纳米铝酸锂粉体制备方法的研究

介绍了铝酸锂(LiAlO2)粉体的物理化学性能以及其目前的主要应用,特别是对LiAlO2粉体的多种合成方法进行了全面详细的介绍,比较了各种合成方法对粉体粒径及其分布、比表面积以及相组成等的影响,并展望了LiAlO2的潜在应用和发展.     

色素增感太阳能电池电解质的研究进展

介绍了色素增感太阳能电池基本结构及原理;综述了色素增感太阳能电池电解质的研究进展及离子液体在电解质中的应用;分析了电解质对色素增感太阳能电池的影响;展望了其应用前景.     

钢丝绳隔振器在大型机械设备的振动冲击隔离设计中的应用

通过对大型变流机组的隔振设计说明了钢丝绳隔振器的非线性特点，以及选用时如何考虑它的非线性影响，并使隔振系统在振动和冲击两方面同时满足要求。指出只有恰当地选用才能使钢丝绳隔振器的优势体现出来。还讨论了隔振器的非线性给机组运行、起动和停机操作带来的影响。     

ZBO(ZnO∶B)靶材烧结机理与特征的研究

用常压烧结方法，在1200℃-1350℃烧结不同含B量的掺硼氧化锌（ZBO）靶材。研究了掺杂量、烧结温度对ZBO靶材微观结构的影响。实验表明，随着烧结温度的增加。ZBO陶瓷的晶粒大小和密度逐渐增大。指出了由于B2O3的挥发，造成ZBO靶材的剩余含B量与掺B量的不符，要获得含定量B的ZBO就必须掺入大约2倍所需量的B2O3。     

Seeded growth of AlN crystals on nonpolar seeds via physical vapor transport

Seeded growth of AlN single crystals was demonstrated in an induction-heated, high-temperature reactor via a physical vapor transport (PVT) process. AlN seeds were prepared from a self-seeded boule containing large single-crystalline grains. Seeded growth was interrupted several times in order to refill the AlN powder source, and a dedicated process scheme was used to ensure epitaxial growth on the seed surface, after prior exposure to air. The growth temperatures were in the range of 2200–2300°C, and the reactor pressure was in the range of 500–900 torr of UHP-grade nitrogen during each growth run. Under these growth conditions, a seed (10 mm diameter) expanded at an angle of 45°, and a larger single crystal up to 18 mm in diameter was obtained. The as-grown surface had three facets, of which facet (1120) was smooth and featureless while the other two, (4150) and (2570), showed serrated morphologies. The double-crystal x-ray rocking curve and glow discharge mass spectroscopy analysis confirmed that the grown crystal was of high crystalline quality with low impurity incorporation.     

基于TOPSIS法的军工科研单位创新能力的综合评价

创新能力对一个军工科研单位来说是至关重要的。对军工科研单位的创新能力进行科学有效的评价变得越来越重要。但是现行的评价方法由于过分依赖主观评价而常不能准确反映军工科研单位的创新能力。为了减少主观因素的影响,引入理想点法(TOPSIS)建立了军工科研单位的创新能力的综合评价模型。该模型相比现行的方法更加客观科学,可以广泛地运用到军工科研单位创新能力的综合评价中。     

基于DS18B20可编程温度传感器的最小温控系统的设计与实现

以AT89C52单片机为开发平台,通过对单总线可编程温度传感器DS18B20的特性、内部结构、工作流程进行深入的研究,结合相应的软、硬件设计,在此基础上开发了一种多用途的最小温度控制系统。与传统装置相比,具有结构简单,测温精度高、应用面广等特点。     

降温水循环泵恒压供水变频改造

本文介绍了降温水循环泵恒压供水变频改造的特点及变频控制系统与DCS控制应用于降温水循环泵变频调速控制的基本情况。     

1200V MR D-RESURF LDMOS与BCD兼容工艺研究

提出具有p埋层的1200V多区双RESURF(MR D-RESURF) LDMOS, 在单RESURF(S-RESURF)结构的n漂移区表面引入多个p掺杂区,并在源区下引入p埋层,二者的附加场调制器件原来的场,以改善其场分布;同时由于电荷补偿,提高了漂移区n型杂质的浓度,降低了导通电阻.开发1200V高压BCD(BJT,CMOS,DMOS)兼容工艺,在标准CMOS工艺的基础上增加pn结对通隔离,用于形成DMOS器件D-RESURF的p-top注入两步工序,实现了BJT,CMOS与高压DMOS器件的单片集成.应用此工艺研制出一种BCD单片集成的功率半桥驱动电路,其中LDMOS,nMOS,pMOS,npn的耐压分别为1210,43.8,-27和76V.结果表明,此兼容工艺适用于高压领域的电路设计中.     

Effect of Cerium on Mechanical Performance and Electrical Conductivity of Aluminum Rod for Electrical Purpose

The effect of rare earth element Ce on mechanical performance and electrical conductivity of aluminum rod for electrical purpose were studied under industrial production condition. Using optical microscope, SEM, TEM, EDS and X-ray diffractometer, the microstructure and phase composition of aluminum rod were measured and analyzed. The results indicate that the content of rare earth element Ce is between 0.05%～0.16% in the aluminum rod for electrical purpose. Its tensile strength is enhanced to some extent. The research also discovers that the tensile strength is enhanced remarkably with impurity element Si content increases. Because influence of Si is big to the conductivity, the Si content should be controlled continuously strictly in the aluminum for electrical purpose. Adding rare earth element Ce reduces the solid solubility of Si in the aluminum matrix, and the negative effect of Si on the aluminum conductor reduces effectively. So the limit of in Si content in aluminum rod for electrical purpose can be relaxed moderately.