基于1553B和外部FLASH实现星上FPGA配置

太阳辐射监测仪作为某卫星载荷之一,其控制系统主要由DSP+FPGA组成,文章利用1553B和外部Flash实现了系统上电后自动配置FPGA;首先,利用1553B通讯芯片上传FPGA和DSP代码到外部RAM,并通过DSP烧写程序分别烧写到Flash的合理区域;系统上电后,DSP从Flash 0x0地址运行,初始化后运行FPGA配置程序,实现FPGA的动态配置;避免了FPGA跑飞后需要重新上电和归零,提高了系统的可靠性;省去了FPGA专用配置EPROM芯片,简化结构,降低了系统成本;实践证明,FPGA加载时间约2分钟,可定时加载或命令控制加载,该方法简单实用,适合星上载荷使用。     

Optimal configuration of Energy-Efficient Ethernet

The IEEE 802.3az standard provides a new low power mode that Ethernet network interfaces can use to save energy when there is no traffic to transmit. Simultaneously with the final standard approval, several algorithms were proposed to govern the physical interface state transition between the normal active mode and the new low power mode. In fact, the standard leaves this sleeping algorithm unspecified to spur competition among different vendors and achieve the greatest energy savings. In this paper, we try to bring some light to the most well known sleeping algorithms, providing mathematical models for the expected energy savings and the average packet delay inflicted on outgoing traffic. We will then use the models to derive optimum configuration parameters for them under given efficiency constraints.     

小口径离轴抛物面反射镜挠性支撑设计分析

关于反射镜支撑稳定性优化设计问题,离轴抛物面反射镜作为空间光学遥感器的重要光学元件,面形精度直接影响遥感器性能。针对反射镜所处环境,组件一阶频率要求高,设计了一种反射镜背部中心单点挠性支撑结构,并利用拓扑优化技术对反射镜进行了轻量化设计。为了结构设计的合理性,采用有限元技术对反射镜组件进行了模态分析、结构强度分析、谐响应分析及热环境分析。分析结果表明:反射镜在重力作用下最大面形误差RMS=1.16nm;在±10℃温度载荷作用下最大面形误差RMS=11.46nm;反射镜组件一阶频率为574.19Hz。使挠性支撑结构具有良好的静、动态特性和热尺寸稳定性,满足反射镜面形要求。     

Ultrasonic crack characterization via a constrained inversion algorithm

The Kirchhoff approximation is used to show that the time domain impulse response of an isolated flat crack can be given a simple geometrical interpretation in terms of the derivative of a projected length function. For an elliptical crack, this derivative can be obtained explicitly to yield the two edge-diffracted waves which originate from the flashpoints of the crack. An explicit coordinate invariant expression is obtained from this elliptical crack solution which relates the time difference, t, between the arrival of these edge-diffracted waves and the crack size and orientation. Previously, we have proposed that this expression, together with t measurements in different scattering directions, could be used in a regression analysis as the basis for performing a constrained inversion of crack scattering data (i.e., where we attempt to obtain the best equivalent flat elliptical crack that fits the scattering measurements). Here we will demonstrate some results of applying the proposed algorithm using noisy synthetic data. The sensitivity of the results to both, number of measurements and transducer orientation, will be discussed.     

基于自动选取最佳阈值的X光图像快速分割方法*

为实现对数字X光图像进行快速分割,提出一种针对直方图的包络特征进行处理的新方法.该方法采用分水岭算法对数字X光图像的直方图一维信号进行处理.首先计算出图像的直方图,然后对直方图进行形态学滤波,提取出直方图的包络.在此基础上对直方图的包络采用分水岭算法自动提取出最佳阈值.用提取出的阈值进行基于阈值的初步分割,然后进一步采用基于标记的分水岭算法对初步分割的二值图像作进一步分割.通过实验表明,采用该方法可以有效地分割大幅X光图像.     

H-PSMA/PVA/PP复合膜的制备及油-水乳液分离性能

通过两步法对聚丙烯（PP）膜进行了亲水改性:首先,通过在碱性条件下水解苯乙烯-马来酸酐共聚物（PSMA）制备了水解的苯乙烯-马来酸酐共聚物（H-PSMA）;然后,以聚乙烯醇（PVA）为亲水性改性剂,戊二醛（GA）为交联剂,将H-PSMA/PVA/GA复合材料浸涂在PP基底膜上,制备了亲水性水解苯乙烯-马来酸酐共聚物/聚乙烯醇/聚丙烯（H-PSMA/PVA/PP）复合膜。利用傅里叶变换红外光谱（FT-IR）分析表征了H-PSMA和H-PSMA/PVA/GA的结构;通过测试复合膜表面的静态接触角,探究了PVA和GA含量及成膜溶液的质量浓度等对膜表面润湿性能的影响;最后,测试了复合膜的油水分离效率和重复利用率。结果表明:当GA、PVA和H-PSMA的质量比为0.225∶1∶1,成膜溶液的质量浓度为0.03 g/mL时,所制备的H-PSMA/PVA/PP复合物膜对水包油乳液（O/W）表现出优异的分离性能,初次油水分离效率为99.40%,当重复分离10次后,油水乳液的分离效率仍达到98.83%以上。该复合膜的制备工艺具有安全性好、成本低和环境友好的特点。     

Co和Cu薄膜电学特性和连续性特征的判据

采用离子束溅射沉积了不同厚度的Co膜和Cu膜,利用四电极法测量了薄膜的电阻率,从而得到了Co膜和Cu膜的电导率随薄膜厚度的变化关系。实验结果表明,Co膜和Cu膜的电学特性都具有明显的尺寸效应。比较了同时考虑表面散射和晶界散射的电导理论得到的电导率公式与实验结果,不同薄膜厚度电导率的理论结果与实验结果符合较好。提出了厚度作为金属薄膜生长从不连续膜进入连续膜的一个特征判据,并利用原子力显微镜(AFM)观测了膜厚在特征厚度附近的Co膜和Cu膜的表面形貌。     

GRIP管混凝土组合结构压弯构件非线性全过程分析

本文应用细观力学、经典层板理论、平截面假定、FRP约束混凝土本构模型及数值积分对GFRP管混凝土组合结构压弯构件进行了非线性全过程分析。通过理论计算发现GFRP管混凝土组合结构能有效地提高构件的承载力，且构件具有良好的变形能力。FRP壳体参与承载且有效地约束混凝土的变形，显著提高核心混凝土强度和变形能力。文中讨论了轴压比、长细比、径厚比、混凝土强度等级、纵筋配筋率、铺层角变化对极限水平荷载和极限水平位移的影响，从而得到了一些有益的结论。     

Incorporating mutation scheme into krill herd algorithm for global numerical optimization

Recently, Gandomi and Alavi proposed a robust meta-heuristic optimization algorithm, called Krill Herd (KH), for global optimization. To improve the performance of the KH algorithm, harmony search (HS) is applied to mutate between krill during the process of krill updating instead of physical diffusion used in KH. A novel hybrid meta-heuristic optimization approach HS/KH is proposed to solve global numerical optimization problem. HS/KH combines the exploration of harmony search (HS) with the exploitation of KH effectively, and hence, it can generate the promising candidate solutions. The detailed implementation procedure for this improved meta-heuristic method is also described. Fourteen standard benchmark functions are applied to verify the effects of these improvements, and it is demonstrated that, in most cases, the performance of this hybrid meta-heuristic method (HS/KH) is superior to, or at least highly competitive with, the standard KH and other population-based optimization methods, such as ACO, BBO, DE, ES, GA, HS, KH, PSO, and SGA. The effect of the HS/FA parameters is also analyzed.