空分设备的酸性腐蚀及预防

以切换式换热器空分设备为例 ,分析了空分设备酸性腐蚀的原因、可能造成的危害 ,提出了预防措施。     

Ka-band solid-state pulsed Gunn oscillator and power combiner

GaAs Gunn diodes were fabricated for pulse source application at 8 mm wave band and operated with pulsewidths of 0.05 to 2.0 microseconds and duty cycles of 0.001 to 0.01. Peak pulse output power levels of 0.8–1.2W are achieved and the maximum available power is 1.6W with the highest efficiency of 6.5 percent. A simple and compact pulsed power combiner is also given in this paper.     

SAW滤波器简化衍射频响的计算方法

提出了由一个变迹ＩＤＴ叉指换能器和一个均匀ＩＤＴ组成的ＳＡＷ滤波器简化衍射频响的计算方法，即将均匀ＩＤＴ简化成单根指计算其衍射频响。该方法与未简化衍射频响的计算方法相比，计算量大为减小，前者约为后者的（Ｎ为均匀ＩＤＴ的指对数）。并给出了一个实例，用未简化与简化方法分别计算了其衍射频响，结果表明，两者符合得较好。     

The cyclotron autoresonance maser with a large-orbit electron ring in a dielectric-loaded waveguide

The cyclotron autoresonace maser with a large-orbit electron ring in a dielectric-loaded waveguide has been analyzed. The stability properties are investigated self-consistently on the basis of the linearized Vlasov-Maxwell equations. The numerical results show the growth rate increases when the electron rotating ratio increases. And the dielectric liner can greatly reduce the energy of the electron beam.     

An electromigration failure model for interconnects under pulsedand bidirectional current stressing

An electromigration failure model which can be used to project the electromigration lifetime under pulsed DC and AC current stressing has been reported. The experimental results indicate that different metallization systems (Al-2%Si, Al4%Cu/TiW, and Cu) show similar failure behaviors, which can be explained and predicted by this model. The pulsed DC lifetime is found to be longer than DC lifetime, and the AC lifetime is found to be very much longer. This recognition can provide significant relief to circuit designs involving metals carrying pulsed DC and AC currents, and allow a more aggressive design to improve circuit density and speed     

采用信息融合技术的IR／MMW复合导引头的目标跟踪

从误差测量环节入手，基于IR／MMW双模结构，采用信息融合处理技术提高其估计跟踪精度，最终达到降低制导误差，提高武器性能的目的，仿真结果验证了该方法的有效性。     

硼酸使掺铁铝酸锂发光增强的现象

在硼酸存在下合成了掺铁铝酸锂荧光体,研究了在不同温度下硼酸加入量对荧光体发光强度的影响,并通过X射线粉末衍射和粒度分析,初步探讨了发光增加的原因。     

超声变幅杆解析法设计的可靠性研究

本文提出了用有限元法验证变幅杆解析法设计的可靠性，对三种类型的变幅杆先作解析法设计；然后利用有限元分析软件ANSYS进行模态分析，确定了变幅杆的固有频率，计算了固有频率与工作频率之间的相对误差，以此来评价解析法设计的可靠性；并分析了影响解析法设计可靠性的两个基本因素。     

Olefins from conventional and heavy feedstocks: Energy use in steam cracking and alternative processes

Steam cracking for the production of light olefins, such as ethylene and propylene, is the single most energy-consuming process in the chemical industry. This paper reviews conventional steam cracking and innovative olefin technologies in terms of energy efficiency. It is found that the pyrolysis section of a naphtha steam cracker alone consumes approximately 65% of the total process energy and approximately 75% of the total exergy loss. A family portrait of olefin technologies by feedstocks is drawn to search for alternatives. An overview of state-of-the-art naphtha cracking technologies shows that approximately 20% savings on the current average process energy use are possible. Advanced naphtha cracking technologies in the pyrolysis section, such as advanced coil and furnace materials, could together lead to up to approximately 20% savings on the process energy use by state-of-the-art technologies. Improvements in the compression and separation sections could together lead to up to approximately 15% savings. Alternative processes, i.e. catalytic olefin technologies, can save up to approximately 20%.     

Microwave heating synthesis of HgS and PbS nanocrystals in ethanol solvent

A novel route was developed to prepare PbS and HgS nanocrystals in ethanol solvent in the presence of sodium hydroxide by microwave heating method. PbS and HgS nanocrystals were obtained with an average size of approximately 10 and 6 nm, respectively. In the reaction, mercury acetate and lead acetate were used as mercury and lead source; sulfur powder was employed as chalcogenide source. The products were characterized by X-ray powder analysis (XRD), transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS) and UV–Vis absorption spectroscopy. The probable mechanism was presented.