催化裂化汽油选择性加氢脱硫催化剂RSDS-1的开发

介绍了用于催化裂化汽油选择性加氢脱硫催化剂RSDS-1的研究开发，考察了载体、活性组元、金属原子比以及助剂对催化剂选择性的影响。研究结果表明，催化裂化汽油中烯烃的加氢饱和受扩散限制；Co—Mo组合对烯烃饱和的能力相对较弱；较高的Co／Mo原子比有利于提高催化剂选择性；助剂的加入对催化剂选择性有明显的影响；RSDS—1催化剂用于催化裂化汽油选择性脱硫，对不同原料油适应性好，脱硫率可达80％，RON损失小于2个单位，且可长周期稳定运转。     

Investigation of the source/drain asymmetric effects due to gate misalignment in planar double-gate MOSFETs

A planar double-gate SOI MOSFET (DG-SOI) with thin channel and thick source/drain (S/D) was successfully fabricated. Using both experimental data and simulation results, the S/D asymmetric effect induced by gate misalignment was studied. For a misaligned DG-SOI, there is gate nonoverlapped region on one side and extra gate overlapped region on the other side. The nonoverlapped region introduces extra series resistance and weakly controlled channel, while the extra overlapped region introduces additional overlap capacitance and gate leakage current. We compared two cases: bottom gate shift to source side (DG/spl I.bar/S) and bottom gate shift to drain side (DG/spl I.bar/D). At the same gate misalignment value, DG/spl I.bar/S resulted in a larger drain-induced barrier lowering effect and smaller overlap capacitance at drain side than DG/spl I.bar/D. Because of reduced drain-side capacitance, the speed of three-stage ring oscillator of DG/spl I.bar/S, with 20% gate misalignment length (L/sub mis/) over gate length (L/sub g/), or L/sub mis//L/sub g/=20%, was faster than that of two-gate aligned DG-SOI.     

An investigation into physicochemical characteristics of ash produced from combustion of oil palm biomass wastein a boiler

Ash derived from combustion of Malaysian oil palm biomass (empty fruit bunches consisting of fibers) was physically and chemically characterized in order to provide a comprehensive understanding of its specific properties in terms of toxicity, compositions and reusability. Principal analyses conducted include particle size distribution, scanning electron microscopy, elemental dispersive X-ray, elemental analysis, toxicity characteristic leaching procedure (TCLP) as well as thermogravimetric, X-ray diffractometry and Fourier-transform infrared analyses. TCLP result indicated that the oil palm ash (OPA) should not be classified as toxic wastes in terms of heavy metal leachability since leachable copper, cadmium, lead and nickel concentrations were detected below the stipulated leachability limits. It was determined that the OPA contained high amount of potassium as well as presence of silica which implied its suitability to be reused as crude fertilizer or cement replacement material.     

基于作业测定技术的后桥壳生产线工艺评价及优化

以某企业后桥壳生产线为研究对象,运用作业测定技术中的时间研究法,测定后桥壳各工序的标准时间,评价工艺及找到瓶颈工序;运用"5W1H"提问技术,根据"ECRS"原则,同时结合工艺设计及企业资源情况,对后桥壳生产线现有工艺进行评价及优化,改善后,使生产线的产能每天提高了10件,生产能力提高了33.57%.     

Analysis and comparison of two-dimensional permanent-magnet arrays for planar motor

This paper investigates three kinds of permanent-magnet arrays used in planar motors with polarity centers distributed in the lattices of a matrix. The magnetic field of every kind of magnet array is analyzed by analytical methods. First, we give a Laplace equation of magnetic scalar potential and a series of boundary conditions. Then, we derive the analytical expressions of magnet field strength and magnet flux density in the air gap of each kind of magnet array by the method of separation of variables. Finally, we compare the three types of magnet arrays on the basis of the analytical solutions.     

PVDF中空纤维滤膜的形态结构

用Ｌ－Ｓ相转换法制备了聚偏氟乙烯（ＰＶＤＦ）中空纤维不对称滤膜。铸膜液由聚合物、溶剂和添加剂组成。用电子显微镜（ＳＥＭ）考察了聚合物浓度、添加剂用量及种类对膜形态结构的影响。实验结果表明，聚合物浓度对膜形态结构有显著影响，当铸膜液中聚合物浓度较低时，无论用什么种类添加剂，都能形成大、且多的孔，但孔的形状随添加剂不同而异。当恒定聚合物浓度时，添加剂的用量对膜形态结构有很大的影响，但孔的大小及多少与添加剂含量的多少不成正比。     

铁钴钒软磁合金损耗谱的分形结构

研究了铁钴钒软磁合金的铁芯损耗，发现铁芯损耗谱具有分形结构。讨论了带材厚度和磁感应强度对分形维数Ｄｆ的影响。     

高性能各向异性Sm2Fe17Nx磁粉的制备

本文研究了高性能各向异性Ｓｍ２Ｆｅ１７Ｎｘ磁粉的制备工艺路线与工艺参数。优化了制备与工艺参数。已制备出磁性能达到：Ｂｒ＝１．３９Ｔ，Ｈｃｉ＝８５０ＫＡ／ｍ和（ＢＨ）ｍ＝２３６ＫＪ／ｍ＾３的各向异性Ｓｍ２Ｆｅ１７Ｎ２．８８磁粉，该磁粉的各向异性场ＨＡ达到２０Ｔ。