射流泵流场数值模拟的罚有限元法

本文采用罚函数有限元法,在标准k-ε双方程紊流模型下,对射流泵内部轴对称流场进行了数值模拟,得到了较全面的参数分布,特别是全场的压力分布,为射流泵的理论研究和优化设计提供了可靠的依据。给出的算例说明了与文献提供的实验结果基本一致。计算方法简捷,有较大的实用价值。     

Evaluation of accuracy of measuring intraocular pressure by handheld non-contact applanation tonometer

PURPOSE: To evaluate the accuracy of measuring intraocular pressure by handheld non-contact applanation tonometer. METHOD: 58 patients' (113 eyes) intraocular pressure were measured by Keeler, non-contact tonometer and R 900 Goldmann applanation tonometer and the results of measurement of intraocular pressure by the two kinds of tonometers were compared. RESULT: The mean intraocular pressure measured by non-contact is 16.31 +/- 5.59 mmHg and 17.49 +/- 6.13 mmHg (1 mmHg = 0.1333 kPa) by Goldmann applanation tonometer, respectively. There was no statistical significance to be found (P > 0.05) between the two methods. By linear correlation and regression analysis, a positive correlation was found between the two methods (r = 0.8942, b = 0.8154). CONCLUSION: The handheld non-contact tonometer has the same accuracy and reliability of measurement of intraocular pressure comparing with Goldmann applanation tonometer, and it can be used in glaucoma clinic and screening.     

Monoalkyl Esters of Isoalkylphosphonic Acid as Extractants in Rare Earth Separation

Four monoalkyl esters of isoalkylphosphonic acids have been studied for the chromatographic separation ofrare earths (RE).The relationship between distribution ratios and acid concentration of the eluants forsamarium and ytterbium has been explored.The characteristics of these extractants loaded onto macroreticularpoly (methyl methacrylate) resin beads for the separation of lanthanum,cerium,praseodymium and neodymiumhave been compared.Among the extractants studied,mono(1-methylheptyl) ester of isooctylphosphonic acidwas found to be the best for RE separation.The acidity for separation is lower than any known P-containingextractants for the same purpose.For instance,with 1.73 mol·L~(-1) nitric acid as eluent,thulium,ytterbium andlutetium can be separated quantitatively.The extractant-loaded resins possess high column efficiency with goodkinetic characteristics.The extraction mechanism was also explored.     

Electromagnetic properties of ferroelectric-ferrite ceramic composites

The NiFe₂O₄ and Pb(Zr_0.52Ti_0.48)O₃ ceramic composites are prepared by conventional solid state reaction method. The microstructural and morphological properties of the composites are studied by X-ray diffraction analysis and scanning electron microscopy. Results indicate that the ferrite and piezoelectric phases can co-exist in the composites. The relationship between the dielectric constant and frequency (40 Hz–40 MHz) as well as temperature is also investigated. It is noted that the transition temperature of the composites is about 380 °C. A double electric hysteresis loop is observed in our composites. The magnetic properties are relatively weak according to the magnetic hysteresis loop. With increase in the content of the ferrite phase, the permeability increases. The electromagnetic properties of the as-prepared composites are tunable according to the content of the NiFe₂O₄ phase.     

Study of miscibility enhancement in poly(styrene‐co‐4‐vinylphenol)/poly(ethylene oxide) blends by the spin labelling method

The electron spin resonance (ESR) spectra of end‐group spin labelled poly(ethylene oxide) (SLPEO) using 2,2,6,6‐tetramethyl‐piperdine‐1‐oxyl nitroxide and its blends with poly(styrene‐co‐4‐vinylphenol) (STVPhs) of different hydroxyl contents were recorded over a wide temperature range. For a blend of SLPEO and pure polystyrene (PS), the ESR spectrum was composed of a single motion component, indicating that PS was immiscible with PEO. For blends composed of SLPEO and different‐hydroxyl‐content STVPhs, two spectral components with different motion rates were observed over a certain temperature range. The difference between the motion rates should be attributed to micro‐heterogeneity in the blends, with the faster rate corresponding to a nitroxide radical motion trapped in the PEO‐rich domain and the slower rate corresponding to a nitroxide radical motion trapped in the STVPh‐rich domain. Variations in the values of a number of the ESR parameters (T_a, T_d and T_50G) and the apparent activation energy (E_a) with hydroxyl content in the blends indicated that the miscibility of the blends increased with increasing hydrogen‐bonding density due to specific interactions between the hydroxyl groups in STVPh and the ether oxygens in PEO. Copyright © 2004 Society of Chemical Industry     

Thin film deposition on a corrugated surface: A molecular dynamics approach

This paper presents the use of molecular dynamics (MD) simulation in the investigation of the surface topography of early-stage film growth on a GMR (giant-magnetoresistance) corrugated structure. The size of the simulated system is limited in order to reduce the computational workload. The numerical model adopts the Morse potential and the Verlet-leapfrog time evolution scheme [R.W. Hockney, 1970; D. Potter, 1972 (Chapter 5). [1]] to describe the atomic interactions which take place between the atoms. The impact energy transferred from the incident atoms to the substrate is modeled by rescaling the atoms within the upper substrate layers. It is found that the important properties of the film-substrate system may be obtained after the deposition of just several atomic layers. The influence of the impact velocity upon the coating parameters is investigated by varying the incident energy of the deposited atoms. The current results indicate that the surface coverage is poor, when atoms are deposited at low incident energies upon a low temperature substrate. At a higher incident energy, the deposited film tends to exhibit a quasi-layer-by-layer growth mechanism, which results in an improved surface coverage. Finally, it is demonstrated that a distinct quasi-fluid behavior is evident on the substrate when the atoms are deposited at high incident energies.     

Geotechnical properties of the soft soil in Guangzhou College City

The paper describes some geotechnical properties of the soft soils in Guangzhou College City, China, which are difficult to both sample and test. Laboratory and in situ tests were carried out to assess the physical and mechanical indices of the soils. The data were statistically analyzed and linear regression undertaken such that equations could be developed by which the geotechnical properties of the soft soils can be predicted. The statistical validity of the degree of correlation confirmed that using these equations, the mechanical indices can be estimated from physical indices determined by routine testing.