甲基丙烯酸三氟乙酰氧乙酯的聚合

对甲基丙烯酸三氟乙酰氧乙酯(TFAOEMA)的阴离子聚合及原予转移自由基聚合进行了研究。常用的阴离于引发剂如丁基锂、1，1-二苯基已基锂等很难引发TFAOEMA的阴离子聚合，而碱性较弱的引发剂如三乙基铝却容易引发，且产率较高。以氯化亚铜、五甲基二乙基三胺、溴代丙酸乙酯为引发体系的TFAOEMA的本体原子转移自由基聚合符合活性聚合特征。但在四氢呋喃为溶剂的原子转移自由基聚合中却存在活性中心失活现象。以末端含卤素的聚甲基丙烯酸甲酯为大分子引发剂，引发TFAOEMA的原子转移自由基聚合，得到了含氟双嵌段聚合物。     

Programmable group-delay module using binary polarization switching

We demonstrate the first programmable group-delay module based on polarization switching. With a unique binary tuning mechanism, the device can generate any differential group delay value from -45 to +45 ps with a resolution of 1.40 ps, or any true-time-delay value from 0 to 45 ps with a resolution of 0.7 ps. The delay varying speeds for both applications are under 1 ms and can be as fast as 0.1 ms. We evaluate both the dynamic and static performances of the device while paying special attention to its dynamic figures of merit for polarization-mode dispersion emulation and compensation applications. Our experiment shows that the device exhibits a negligible transient-effect induced power penalty (<0.2 dB) in a 10-Gb/s nonreturn-to-zero system.     

An alternative blind feedforward symbol timing estimator using two samples per symbol

Recently, S.J. Lee proposed a blind feedforward symbol timing estimator that exhibits low computational complexity and requires only two samples per symbol (see IEEE Commun. Lett., vol.6, p.205-7, 2002). We analyze Lee's estimator rigorously by exploiting efficiently the cyclostationary statistics present in the received oversampled signal; its asymptotic (large sample) bias and mean-square error (MSE) are derived in closed-form expression. A new blind feedforward timing estimator that requires only two samples per symbol and presents the same computational complexity as Lee's estimator is proposed. It is shown that the proposed new estimator is asymptotically unbiased and exhibits smaller MSE than Lee's estimator. Computer simulations are presented to illustrate the performance of the proposed new estimator with respect to Lee's estimator and existing conventional estimators.     

89-GHz fT room-temperature silicon MOSFETs

The authors report the implementation of deep-submicrometer Si MOSFETs that at room temperature have a unity-current-gain cutoff frequency (f_T) of 89 GHz, for a drain-to-source bias of 1.5 V, a gate-to-source bias of 1 V, a gate oxide thickness of 40 Å, and a channel length of 0.15 μm. The fabrication procedure is mostly conventional, except for the e-beam defined gates. The speed performance is achieved through an intrinsic transit time of only 1.8 ps across the active device region     

试谈高炉冷却壁的检漏及维护

高炉冷却壁的检漏及维护，是炼铁工作者十分关心的问题，本文针对邯钢高炉具体情况，探讨了高炉冷却壁漏水的原因，检漏方法，漏水冷却壁的维护及预防措施。     

用φ20mm离心萃取器两步法制取高纯钇

本文研究了中钇富镧稀土的氧化物溶液在环烷酸中的萃取行为，测定了镧钇组成、温度变化与分离系数的关系；在Ｐ＿（５０７）体系中研究了ｐＨ值与分配比的关系；提出用环烷酸、Ｐ＿（５０７）两种萃取剂制备高纯钇的工艺流程。用８４台φ２０ｍｍ离心萃取器进行了一个月的台架试验，结果证明两种萃取剂有很好的互补性，在满足钇的纯度要求下有较高收率。离心萃取器具有易分相、体系存留量少、液流密闭性好等优点，它更适宜于粘度大、级数多、产品纯度要求高的体系。     

1.48μm掺饵光纤放大器泵源

采用Ｐ型ＩｎＰ衬底新月型结构制备了１．４８μｍ大功率激光器，该激光器与单模光纤耦合输出功率大于４０ｍＷ。     

流动微量量热法研究阴离子表面活性剂在油砂表面的吸附

用流动微量量热法研究了十二烷基硫酸钠(SDDS)和十二碳羧酸钠(SL)在克拉玛依油田九区和乌尔禾区油砂上的吸附,简要地计论了吸附机理。所得实验结果表明,SL 在油砂上的吸附强度比 SDDS 的要大,在相当低的浓度下即可迟到饱和吸附。     

糖化酶制剂辐照性能研究

研究了工业糖化酶制剂经辐照处理后各项性能的变化。结果表明,经2kGy以下剂量的γ射线处理后,可提高其贮存稳定性,改善卫生品质,不影响其正常使用。     

Non-steady-state model for kinetics of free radical polymerization, 4. Direct thermal initiation

This paper deals with the non-steady-state kinetics of direct thermal initiated polymerization. The initiation is assumed to be a bimolecular reaction of the monomer. The relationship between the radical concentration and the monomer conversion is rigorously derived. In further treatment a few very close approximations are introduced based on the fact that the number of monomer molecules reacting in the initiation step is much less than that consumed in the propagation step for a process producing high polymer, and the value of the rate constant for propagation or chain transfer is much lower than that for chain termination. Expressions for various molecular parameters, such as molecular weight distribution, number-average and weight-average degrees of polymerization, and dispersity, are given. Several numerical examples are provided.