索风营水电站大坝施工中的若干问题决策

结合索风营水电站2005年第1台机组发电的目标,参建各方围绕大坝施工中出现的建基面抬高、固结灌浆、碾压混凝土施工间干扰、坝体建筑材料选择、汛期混凝土施工、砂石加工系统整改等若干问题认真研究、审慎决策,采取了一系列措施,从而扭转了被动局面。     

我国有线电视的网络媒体价值

阐述有线电视网络媒体的特点，有线电视网络媒体面临的困境及解决办法，最后展望有线电视网络媒体价值。     

DFB active filter/detector for multichannel FSK optical transmission

In a DFB laser amplifier, used simultaneously as narrow band optical filter and detector in O-FDM systems the increase of the input optical power induces distortion of the filter transfer function. The effect of such a distortion on the receiver sensitivity and dynamic range has been investigated in a 155 Mbit/s FSK direct detection experiment. A two-channel experiment is also reported for the first time. Owing to the effect of interference between the two channels, it has been found that a minimum channel spacing of about 15 GHz is required to maintain the bit error rate below 10/sup -9/.<>     

非均相成核中间相炭微球的形成过程及其结构演变

以含有喹啉不溶物的煤焦油沥青为原料，在410℃、不同反应时间下获得一系列中间相炭微球(MCMB)和小于0．5μm的碳质颗粒(SCP)。通过对中间相沥青的软化点、族组成和MCMB、SCP的形貌及MCMB断面结构的分析，认为非均相成核MCMB的形成和生长过程不同于均相成核的融并生长过程，而是SCP碳质颗粒的构筑过程，我们称之为“球形基本单元构筑”过程。在MCMB生长过程中，体系的黏度对SCP的形成和MCMB的生长起着重要的作用。非均相成核MCMB的内部结构不是三种模型结构(“地球仪”型、“洋葱”型和“同心圆”型)中的任一种，而是炭层具有收缩点的复杂结构，并且球体的结构不具有“继承性”，即随着反应时间的延长而不断发生变化和调整。MCMB内部分子在球体生长过程中的主要变化趋势是分子的不断缩合长大，而不是分子片层的平行趋向。     

自动控制原理考试系统的设计与实现

对基于Visual Basic 6．0开发的自动控制原理考试系统的系统结构做了阐述，并简要介绍了该系统的设计思想、主要功能及实现方法。     

Impact of Aspen Log Storage with and without Protection on OSB Performance

Outdoor log storage without protection can change the mechanical and chemical properties of wood due to infection by various fungi. To understand how outdoor log storage affects the wood and, subsequently, the strandboard quality, two piles of aspen logs were set up outside and stored for a period of four months (July to November). One of the piles was treated with a biological solution to prevent fungal growth. The other one was stored without treatment. Both piles contained non-debarked and partially debarked logs. Evaluation of sap stain development indicated that all logs had been colonized by staining fungi with average stain coverage of 9.37 to 57.18% and maximum stain penetration of 3.58 to 7.27 cm over the log cross section. The variation of fungal colonization depended on log treatment and bark condition. The most effective way to prevent stain growth was the combination of biological treatment and partial debarking. A series of strandboard was prepared from fresh and aged aspen logs. All boards made from stored logs were statistically comparable to or superior to the control boards made from fresh aspen logs. The boards made from treated/partially debarked and untreated/non-debarked logs were statistically comparable to each other except for wet MOR. In addition, these two board types were statistically stronger than other boards made from treated/non-debarked and untreated/partially debarked logs in terms of IB and water resistance. Some individual stained strands were observed on the finished board surface. Less staining was found in the boards prepared from biologically treated and partially debarked logs, compared with those made from other stored logs.     

临床检验实验室自动化与实验室国际标准化认可的准备

临床检验实验室的自动化集中管理（LAS）及实验室的认可是目前临检专业讨论比较集中的问题.与传统的实验室比较分散、各自独立的分析设备相比,LAS具有集成度高,能够充分利用检验设备资源,与临床信息系统（CIS）联系更密切的特点.本文就实际临床检验中心投入的实验室集中管理系统,对其结构、流程设计、以及导入自动化系统前后实验室改造所带来的变化进行了分析.     

影响喷气燃料与橡胶相容性的因素

采用几种具有不同初始物理性能及不同丙烯腈含量、不同硫化剂和硫化程度的丁腈橡胶，考察了其配方和物理性能对采用不同工艺条件生产的喷气燃料的相容性。结果表明，喷气燃料与橡胶的相容性不仅与喷气燃料的加工工艺有关，而且与橡胶的组成及其制备工艺有关。采用非加氢工艺生产的喷气燃料与橡胶的相容性好于采用加氢工艺(特别是加氢裂化工艺)生产的喷气燃料。橡胶材料的初始力学性能的好坏并不完全决定其与喷气燃料相容性的好坏，橡胶材料的耐过氧化物侵蚀能力才是影响相容性好坏的主要因素。橡胶的组成和其制备工艺决定了橡胶在喷气燃料中萃取物的数量和组成，不同萃取物的综合作用给相容性带来不同程度的影响。用硫作硫化剂的橡胶虽然原始强度低于用过氧化物作硫化剂的橡胶，但前者与喷气燃料的相容性却远好于后者。     

利用UTD修正的MoM-PO混合算法研究

介绍了利用矩量法(MoM)和物理光学(PO)混合方法处理复杂线体结构的电磁散射问题，提出利用pulse基函数对线电流进行展开，使得处理复杂线体结构问题变得简化，并推导出一般的矩阵方程。然后针对PO在阴影区域失效等问题，利用UTD(一致性几何绕射)对该简化模型结构下的PO区域电流进行了修正，使得其应用范围得到扩展、计算精度得到提高。文中的实例结果与传统的MoM很好的一致，从而说明了该方法的有效性和精确性。