Electrochemical Faceting of polycrystalline platinum in HF solutions

The electrochemical faceting of polycrystalline (pc) platinum yielding a (100)-preferred oriented electrode surface was accomplished in HF solutions by applying to the pc platinum electrode a square wave potential perturbation at 1 kHz in the 0.2 to 1.3 V range (vs rhe). SEM patterns of the resulting surfaces were also obtained. For HF concentrations up to 2 M no appreciable influence of the electrolyte concentration on the electrochemical faceting was noticed. Otherwise, the voltammetric response of the (100)-type preferred oriented platinum surface in the H-adatom potential range when compared to previously reported data resulted remarkably sensitive to the electrolyte composition. The discussion of results was based on the non-equilibrium adsorption conditions for anions under the periodic perturbation.     

Catalytic properties and electronic structure of copper ions in Cu-ZSM-5

The effect of ion exchange conditions, such as Si/Al ratio, precursor copper salt, pH and concentration of the solution, on the catalytic activity in SCR of NO by propane and on the electronic state of copper ions in Cu-ZSM-5 has been studied. The NO conversion in NO SCR by C₃H₈ has been found to reach a maximum value at Cu/Al ratio about 0.37–0.4 and remain constant at higher Cu/Al.

ESR and UV–vis DR spectroscopy have been used to elucidate stabilization conditions of copper ions in Cu-ZSM-5 zeolites as isolated Cu²⁺ ions, chain copper oxide structures and square-plain oxide clusters. The ability of copper ions for reduction and reoxidation in the chain structures may be responsible for the catalytic activity of Cu-ZSM-5. These transformations of copper ions are accompanied by the observation of intervalence transitions Cu²⁺–Cu⁺ and CTLM of the chain structures in the UV–vis spectra.     

基于FLUENT软件的管式搅拌反应器流场的数值模拟

运用商业计算流体力学(CFD)软件FLUENT对一种新型管式搅拌反应器进行流场模拟,用GAMBIT建立流场实体模型,采用标准k-ε湍流模型以及多重参考系法(MRF)处理搅拌桨区.结果表明,计算所选模型能较准确地预测搅拌反应器的速度场、压力场及湍流动能分布,考察流量为1 m3/h时不同搅拌转速对反应器内部混合的影响,此时对应的最佳搅拌转速为50 rpm左右.模拟结果将为实验研究提供适当的操作参数,对搅拌反应器的优化和放大具有一定参考价值.     

PTA压力离心机转子的改造

介绍了PTA压力离心机的主要性能参数、工作原理、分离效果的影响因素。为了增大沉渣在过渡区及脱水区滞留的时问，同时为达到在过渡区及脱水区对沉渣加入纯净水进行再冲洗的目的，对螺旋送料转子、挡液环、进料管进行了改造。改造后，沉渣在脱水区的停留时间由0．44a增至0．72s，2．5～3t／h的冲洗水对脱水区的沉渣进行冲洗效果较好。产品中的杂质质量分数较改造前减少15％，产品优等品率提高到99％。     

市区微蜂窝传播路径损耗模式的比较检验

讨论了几种微蜂窝路径损耗模式,并用我国某城市测量的微蜂窝传播数据对COST231WI,修正COST231WI和Xia模式进行了检验,结果表明修正COST231模式的误差最小,Xia模式次之,COST231WI模式最差。从而得到修正COST231模式比较符合我国实际的微蜂窝传播预测模式。     

关于Smarandache可乘函数的均值研究

本文的主要目的是利用初等方法研究Smarandache可乘函数在简单数集中的均值性质,并给出一个有趣的渐近公式。     

生态平衡的伦理学意蕴解读

20世纪以来，人类采用技术工程治理、法律制裁和经济惩罚等措施，一定意义上改善了局部的生态环境，但是未能遏制住全球环境问题的恶化态势。生态危机的根本解决，关键在于人类自身必须进行深刻的利益观念和价值观念的变革。重新审视人与自然界的关系，对自然进行伦理关怀，寻求和建立以保护地球环境和人类生存与可持续发展的生态平衡理念。     

微型生化分析仪样品室温度控制系统研究

结合微型生化分析仪样品室的要求,设计了一种基于单片机的微型生化分析仪样品室温度控制系统.它以AT89S51为核心,采用单总线高精度数字温度传感器DS18B20对样品室温度采样,同时利用汇编语言编写温度设定与控制程序,采用半导体制冷的方式,实现了温度在25℃、30℃、32℃和37℃四个温度值的稳定,控制精度达±0.5℃.     

Design Techniques of CMOS Ultra-Wide-Band Amplifiers for Multistandard Communications

This paper presents design techniques of CMOS ultra-wide-band (UWB) amplifiers for multistandard communications. The goal of this paper is to propose a compact, simple, and robust topology for UWB low-noise amplifiers, which yet consumes a relatively low power. To achieve this goal, a common-gate amplifier topology with a local feedback is employed. The first amplifier uses a simple inductive peaking technique for bandwidth extension, while the second design utilizes a two-stage approach with an added gain control feature. Both amplifiers achieve a flat bandwidth of more than 6 GHz and a gain of higher than 10 dB with supply voltages of 1.8-2.5 V. Designs with different metal thicknesses are compared. The advantage of using thick-metal inductors in UWB applications depends on the chosen topology.     

一种基于服务质量的节能无线传感器网络MAC协议

为了平衡网络能耗与QoS,提出了一种基于服务质量的节能MAC协议-QE-MAC.该协议一方面采用由Hill等人提出的低能量载波侦听技术降低节点能耗,另一方面,采用冲突避免、回复确认、区分优先级和失败重传等机制确保分组传输的可靠性,以及使用业务固定短周期发起策略来解决分组接收的时延过大问题.模拟实验和测试结果都表明,QE-MAC能够以较低的网络能耗提供良好的QoS.