Optimal Performance in Tracking Stochastic Signal Under Disturbance Rejection

The analysis method of optimal tracking performance is proposed for multiple‐input multiple‐output (MIMO) linear time‐invariant (LTI) systems under disturbance rejection. An H₂ criterion of the error signal between the output of the plant and the reference signal is used as a measure for the tracking performance. Spectral factorization is applied to obtain the optimal solution of the system tracking error. The explicit expressions are derived for this minimal tracking error with respect to random reference signals under disturbance rejection. It is shown that the nonminimum phase zeros, the zero direction, the unstable poles, the pole direction of a given plant, statistical characteristics of the reference input signal, and disturbance signal have a negative effect on a feedback system's ability to reduce the system error with disturbance rejection. The results show that the optimal tracking performance will further be damaged because of disturbance rejection. Some typical examples are given to illustrate the theoretical results.     

Scaling effects on flow hydrodynamics of confined microdroplets induced by Rayleigh surface acoustic wave

This paper reports an experimental and numerical investigation on the scaling effects in the flow hydrodynamics for confined microdroplets induced by a surface acoustic wave (SAW). The characteristic parameters of the flow hydrodynamics were studied as a function of the separation height, H, between the LiNbO₃ substrate and a top glass plate, for various droplets volumes and radio-frequency powers. The ratio of the gap height to attenuation length of the SAW, H/l _SAW, is shown to be an important parameter affecting the streaming flow induced in this confined regime. The reported numerical and experimental results are in good agreement over the range examined in this study and demonstrate that, at a lower gap heights of H?≤?100?μm, a significant decrease in streaming velocity or Reynolds number is induced, with the velocity approaching zero when the gap height is decreased to ~50?μm. An increase in the gap height results in an increased streaming velocity; however, if the gap height exceeds 70?% of the SAW attenuation length, any further increase in the gap height induces a drop in the streaming velocity.     

A dynamic programming approach to sequential pattern recognition

This paper presents the dynamic programming approach to the design of optimal pattern recognition systems when the costs of feature measurements describing the pattern samples are of considerable importance. A multistage or sequential pattern classifier which requires, on the average, a substantially smaller number of feature measurements than that required by an equally reliable nonsequential classifier is defined and constructed through the method of recursive optimization. Two methods of reducing the dimensionality in computation are presented for the cases where the observed feature measurements are 1) statistically independent, and 2) Markov dependent. Both models, in general, provide a ready solution to the optimal sequential classification problem. A generalization in the design of optimal classifiers capable of selecting a best sequence of feature measurements is also discussed. Computer simulated experiments in character recognition are shown to illustrate the feasibility of this approach.     

A step towards unification of syntactic and statistical pattern recognition

The problem of pattern recognition is discussed in terms of single-entity representation versus multiple-entity representation. A combined syntactic-semantic approach based on attributed grammars is suggested. Syntax-semantics tradeoff in pattern representation is demonstrated. This approach is intended to be an initial step toward unification of syntactic and statistical approaches to pattern recognition.     

在Fe-Al-C系统中合成优质Ⅱa型宝石级金刚石单晶

和优质Ib型宝石级金刚石单晶生长相比，作为当今高温高压晶体生长的一种高精尖技术，优质1／a型宝石级金刚石单晶对合成技术提出了更高更苛刻的要求：枢研究从晶体的生长速度出发，发现一开始阶段（大约几个小时）的晶体生长速度对优质宝石级金刚石单晶的后期生长争关重要。埘Fe-Al-C系统（Al含量不大于2．5wt％）来说，采用多品种法将晶体开始阶段的晶体生长速度由1．5mg／h降至0．5mg／h后，对生长过程中金属包裹体的进入有了明显的抑制作用，晶体的质量有了很大提高。从晶体中包裹体的存任形式来看，为了获得优质Ⅱa型宝石级金刚石单晶，在触媒中人为地添加除氮剂给晶体生长过程中的排杂过程带来了很大的难度：为了更好的实现排杂，必须很好的处理晶体表面的径向平铺生长速度和晶体轴向的堆积生长速度之间的火系。     

红外测温技术在离心复合铸造轧辊生产上的应用

本文分析了离心复合铸造轧辊生产过程中离心机停机温度和时间对轧辊质量的影响 ,提出了用先进的红外测温技术来预报停机温度和时间 ,以实现微机监控适时停机 ,保证轧辊内外层熔合良好 ;同时指出了红外测温技术在离心复合铸造轧辊生产上的应用前景     

Preparation and properties of nanosize MnZn ferrite from δ-FeOOH

Ferrous ion was transformed into feroxyhyte (δ-FeOOH) by oxidation. Then, manganese sulfate and zinc sulfate in some ratio were added to the feroxyhyte solution. The co-precipitation was boiling reflux conditions sometime under constant stirring. The nanosize MnZn ferrite powder was formed. The mechanism of preparation of the nanosize MnZn ferrite was discussed, and the formation of feroxyhyte which was playing a key role during the process was mentioned. The properties of powder was tested by means of X-ray diffraction, transmission electron microscopy and vibrating sample magnetometer. The results show that the samples of spherical particles about 20 nm, which have characteristics of ferrimagnetism, has larger saturation magnetization, but the remanent magnetization and coercivity are comparatively smaller. The spinel MnZn ferrite nanosize powder was successfully prepared from δ-FeOOH at low temperature, with low-carbon steel and peroxide as main material.     

人胎盘泌乳素的提纯及裂解片断免疫学特性的研究

采用人胎盘泌乳素（hPL）-亲和层析和抗人血清抗体-亲和层析技术，从胎盘匀浆中提取hPL纯品，经圆盘电泳、免疫电泳及交叉试验证实为单一成分。溴化氰水解后的产物，以高效液相色谱分析。分离出7个肽链片断峰，分别用hPL和人生长激素（hGH）放免法检测其活性，其中第6肽链片断无hGH免疫活性，若用此片断制备特异抗体，可避免与hGH出现交叉反应。     

异丁烯两段催化氧化制甲基丙烯酸催化剂研究 Ⅰ．异丁烯气相氧化制甲基丙烯醛多元复合氧化物催化剂的研究

本文报导用于异丁烯（叔丁醇）选择氧化制ＭＡＬ（甲基丙烯醛）的多元复合氧化物催化剂的研究结果。同共沉淀法制备的催化剂的活性主要决定于其化学组成，同时受到制备条件的影响。最佳催化剂的主要物相组成为ＰｂＯ３，Ｂｉ２ＭｏＯ３．３、ＮｉＭｏＯ４、Ｓｂ２Ｏ３及ａ－Ｆｅ２Ｏ３小颗粒。在３５５℃，１０００～２５００ｈ－１空速范围，叔丁醇：水：空气＝１：３．３：７（摩尔比）的条件下可获得异丁烯转化率达９６％，ＭＡＬ选择性达８９％的结果。