Probabilistic analysis of random contact force between geomembrane and granular material

A probabilistic method based on principle of maximum entropy was employed to analyze the randomness of contact force between geomembrane and granular material. The contact force distribution is exponential according to the proposed method and the grain size is the most important factor that affects the distribution of contact force. The proposed method is then verified by a series of laboratory experiments using glass beads and cobbles as granular material and a very thin pressure, indicating that film is firstly used in these experiments which give a reliable method to measure the contact force at each contact point.     

Simulation of hydrogen diffusion in welded joint of X80 pipeline steel

Hydrogen diffusion coefficients of different regions in the welded joint of X80 pipeline steel were measured using the electro-chemical permeation technique. Using ABAQUS software, hydrogen diffusion in X80 pipeline steel welded joint was studied in consideration of the inhomogeneity of the welding zone, and temperature-dependent thermo-physical and mechanical properties of the metals. A three dimensional finite element model was developed and a coupled thermo-mechanical-diffusion analysis was performed. Hydrogen concentration distribution across the welded joint was obtained. It is found that the postweld residual hydrogen exhibits a non-uniform distribution across the welded joint. A maximum equivalent stress occurs in the immediate vicinity of the weld metal. The heat affected zone has the highest hydrogen concentration level, followed by the weld zone and the base metal.Simulation results are well consistent with theoretical analysis.     

基于表面反应和扩散迁移控制的灰岩单裂隙渗流—溶解模型及其数值模拟

针对碳酸盐类可溶岩地区水电站坝址流场、化学场以及固相介质属性等随时间发生改变,从而对工程安全运行造成不利影响等问题,研究了灰岩地区地下水运移过程中各物理场间的相互作用,分析了影响灰岩溶解速率的两个因素,即表面反应控制和扩散迁移控制。在此基础上,建立了单裂隙中的渗流—溶解耦合模型,并进行数值求解。模拟结果表明,在垂直裂隙延伸方向,其溶蚀锋面为非齐整平面,而是呈似“虫洞”状非均一变化,而沿裂隙延伸方向即自上游侧向下游方向溶蚀程度逐渐减轻;而通过裂隙的流量呈现随时间逐渐增大的趋势,但变幅不大;根据流量求得的等效水力隙宽,其增幅和增长速率均小于实际平均隙宽;同时,化学场中Ca2+浓度的分布与裂隙开度变化具有相似性,不同时刻下上游侧反应速率R均大于下游侧。就反应机制而言,在初期均受表面反应控制,而随反应进行,位于上游补给区部位转为受扩散迁移控制,但在下游位置仍受表面反应控制。     

城市规划环评中公众参与的法律价值分析

用法律价值分析法研究城市规划环评公众参与制度,对我国城市规划环评制度的完善具有积极的意义。我国城市规划环评的公众参与制度是以提高环评的科学性、保障公民合法权益、维护环境正义为价值目标。然而现行制度中还存在着许多诸如立法层次低、参与主体不明确、参与方式有限、信息公开制度不健全、司法救济制度不完善等不利于实现前述法律价值目标的缺陷。为此,在法律实践中立法机关应当采取如转变法律价值观念、提高立法层次、明确参与主体、规范参与方式、健全信息公开制度、构建司法救济制度等措施来完善公众参与制度,以实现其应有的法律价值。     

三类镍单晶纳米材料的力学行为与性能

基于镶嵌原子势采用分子动力学方法研究了纳米镍单晶一维纳米丝、二维纳米薄膜和三维纳米固体的拉伸变形破坏过程和力学行为与性能,分析了3类典型纳米金属材料的本征应力、初始能量状态和变形机制以及破坏过程中的能量和应力变化,讨论了自由表面对纳米金属材料力学行为和性能的影响。模拟得到镍单晶纳米丝、薄膜和三维固体的弹性模量分别为145.45、186.6和122.03 GPa;断裂强度分别为22.293、21.08和19.98GPa;纳米丝和固体的破坏中出现短暂屈服,屈服强度分别为14.451和13.67 GPa,纳米薄膜的断裂无屈服。     

桩基倾斜度对低应变反射波法割桩损伤的影响

低应变反射波法用于已建高桩码头的桩身结构完整性检测时,需要割桩设置传感器和激振两个平台,因而对桩身产生一定损伤。运用大型通用有限元软件ANSYS对比了不同倾斜度桩基在完好状态和检测状态下桩身应力的变化,分析了有割桩损伤侧桩身应力集中程度。结果表明:割桩损伤会导致割桩处出现应力集中,其影响范围主要在割桩处1.0 m之内,桩身受力最不利截面从桩基与横梁联接处移至割桩平台处。割桩处的应力集中程度与桩基的倾斜度相关:正斜桩应力集中程度最高,直桩次之,反斜桩应力集中程度最低。因此,对于以船舶撞击力为控制荷载的高桩码头,在低应变检测桩数目的前提下可增大抽检桩中反斜桩的比例。低应变检测桩基后应对割桩处1.0 m范围内进行修补,以确保桩基水平承载性能。     

密实度对砂卵砾石料强度及变形特性的影响

为研究试样相对密度对砂卵砾石料强度及变形特性的影响,对4组不同相对密度的砂卵砾石料进行不同围压下的中型三轴固结排水剪切试验。试验结果表明:在试验的相对密度范围内,随着围压增大,相对密度小的试样应力应变曲线硬化特征逐渐明显,而相对密度大的试样无论围压大小,应力应变曲线都呈应变软化型;试样在剪切过程中均表现出不同程度的剪胀性;试样抗剪强度指标φ和φ0随着试样相对密度Dr增大而增大,c和Δφ随Dr增大而减小,并建立了试样抗剪强度与相对密度的函数关系式;割线模量、切线体积模量都随Dr增大而增大,可近似用线性关系表示。     

折板跌落式竖井设计约束条件研究

结合国内深层隧道排水工程-广州市东濠涌深层排水隧道,通过物理模型试验探讨了不同折板间距情况下折板竖井消能规律,并根据竖井中水流在折板间需满足的过流能力及充分消能的约束条件,研究了折板竖井消能的最大过流流量及稳定消能边界,提出了折板竖井设计应同时满足的约束条件以及折板通气孔的推荐位置。研究表明,在折板间距与折板宽度的比值小于0.408时,约束条件只有最大过流能力;当比值大于0.408时,只需考虑充分消能的约束条件。     

Group decision making based on incomplete multiplicative and fuzzy preference relations

The main aim of this paper is to investigate the group decision making on incomplete multiplicative and fuzzy preference relations without the requirement of satisfying reciprocity property. This paper introduces a new characterization of the multiplicative consistency condition, based on which a method to estimate unknown preference values in an incomplete multiplicative preference relation is proposed. Apart from the multiplicative consistency property among three known preference values, the method proposed also takes the multiplicative consistency property among more than three values into account. In addition, two models for group decision making with incomplete multiplicative preference relations and incomplete fuzzy preference relations are presented, respectively. Some properties of the collective preference relation are further discussed. Numerical examples are provided to make a discussion and comparison with other similar methods.