基于FPGA的ASI信号接收与发送的实现

提出了一种用FPGA芯片代替Cypress公司的CY78933和CY78923芯片来实现ASI信号接收与发送的方案，详细阐述了DVB—ASI接口的硬件组成与FPGA实现，该接口符合DVB—ASI的接口规范，可实现270Mbps的信号传输，已经得到实际运用。     

单片LCoS光学引擎中彩色LED照明系统设计

LCoS光学引擎作为整个背投的一个要组成部分，其照明系统显著地影响着LCoS背投的性能。详细分析了影响照明效果的各个因素，并利用ZEMAX软件设计出了单片LCoS光学引擎中基于彩色LED光源的照明系统，该系统能达到较好的亮度和均匀性，满足整个光机系统的成像要求。     

光学材料的激光微加工研究进展与应用前景

综述了国内外在光学材料激光微加工方面的研究成果和应用状况，并展望了其发展前景。     

APPLICATION OF COMPUTER NUMERICAL METHOD IN PORE STRUCTURE CALCULATION

This paper compares the results Of calculat-ing pore structure and graphing differential and integralpore size distribution by hand and Computer,and presents thatlagrangian interpolation uesd by calculating pore structure issuitable and reliable.     

DIRECT RESONANCE OF TURBULENT BOUNDARY LAVER OVER COMPLIANT WALLS

１．　ＩＮＴＲＯＤＵＣＴＩＯＮＴｈｅｍａｉｎｇｏａｌｏｆｔｈｉｓｐａｐｅｒｉｓｔｏｅｘｐｌｏｒｅｔｈｅｐｏｓｓｉｂｉｌｉｔｙｔｏｌｅａｒｎｍｏｒｅａｂｏｕｔｔｈｅｍｅｃｈａｎｉｓｍｏｆｔｕｒｂｕｌｅｎｔｂｏｕｎｄａｒｙｌａｙｅｒｆｌｏｗｉｎｔｅｒａｃｔｉｏｎｓａｎｄｉｔｓｅｆｆｅｃｔｓｏｎｃｏｍｐｌｉａｎｔｗａｌｌｐｅｒｆｏｒｍａｎｃｅ．Ｔｈｅｒｅａｒｅｃｅｒｔａｉｎｐｒｅｒｅｑｕｉｓｉｔｅｃｏｎｄｉｔｉｏｎｓｔｏｆｕｒｔｈｅｒｔｈｅｓｔｕｄｙｏｎｔｈｅｍｅｃｈａｎｉｓｍ，ｉ．ｅ．ｔｈｅｃｏ…     

高压脉冲放电处理含氰废水的影响因素探讨

焦化废水中含有大量的氰化物,必须采取有效措施进行去除,传统去除方法运行成本高、操作复杂。提出了用高压毫微秒脉冲产生的非平衡等离子体处理含氰废水的方法,对其影响因素pH值、放电时间、气流量、放电条件等进行了大量的实验研究,结果表明:溶液初始pH值为9.09,放电2 h,放电电压46 kV时氰化物的去除率最高可达93.2%,氰化物质量浓度可降至0.26 mg/L。实验对比了放电与不放电氰化物的去除效果:相同条件下放电后氰化物的去除率大大提高,为焦化废水中氰化物的去除提出了一种新的方法。     

Electrical conductivity and gas sensitivity of Zn-Sb-O thick films

The thick film of Zn-Sb-O was prepared by coating the paste of nanoparticles mixture (Sb₂O₃:ZnO=1:3) on the alumina substrate, followed by sintering at 500-900 °C for 2 h in air. The electrical resistance and gas-sensing properties to benzene, alcohol and acetone of Zn-Sb-O films were found to be dependent on the change of phase structure caused by sintering temperature.     

Entropy generation and thermodynamic optimization of fully developed laminar convection in a helical coil

The present paper analyses the entropy generation of the fully developed laminar convection in a helical coil with constant wall heat flux and presents the optimal design based on the minimum entropy generation principal. The important design parameters, including Reynolds number (Re), coil-to-tube radius ratio (δ) and nondimensional coil pitch (λ) are varied to investigate their influences on the entropy generation. The results presented in this paper cover Re range of 100–10,000, δ and λ range from 0.01 to 0.3. Compared with Re and δ, the coil pitch λ is found to have minor influence on the entropy generation. For a demonstrated case, the minimum entropy generation occurs in the range bounded by Re from 2271 to 4277 and δ from 0.17 to 0.3, within which the irreversibility of the system is lowest and the system performance would be optimum. The details show that there is an optimal Re for a helical coil with a fixed δ; meanwhile for a helical coil flow with a specified Re, the smaller δ should be selected when the Re is larger than 5000, and the larger δ should be selected when the Re is less than 5000. These results provide worthwhile information for heat exchanger designers to find the optimal helical coil design from the viewpoint of the thermodynamic second law.     

基于RDP算法的RAID6实现

正确高效的RAID6算法是RAID6磁盘阵列系统可靠运作的保障,算法的实现效率将直接影响整个系统的性能。笔者首先对RAID6的现有可行算法进行了分析,然后详细介绍了基于RDP算法的RAID6实现,最后用权威的Benchmark对该实现机制做出评估。