Residual stresses and transformation toughening in MoSi2 composites reinforced with partially stabilized zirconia

The results of study of the effects of yttria stabilization (0–6 mol.%) on the room-temperature fracture behavior and toughening mechanisms in zirconia-reinforced MoSi₂ are presented in this paper. Transformation toughening is shown to occur only in composites reinforced with zirconia particles stabilized with 2 mol.% yttria. However, the fracture toughness levels are comparable in the other composites with yttria levels between 0 and 6 mol.%. Toughening in the other composites is attributed to the combined effects of residual stress, microcrack shielding/anti-shielding and/or crack deflection. A rigorous micromechanics-based model is presented for the estimation of residual stress levels in brittle materials reinforced with phases that can transform during cooling or under stress. The model is applied successfully to the rationalization of the observed fracture and toughening phenomena.     

地表热释光找油机理的探讨

油气藏的微渗漏造成的上方放射性元素的局部富集（或贫化）影响地表沙土的天然热释光量，据此探讨了热释光找油的机理。     

Leiomyomatosis peritonealis disseminata. Two case reports

AIM: To study the action of quercetin (Que) on inhibiting platelet aggregation. METHODS: Active oxygen free radicals produced by xanthine/xanthine oxidase (Xan/XO) reaction was used, platelet aggregation was determined by the turbidimetric method, and the Xan/XO oxyradicals generating reaction by luminol-dependent chemiluminescence (Che) method. RESULTS: Active oxygen free radicals enhanced the platelet aggregation induced by ADP 1.6 mumol.L-1. The rate of maximal aggregation increased from 29%-38% for ADP to 59%-70% for ADP + Xan/XO. The enhancement was abolished by the treatment of platelet-rich plasma (PRP) with Que 650 mumol.L-1 or hydrocortisone (Hyd) 900 mg.L-1. Both Que and Hyd scavenged the active oxyradicals in vitro. The Che was decreased by 75.7% (Que 4 mumol.L-1) and 79.0% (Hyd 900 mg.L-1) as compared with control. CONCLUSION: Active oxygen free radicals participated in the platelet aggregation, and scavenging oxyradicals by Que was one of mechanisms of inhibiting platelet aggregation.     

Depth of intergranular oxygen diffusion during environment-dependent fatigue crack growth in alloy 718

The elevated-temperture fatigue crack growth behavior in alloy 718, when subjected to a loading frequency lower than the transitional frequency of this alloy, is viewed as fully environment dependent. In this process, the crack growth increment per loading cycle is assumed to be equal to the intergranular oxygen diffusion depth at the crack tip during the cycle effective oxidation time. In order to identify the trend of this diffusion depth an experimental program was carried out on compact tension specimens made of alloy 718 at 650 °C in which fatigue crack growth measurements were made for cyclic load conditions with and without hold time periods at minimum load level. This work resulted in establishing a relationship correlating the intergranular oxygen diffusion depth and the value of the stress intensity factor range ΔK. This relationship, when integrated over the cycle effective oxidation time, results in a closed-form solution describing the environment-dependent fatigue crack growth rate. A comparison is made between the results of this solution when applied to different loading frequencies and the corresponding experimental results. This comparison shows good agreement between the two sets of results. Furthermore, by combining the parabolic rate law of diffusion and the equation for the intergranular oxygen diffusion depth, an explicit expression for the oxygen diffusivity of grain boundaries is derived. It is found that this diffusivity is both a ΔK- and a frequency-dependent parameter.     

Modeling Power Supply Noise in Delay Testing

Excessive power supply noise during test can cause overkill. This article discusses two models for supply noise in delay testing and their application to test compaction. The proposed noise models avoid complicated power network analysis, making them much faster than existing power noise analysis tools. can cause performance degradation and     

Hydrogenated amorphous silicon thin-film transistor arrays fabricated by digital lithography

A jet-printed digital-lithographic method, in place of conventional photolithography, was used to fabricate 64 /spl times/ 64 pixel (300 /spl mu/m pitch) matrix addressing thin-film transistor (TFT) arrays. The average hydrogenated amorphous silicon TFT device within an array had a threshold voltage of /spl sim/3.5 V, carrier mobility of 0.7 cm/sup 2//V/spl middot/s, subthreshold slope of 0.76 V/decade, and an on/off ratio of 10/sup 8/.     

Acoustical tomography based on the second-order Born transformperturbation approximation

Reconstruction algorithms and their numerical examples of acoustical tomography based on the second-order Born transform perturbation approximation are presented. The reconstruction algorithms in the second-order Born approximation are similar in form to those in the first-order Born approximation. Replacing the angular spectrum of the scattered wave in the first-order case by the result of applying a first-order operator to the angular spectrum of the scattered wave or applying a second-order operator to the angular spectrum of the incident wave leads to the second-order reconstruction algorithms. Also, comparisons of reconstruction algorithms of the first- and second-order Born approximations are given, and they show that the second-order Born approximation algorithms have a distinct advantage over the first-order approximations in many cases