Monitoring actual performance of ground source heat pump system using GPRS-based data transmission: A case analysis in Tangshan

The energy efficiency monitoring is an essential precondition for ground source heat pump system’s controlling and energy saving operation. Based on the data monitoring applied in the school building, this work is focused on the parameters acquisition and operation analysis of the GSHP system in Tangshan. Results show the average COPs(coefficient of performance) are2.85 and 2.70 in summer and winter, respectively, and heat(cold) unbalance underground existed after whole year operation. The analysis of data also indicates that the direct borehole air-conditioning saved some power consumption obviously in the early stage of summer and energy saving of the GSHP system depended remarkably on its operation and management level. Besides the observation points of ground temperature are laid for a large-scale GSHP system, and the hydraulic balance of the pipes group needs to be concerned specially in safeguarding better reliability.     

Effects of COD to Phosphorus Ratios on the Metabolism of PAOs in Enhanced Biological Phosphorus Removal with Different Carbon Sources

To elucidate the phosphorus removal and metabolism under various COD / P ratio,a sludge highly enriched in PAOs was used to investigate the impacts of COD / P in batch tests under different carbon supply conditions. Acetate,propionate and a mixture of acetate and propionate at a ratio of 3 ∶ 1( COD basis) was used as carbon sources with the COD / P of 20,15,10 and 5. 0 g COD /gP,respectively. The minimum COD / P ratios for complete P removal were found to be 8. 24 g COD /gP for acetate,11. 40 g COD /gP for propionate and9. 10 g COD /gP for the 3 ∶ 1 mixture of acetate and propionate. Converted to a mass basis,all three cases had a very similar ratio of 7. 7 g VFA /gP,which represented a useful guide for operation of EBPR plants to identify possible shortages in VFAs. The trend in PHV accumulation during the anaerobic period along with the decrease of COD / P ratios suggested that,PAOs may use the TCA pathway for anaerobic VFA uptake to maintain the required NADH production with reduced glycogen degradation. During the aerobic phase,the glycogen pool was reduced but remained enough compared to the requirement for anaerobic VFA uptake,and the synthesis and degradation of glycogen was not the inhibition factor of PAOs.     

Non-Fourier heat conduction in a thin gold film heated by an ultra-fast-laser

Based on the dual-phase-lagging(DPL)heat conduction model,the Cattaneo-Vernotte(CV)model and the improved CV model we investigate the one-dimensional heat conduction in gold films with nano-scale thickness exposed to an ultra-fast laser heating.The influence of system parameters on the temperature field is explored.We find that for all the non-Fourier heat conduction models considered in this work,a larger Knudsen number normally leads to a higher temperature.For the DPL model,the large ratio of the phase lag of temperature gradient to the phase lag of heat flux reduces the maximum temperature and shortens the time for the system to reach its steady state.The CV model and the improved CV model lead to the similar thermal wave behavior of the temperature field,but the thermal wave speeds for these two models are different,especially for large Knudsen numbers.When the phase lag of temperature gradient is smaller,the difference between the DPL model and the improved CV model is not significant,but for the large phase lag of temperature gradient the difference becomes quite significant,especially for the large Knudsen number.In addition,the effect of the surface accommodation coefficient,which is a parameter in the slip boundary condition,on the temperature field of the gold film heated by ultra-fast laser pulses is investigated based on the DPL model.     

潜水搅拌器安装角度对搅拌效果的影响

研究潜水搅拌器水平安装角度对搅拌池内流场的影响,建立不同的水平安装角度,通过Fluent对潜水搅拌机的搅拌槽内流场进行三维数值模拟,得出不同方案的速度分布情况.利用UDF模块,分别计算流场中流速达到搅拌效果的有效搅拌流体体积及其占整个流场体积的百分比,通过比较,选出最优的潜水搅拌器安装方案,提出了评价潜水搅拌器效能及其安装布置优劣的新方法——有效搅拌域法,利用此方法,使潜水搅拌器的搅拌效果分析更加准确.     

Thin-film composite forward osmosis membrane prepared from polyvinyl chloride/cellulose carbamate substrate and its potential application in brackish water desalination

Synthesized by the reaction between α-cellulose and m-tolyl isocyanate (MTI), cellulose carbamate (CC) was blended with polyvinyl chloride (PVC) to fabricate substrates for thin-film composite (TFC) forward osmosis (FO) membranes. The introduction of CC into substrates improved both membrane structure and performance. The substrates exhibited higher porosity and hydrophilicity, and better connective pore structure; while rejection layer exhibited better morphology but limited cross-linked degree decrease after the introduction of CC. According to the results, the CC blend ratio of 10% was the optimal ratio. With this blend ratio, the TFC-10 membrane presented favorable water permeability (1.86 LMH/bar) and structure parameter (337 μm), which resulted in excellent FO performance (water flux with a value of 40.40 LMH and specific salt flux with a value of 0.099 g/L under rejection layer faces draw solution [DS] mode when 1 M NaCl and deionized water were utilized as DS and feed solution). In addition, the TFC-10 membrane showed good water flux and low-sulfate ion leakage in the potential application of brackish water desalination.     

Effect of electric field on storage modulus of dielectric composites

DCs composed by dielectric particles and elastomer matrix present electric field dependent deformation. Viscoelasticity dominates their electric field response, which has to be considered in their applications. Although the influence of strain amplitude and oscillation frequency on the viscoelasticity of DCs has been investigated, the effect of electric field has been seldom studied. In this study, DCs were prepared by dispersing TiO₂ particles with different concentrations and different distributions within silicone rubbers. The areal strain and the storage modulus of the DCs under different electric fields were tested. The results indicated the electric field has significant influence on the storage modulus of the DCs. Such an electric field dependent storage modulus is more significant for the DCs with higher particle fraction, or with aligned distributed particles. The enhanced electrostatic interaction between the adjacent particles by applying electric field is responsible for the phenomena.     

Photocatalytic oxidation activity of titanium dioxide film enhanced by Mn non-uniform doping

1 Introduction Heterogeneous photocatalysis is an effective technique for reducing the concentration of pollutants at low concentration. It has been demonstrated that almost all organics can be oxidized to generate carbon dioxide, water and simple mineral…     

Supervised Distance Preserving Projections: Applications in the quantitative analysis of diesel fuels and light cycle oils from NIR spectra

In this work, we discuss a recently proposed approach for supervised dimensionality reduction, the Supervised Distance Preserving Projection (SDPP) and, we investigate its applicability to monitoring material's properties from spectroscopic observations. Motivated by continuity preservation, the SDPP is a linear projection method where the proximity relations between points in the low-dimensional subspace mimic the proximity relations between points in the response space. Such a projection facilitates the design of efficient regression models and it may also uncover useful information for visualisation. An experimental evaluation is conducted to show the performance of the SDPP and compare it with a number of state-of-the-art approaches for unsupervised and supervised dimensionality reduction. The regression step after projection is performed using computationally light models with low maintenance cost like Multiple Linear Regression and Locally Linear Regression with k-NN neighbourhoods. For the evaluation, a benchmark and a full-scale calibration problem are discussed. The case studies pertain the estimation of a number of chemico-physical properties in diesel fuels and in light cycle oils, starting from near-infrared spectra. Based on the experimental results, we found that the SDPP leads to parsimonious projections that can be used to design light and yet accurate estimation models.