CENTUM-CS1000在离子膜制碱工艺中的应用

介绍了DCS在离子膜制碱工艺中的应用及常用控制方案的实现和运行效果。     

异丁烯两段催化氧化制甲基丙烯酸催化剂研究 Ⅰ．异丁烯气相氧化制甲基丙烯醛多元复合氧化物催化剂的研究

本文报导用于异丁烯（叔丁醇）选择氧化制ＭＡＬ（甲基丙烯醛）的多元复合氧化物催化剂的研究结果。同共沉淀法制备的催化剂的活性主要决定于其化学组成，同时受到制备条件的影响。最佳催化剂的主要物相组成为ＰｂＯ３，Ｂｉ２ＭｏＯ３．３、ＮｉＭｏＯ４、Ｓｂ２Ｏ３及ａ－Ｆｅ２Ｏ３小颗粒。在３５５℃，１０００～２５００ｈ－１空速范围，叔丁醇：水：空气＝１：３．３：７（摩尔比）的条件下可获得异丁烯转化率达９６％，ＭＡＬ选择性达８９％的结果。     

Measurement of the rheological properties of polymer melts with annular rheometer

An annular die has been designed having a very thin gap distance between two coaxial cylinders. The die was then used to measure wall normal stresses along the longitudinal direction of polymer melts flowing through the thin annulus. The materials investigated were high-density polyethylene, low-density polyethylene, polypropylene, and polystyrene. Also investigated were blends of polystyrene and polypropylene, and blends of polystyrene and high-density polyethylene The measurements of wall normal stresses were used to determine the rheological properties of the melts, namely, the melt viscosity from the slope of axial wall normal stress profiles and the melt elasticity from exit pressures. The interpretation of the experimental data was made possible by the fact that the narrow-gap annular die can be considered as a substitute for a thin slit die. It has been found that the results obtained in the present study are consistent with those reported earlier by the author, who at that time used both capillary and slit dies.     

Water-soluble and amphiphilic polymers

Summary Three PEO-PSt-PEO triblock polymers and their parent ho-nopolystyrene have been studied by means of light scattering technique in chloroform, toluene and ethyl acetate. It has been found that the weight average molecular weights calculated by using the equation Mapp- were unbelievable negative values; and the largest deviation appeared for the sample with PEO mole content of about 50%. Data of PSt-PEO-PSt triblock polymers in literature have been quoted and discussed.     

Guerbet十四醇的合成与表征

以正庚醇为原料 ,通过Guerbet反应合成Guerbet十四醇 (2 戊基壬醇 ,C14 GA)。用IR、NMR和元素分析测定了C14 GA的结构 ,并研究了反应温度和用料比对其产率的影响。实验结果如下 :(1)在较优化的反应条件下 (正庚醇的总加入量为 1mol,在实验过程中 ,先加入 1/ 3mol庚醇和 1/ 4mol的KOH ,在 16 0℃下反应 2h ,然后再加入剩下的 2 / 3mol庚醇和 4g 5 %Pd -C催化剂 ,在 15 5℃下反应 6h)合成产物 ,其产率可达到 5 4 2 0 % ;(2 )所合成的产物与试图要得到的Guerbet十四醇 (2 戊基壬醇 ,C14 GA)含有相同的基团 (2×—CH3、10×—CH2 —、1×CH、1×—CH2 —O—和 1×—OH) ,而且 ,所合成的产物中 ,w (C) =79 0 6 % ,w (H ) =13 6 2 % ,与从Guerbet十四醇分子式计算的理论值w(C) =78 5 0 % ,w (H) =14 0 1%基本一致。可见所合成的产物正是Guerbet十四醇 (C14 GA)     

Industrial TiO2 based nacreous pigments as functional building materials: Photocatalytic removal of NO

In this paper, the photocatalytic activity of industrial titanium dioxide (TiO₂) based nacreous pigments was researched as functional building materials for photocatalytic NO remove. Three industrial TiO₂ based nacreous pigments were selected to estimate the photocatalytic activity for NO remove. This study is a good proof that pearlescent pigments can eliminate NO, and its performance is positively correlated with its titanium dioxide content. And this research will widen the application of nacreous pigments in functional building materials, and provide a new way to eliminate in door nitric oxide pollution.     

中央空调的水处理

本文扼要介绍了中央空调循环冷却水和冷冻水系统中常见的问题及其原因,并对冷却水和冷冻水的处理程序作了初步的阐述.     

ATO包裹硅酸锆的制备与应用

采用化学共沉淀技术制备了锑掺杂二氧化锡(ATO)包裹硅酸锆的导电粉体,对比了该导电粉体与ATO在防静电陶瓷中的应用效果。结果表明与掺纯ATO相比较,掺入ATO包裹硅酸锆的防静电陶瓷颜色比较浅,并且能明显减少氧化锡的用量,当陶瓷的表面电阻为107Ω/□量级时,用ATO包裹硅酸锆作为导电填料可以节省25%左右的ATO。     

The determination of the pore structural parameters of isoporous resins by inverse GPC

The swollen pore structure of a series of microporous isoporous resins (7.4–140 Å) are investigated with inverse GPC, n-alkylbenzenes and linear polystyrenes being used as probe molecules. The results indicated that, with the lowering of crosslinking degree of isoporous resins, the average pore diameter increased and the pore distribution curve broadened. All pore volume distribution obeyed a log-normal distribution. Based on the linear regression method, the experimental data were fitted to a monotonously declining exponential function and a normal distribution function by a computer, and some important structural parameters such as average pore diameter, pore volume distribution, specific surface area, etc. were obtained. The specific surface area of swollen gels were found much greater than those in the dry state measured by N₂ adsorption.     

冷却器盘管失效分析及防范措施

本文介绍了冷却器盘管破裂泄漏的情况，分析了失效破坏的原因，并提出防止冷却器盘管破裂泄漏的措施。