算结果表明,正常运行时厂址边界(0.5km)处的最大个人有效剂量当量为2.7×10~(-2)mSv/a,该剂量的大部分来自~(137)Cs 的食入(主要由地表湿沉积引起);80km 范围内的集体有效剂量当量为1.1人·Sv/a,归一化集体有效剂量当量为3.7人·Sv/GW(e)·a。文中还给出了事故情况下剂量估算结果。     

过一硫酸的合成及其在铀水冶中的应用

文章介绍了选择过一硫酸合成的最佳条件及进行生产的可行性。介绍了过一硫酸用于含铀煌斑岩、辉绿岩、花岗岩及炭板岩矿石提取铀时,与常规酸浸方法对比,有很好的经济效益和对环境的保护价值。     

不同品位高钛渣对沸腾氯化工艺的影响

分别以94％品位高钛渣和90％品位高钛渣为原料，采用沸腾氯化工艺制备粗TiCl4，分析了两种品位高钛渣对沸腾氯化工艺的影响。结果表明：94％品位高钛渣由于其活性低而对沸腾氯化工艺的影响较大。     

施加复合电磁搅拌对A357合金微观组织的影响

在半固态加工技术中，电磁搅拌是最早应用于制备非枝晶浆料的方法之一，同时也是半固态触变压铸技术最早获得工业应用的重要技术基础之一。采用自行开发的电磁搅拌器，研究了多种不同电磁搅拌方式在不同工艺条件下，单独施加或复合施加对A357合金微观组织的影响。试验结果表明：单一施加旋转感应电磁搅拌时，浆料径向组织很不均匀；单一施加无芯感应电磁搅拌。当搅拌电流较小时，径向组织也不均匀，增大电流，浆料质量有明显改善；采用（旋转感应＋无芯感应）复合电磁场进行复合电磁搅拌时，可在电流较小时获得满意的浆料质量。