Anomalous variations of OFF-State leakage current in poly-Si TFTunder static stress

Studies the anomalous variations of the OFF-state leakage current (I_OFF) in n-channel poly-Si thin-film transistors (TFTs) under static stress. The dominant mechanisms for the anomalous I_OFF can be attributed to (1) I_OFF increases due to channel hot electrons trapping at the gate oxide/channel interface and silicon grain boundaries and (2) I_OFF decreases due to hot holes accumulated/trapped near the channel/bottom oxide interface near the source region. Under the stress of high drain bias, serious impact ionization effect will occur to generate hot electrons and hot holes near the drain region. Some of holes will be injected into the gate oxide due to the vertical field (~(V_Gstress V_Dstress)/T _OX) near the drain and the others will be migrated from drain to source along the channel due to lateral electric field (~V_Dstress/L_CH)     

含油废水处理

在水量水质调查的基础上，本文提出了以出水回用为目的的含油废水隔油调节沉淀－混凝沉淀－砂滤处理工艺，动态模型试验表明，废水中油和ＣＯＤ的去除率分别达到９５％和９０％，出水浊度低于２，此水质完全可回用于有关生产车间。     

北运河运河核心区地表水资源状况分析

通过分析运河核心区汇水关系和北关分洪枢纽的历史变迁,收集整理1981-2018年北运河北关闸和通惠河高碑店站水文资料,计算控制流域的降水量、不同时段来水量、河道生态需水量和下游用水量以及可利用来水量,分析表明:运河核心区地表水资源较充沛,来水量较为稳定,可利用水资源保证程度较高.研究结果对于该区域科学取用水、水资源可持续利用以及相关产业的有效实践有参考意义.     

基于单片机的分段线性插值算法实现

分段线性插值算法是一种技术比较成熟、实现比较简单的低次多项式插值算法,其曲线逼近程度即插值函数与原函数误差基本满足一般的工业控制场合需要。该算法占用系统资源少,在数据采集和数据处理等工业控制领域,往往使用单片机或嵌入式系统等资源受限处理器,通过分段线性插值算法简化原函数,减少计算量,对于提高系统整体性能具有显著的现实意义。     

Preparation and properties of close-packed composite materials

Monodisperse silica particles of about 0.3m diameter are suspended in methacrylate monomer using a carefully selected dispersant. Many steric dispersants are hydrocarbon chains with a reactive end-group. These are not effective as dispersants for silica in moderately polar solvents, such as esters and the methacrylate monomers. Good dispersion was obtained with a methacrylate polymer terminated by a chlorosilane end group. Settling or centrifugation of these unagglomerated dispersions gives well-packed particle beds. Polymerization of the surrounding monomer produces composite materials with high packing fractions and a high degree of regularity. Moduli and strengths of these composites are reported.     

电动车制动能量再生反馈控制研究

研究了电动汽车制动过程中的能量回馈，设计了混合励磁无刷电动机在汽车制动过程的能量再生反馈控制系统。以脉宽调制调压调速系统为例，研究各种制动态下的能量回馈过程。并将其安装在EV6600电动汽车上进行试验，结果表明：该控制系统可达到10%左右的能量回收效率。     

提高钻杆接头冲击功的工艺方法

针对石油钻井关键产品高强度钻杆接头的使用要求,在保证强度指标要求非常高的前提下,研究摸索增加高温正火后再调质的工艺方法,以改善接头材料原始微观带状组织和纤维结构,细化晶粒,提高钻杆接头的冲击功,使该产品力学性能达到API标准的要求。     

碱土金属在萃取剂与树脂间反应平衡常数的测定

研究了碱土金属离子在Ｄ００１树脂与８－羟基喹啉三氯甲烷溶液间的平衡常数Ｏ－ｔＫ的测定。其值依Ｍｇ、Ｃａ、Ｓｒ、Ｂａ次序减小。并得出萃取剂浓度［ＨＡ］。与金属离子在两相分配的关系。     

2,6-二乙酰基吡啶合成方法的改进

优化了2，6—二乙酰基吡啶的合成工艺。以2，6—吡啶二羧酸为原料，经过醇化及克莱森酯缩合反应，合成了2，6—二乙酰基吡啶，2，6—吡啶二羧酸二乙醇和2，6—二乙酰基吡啶的分离收率分别为94．1％和88．9％，2，6—二乙酰基毗啶的质量分数大于99％。