Characterization of ultrafine La x Sr1−x MnO3 powder prepared by spray pyrolysis

The characterization of La _x Sr_1−x MnO₃ powders produced by spray pyrolysis using scanning electron microscopy (SEM) and transmission electron microscopy (TEM) observation, specific surface area (Brunauer-Emett-Teller), and particle size distribution measurements shows that the resultant large particles are loose agglomerates consisting of many small particles. However, the sintered tiny particles can form hard agglomerates, and the particle size increases remarkably. The structures of the powders before and after sintering were identified by x-ray diffraction (XRD). The study of the electrical property of the powder shows that the powder is a metallic conductor. In a reducing atmosphere, the powder can be decomposed. When the powder is cofired with yttria-stabilized zirconia 5% (YSZ) powder at 1200 °C for 5 h, no new phase is produced, and the powder remains a single provskite hexagonal-rhombohedral structure.     

稀土含量对喷熔层组织及耐蚀性的影响

本文通过在镍基自熔合金粉末中加入不同含量的稀土，研究了稀土含量对喷熔层组织及耐蚀性的影响规律及其作用机制。结果表明，在喷熔材料中加入适量稀土，可使喷熔层组织细化、晶界净化，从而使腐蚀过程中的表面活性点减少，耐蚀性提高。     

测定银的新催化分光光度法研究──藏红T－碘化钾指示反应体系

根据银对藏红Ｔ与碘离子氧化还原反应的催化作用，建立了一种测定微量银的动力学光度法。方法的线性范围为０．５～４．０μｇ／ｍｌ，检测限为０．０２μｇ／ｍｌ。除Ｈｇ２＋严重干扰，Ｆｅ３＋、Ｃｒ６＋有轻度干扰外，其余常见的离子不影响测定。与常见测定银的动力学法相比，本法反应速度很快，且所有测定均可在室温下进行。     

汽车后市场准入门槛亟需设防

任何市场都是有规则的,没有标准的市场是短暂的.经销商要有一个好的经营环境,必须把这个门槛设好. 汽车后市场还需要准入门槛? 李庆云现任天津环渤海汽车城董事长并身兼天津市交易市场协会会长,在没有跨进汽车行业之前,一直觉得这样的问题多余:哪个行业没有准入门槛?等自己在天津建立环渤海汽车城之后,才意识到,中国的汽车后市场是多么需要"设防".     

Properties of poly(n‐butyl methacrylate) prepared by reverse atom transfer radical polymerization in an aqueous dispersed system

Reverse atom transfer radical polymerization (ATRP) of n‐butyl methacrylate (BMA) in waterborne media using Cu(II) complexes with azo initiators (i.e., reverse ATRP) was conducted. The influence of several factors, such as surfactant, catalyst, and reaction time, on the stability of the emulsion, the particle size, the morphology of the emulsion particles, and the control of the polymerization was investigated. The results showed great differences between ATRP and conventional emulsion polymerization, especially the nucleation mechanism and the kinetics. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 1542–1547, 2003     

铁(Ⅲ)—苯芴酮—聚乙二醇辛基苯基醚显色反应的研究及应用

详细研究了非离子表面活性剂聚乙二醇辛基苯基醚（OP）存在下铁（Ⅲ）与苯芴酮的显色反应。结果表明铁（Ⅲ）与苯芴酮形成了蓝紫色的配合物，其最大吸收波长λmax为614nm，对比度（△λ）为74nm，摩尔吸光系数ε614为6．41×104L·emol(-1)·cm(-1)，铁量在0～16μg／25mL范围内服从比耳定律。所拟方法用于磷矿样中铁的分析与邻菲罗啉法结果一致。     

Analysis of the oscillatory behavior of double-walled carbon nanotube-based oscillators

Molecular dynamics simulations of oscillatory behaviors of double-walled carbon nanotube-based oscillators are performed. The second-generation empirical bond-order potential is used for the atomic interactions within a wall, and a registry-dependent and four different registry-independent van der Waals potentials are used for the atomic interactions between walls. It is found that the frequencies of the nanotube oscillators are sensitive to the choice of the van der Waals potentials. An almost non-decay oscillation is observed for the registry-dependent potential when there is no rocking motion. However, an apparent decay oscillation is observed when rocking motion occurs. A decay oscillation is observed for all registry-independent potentials even without rocking motion. Mechanisms leading to unstable oscillatory behavior are analyzed.     

环己烷液相无催化剂的氧化动力学研究

采用搅拌釜反应器,在确认已排除传质因素对反应速率影响的情况下,研究了环己烷液相无催化剂的氧化反应动力学。应用自由基理论及最优化计算技术,从导出的8个候选动力学模型中,确定了最佳的动力学模型,它能满意地描述环已烷氧化过程。该动力学可为环己烷氧化工业生产操作条件的优化、反应器的选型及工业设计提供依据。     

结晶性高聚物作为相变材料的应用

本文研究了结晶性高聚物聚乙烯及其共混物作为相变材料对模拟发热体铜片热量的吸收作用，由于相变的吸热，铜片的温度在一定时间范围内保持在一个定值。选择不同的相变材料，可使这种温度平台出现在不同的温度范围，不共晶的共混物可有两个以上的温度平台，提高了降温效果。     

碱土金属在萃取剂与树脂间反应平衡常数的测定

研究了碱土金属离子在Ｄ００１树脂与８－羟基喹啉三氯甲烷溶液间的平衡常数Ｏ－ｔＫ的测定。其值依Ｍｇ、Ｃａ、Ｓｒ、Ｂａ次序减小。并得出萃取剂浓度［ＨＡ］。与金属离子在两相分配的关系。