High‐Performance,Monolithic Polyaniline Electrochemical Actuators

New polyaniline (PANI) asymmetric membranes were fabricated using a phase‐inversion technique with hexane as the coagulation bath. These membranes exhibit a dense structure with macrovoids distributed asymmetrically throughout the cross‐section. A stress–strain study demonstrated that the Young's modulus (1.421 GPa) and strain at break (7.6 %) of the new PANI asymmetric membranes prepared from hexane are approximately 12 and 4 times higher, respectively, than the values reported previously for the PANI integrally skinned asymmetric membranes (ISAMs) (123 MPa Young's modulus and 1.8 % strain at break). Furthermore, monolithic electrochemical actuators based on a single PANI asymmetric membrane were constructed, and a bending movement of up to 20 Hz was experimentally recorded in a hydrochloric acid aqueous solution. A lifetime of over 329 500 cycles was determined for these actuators at a ± 2° angular displacement (5 Hz). The lifetime is limited by a bending fatigue that creates a transversal crack on the PANI membrane at the air–water interface. Control over the actuator movement is also manifested by the linear dependences of the bending angle on the charge and of the angular velocity on the current. These relationships are independent of both the kind of applied electric signal and the frequency used.     

乙烯-1-辛烯共聚物增韧应用研究

介绍了聚烯烃系弹性体（POE）的特点及其在PP增韧改性中的应用，同时还报道了马来酸酐接枝的POE在极性聚合物复合体系中的应用研究。     

汽车发动机电机铁芯用钢(ADW2)的研制开发

鞍钢研制开发的汽车发动机启动电机用钢是针对汽车电机铁芯用钢（定、转子）而开发的电机钢类产品。介绍了该产品的研制过程及规格、特点。通过批量试制及装机试验，产品巳满足用户的使用要求。     

秦岭金矿9~#脉主要矿物特征及矿物学标志

小秦岭地区金矿床严格受构造控制，各成矿阶段及矿物学特征明显，通过对矿物学特征的研究找出矿物学标志，认为今后找矿要注意各阶段石英的颜色、黄铁矿中金的含量以及矿石中银的含量，这些与金有密切关系.     

采用活性非均匀分布催化剂中变反应器的模拟计算

模拟计算表明:采用活性趋于表层的分布,可以较明显地提高国产中温变换催化剂的内表面利用率,有效地节省催化剂用量,而对“热点”温度没有多大影响。     

近期全国建材市场走势展望

结合当前我国建材市场的形势 ,就建材市场“涨价风潮”的起因 ,从经济增长的结果、市场运行的规律等方面进行了论述 ,提出了涨价风潮对近期全国建材市场的影响     

Preparation of nanosized titania powder via the controlled hydrolysis of titanium alkoxide

By controlling the hydrolysis of titanium butoxide, followed with or without an ethanol washing process, the preparation of nanoscale titania powder was studied in detail. The characteristics of different powders produced by the direct precipitation (without an ethanol wash) and ethanol wash processes were studied by X-ray diffraction, transmission electron microscopy, BET, thermogravimetry and differential thermal analysis techniques. By comparison, it was found that both the direct precipitation and ethanol wash methods can obtain slightly agglomerated nanoscale titania powders of less than 15 nm, but the ethanol wash can further reduce the agglomeration. The particle sizes of titania powders can be modified while still retaining the anatase structure.     

The preparation and magnetic properties of Fe-Ag granular solid using a sol-gel method

The Fe-Ag granular metal solid samples with 10% and 30% weight iron have been successfully fabricated using a sol-gel method, which are characterized by X-ray diffraction and transmission electron micrography. The average diameters of iron particles are from about a few nanometres to a few tens of nanometres controlled by the reducing temperature. The evolution of magnetic properties and microstructure during heat treating are described in detail and explained by using the superparamagnetism, single domain and multi domain theories. The magnetic anisotropy of the Fe-Ag granular solid is studied by using the law of approach to saturation. It is found that the magnetic anisotropy constant is in the order of 10⁵ J m^–3 which is higher than the value of the bulk iron and increases with the increase of reducing temperature.     

沟槽控制爆破研究技术

文章通过对洋浦电厂海水冷却箱涵沟槽预裂（深孔）爆破技术的研究，提出了复杂地质条件下合理的控制爆破参数及微差起爆方式。针对砂层地段难以钻、爆的特点。笔者进行了有益的探讨。