CSAa黏弹性表面活性剂压裂液的研制

用化学试荆长链烷基季铵盐CSAa制备了两种VES压裂液并研究了相关性能，其组成（CSAa／水杨酸钠／氯化钾／正丁醇，以g／dL为单位）如下：1．0／0．3／1．0／0．2；2．0／0．6／0．5／0．1。在耐温性测定中，1．0g／dL CSAa压裂液的黏度由30℃时的75．0mPa·s降至50℃时的37．5mPa·s；2．0g／dL CSAa压裂液的黏度由40℃时的225mPa·s逐渐降至55℃时的110mPa·s，再降至60℃时的65．0mPa·s.在1701／s剪切2h后，剪切温度为42℃时1．0g／dL CSAa压裂液的黏度下降26％，剪切温度为53℃时2．0g／dL CSAa压裂液黏度下降9％。陶粒沉降速度测定结果表明，40℃、42℃时的1．0g／dL CSAa压裂液（黏度分别为60和54mPa·s）和50℃、53℃时的2．0g／dLCSAa压裂液（黏度分别为180和145mPa·s）携砂性能良好，而45℃、50℃时的1．0g／dLCSAa压裂液和55℃、60℃时的2．0g／dL CSAa压裂液，携砂性能则较差或很差。认为VES压裂液的携砂性能来源于棒状胶束网络，并不全由压裂液黏度决定。还考察了VES压裂液的破胶性能。图1表2参5。     

HPLC–MS analysis of the green food colorant sodium copper chlorophyllin

Five commercial samples of sodium copper chlorophyllin, a green food colorant, were analysed by high-performance liquid chromatography (HPLC) using diode-array detection (DAD) and mass spectrometry (MS). Some of the constituents were identified using authentic standards, whereas others were identified tentatively based on their absorption spectra and mass data. The composition of three of the samples was very similar, whereas the other two were quite different. In the three former samples, the three largest peaks could be assigned to Cu chlorin e₆, Cu chlorin p₆, and Cu isochlorin e₄. In one of the two other samples, these three compounds were also among the largest peaks, whereas Cu chlorin e₆ was a small peak in the last sample and Cu chlorin p₆ was absent altogether. Porphyrins were also present in the samples, while except in one of the samples chlorins derived from chlorophyll b were largely absent.Industrial relevanceSodium copper chlorophyllin is a green food colorant made from chlorophyll. Sodium copper chlorophyllin is made by saponifying chlorophyll and coppering the resulting product. This processing leads to a complex mixture of compounds. An analytical method was developed that can be used to identify many of these compounds and show the extent of coppering and degradation of sodium copper chlorophyllin, which may be used industrially to optimize the production of sodium copper chlorophyllin.     

Thermal emission properties of Al2O3/Er3Al5O12 eutectic ceramics

The mechanical properties and thermal stability of the Al₂O₃/Er₃Al₅O₁₂ (EAG) eutectic ceramics have been investigated at very high temperature. The emissive properties of this eutectic ceramics have also been measured and its possibilities of application to an emitter have been discussed. The present eutectic ceramic has excellent high-temperature strength characteristics, showing that tensile yielding stress is approximately 300 MPa at 1650 °C and superior thermal stability at 1700 °C in an air atmosphere. The present material shows strong selective emission bands at wavelength 1.5 μm due to Er³⁺ ion. The emission bands of this material are nearly coincident with the sensitive region of GaSb PV cell, therefore, the Al₂O₃/EAG eutectic ceramic can be regarded as one of the promising emitter materials in TPV systems.     

Design of Millimeter Wave TFMS Bandpass Filter

In this paper, a Ka-band thin film microstrip line(TFMS) filter with multi-layer structure on silicon substrate is introduced. The simulated results show that it is possible to design compact millimeter-wave filter on silicon substrate with process compatible to current VLSI technology.     

Improved method for HgI2 crystal growth and detector fabrication

Instead of the temperature oscillation method (TOM), a modified vapor growth method was applied in this paper to grow large HgI₂ crystals with fewer lattice defects by providing a relatively stable temperature field during growth. And a new processing technique of HgI₂ crystals was developed for detector fabrication by merging solution string-sawing and hand-cleaving. The lattice deformations caused during cleaving were reduced greatly by eliminating passivated layers on the sawed crystal platelets before cleaving.     

The influence of the alloying elements upon the transformation kinetics and morphologies of ferrite plates in alloy steels

A series of Fe-C-X and Fe-C-X₁-X₂ alloys in which X, X₁ and X₂ either raise or depress the activity of C iny were investigated by autodilatometer, optical microscopy, and transmission electron microscopy (TEM) to reveal the relations among the chemical composition, transformation kinetics, and morphology of ferrite plates. The incubation time of austenite decomposition at the nose temperature in the time-temperature-transformation (TTT) diagrams, the concentration of C in y in contact with theα/gg boundary, and the growth rate of ferrite were evaluated to estimate the magnitude of the solute drag-like effect (SDLE) for the different alloying elements used. All the results are consistent qualitatively with the SDLE hypothesis. This article is based on a presentation made at the Pacific Rim Conference on the “Roles of Shear and Diffusion in the Formation of Plate-Shaped Transformation Products,” held December 18-22, 1992, in Kona, Hawaii, under the auspices of ASM INTERNATIONAL’S Phase Transformations Committee.     

The experiment about a plane mirror cavity with dielectric tubes

This paper introduce the experiment about a new type of quasi-optic cavity Making a experimental model, measuring all parameters of the cavity, giving experiment results. It shows that theoritical research in reference[1] is correct Its results coincide with theory. At same time, it also indicates the cavity is hopeful device in MMW.     

Fractals by Multigenerators

Abstract: Non-classical fractals generated by many generators are of interest. Random fractals caused by the random action of given generators and by random generrrtors are discussed The generators may have different scales. The fractal spectral function, the generalized fractal dimensions and scaling index are derived explicitly. Examples include the cracking patterns of concrete mix.     

高含酸性气碳酸盐岩气藏流体敏感性实验研究

对川东北雷口坡组、嘉陵江组、飞仙关组、长兴组高含H，S及032的碳酸盐岩储层流体敏感性进行了实验研究，结果表明岩样速敏损害弱～强，水敏和盐敏损害中偏弱～极强，碱敏损害严重。岩石学分析揭示，川东北高含酸性气碳酸盐岩储层发育伊利石、微晶石英、白云石、方解石、硫化钙等潜在损害物质。钻井完井液侵入会破坏储层各物质间的原始动态平衡，诱发储层损害。主要损害机理为：①储层流体pH增加引起黏土矿物以及微晶石英失稳；②碱液与微晶石英、长石、白云石反应生成硅酸盐、高岭石、水镁石等新矿相；③流体矿化度改变可降低伊利石微粒间的连接力；④硫化钙水解产生OH^-，过量的OH-与Ca^2＋结合形成氢氧化钙沉淀；⑤储层含水饱和度和流体离子浓度改变，致使焦沥青脱附并在储层深部沉积；⑥硬石膏水化膨胀、分散运移。针对该气藏损害机理，可采用屏蔽暂堵技术以形成优质滤饼，有效降低储层流体敏感性损害。图5表2参10。     

砂岩储集层微波加热产生微裂缝的机理及意义

微波加热无需介质传热,具有升温速度快、热惯性小、选择性加热、穿透力强、过程易于控制等优点,已被试验性地应用于石油开采中。但有关微波加热对储集层岩石微观结构影响的研究还很缺乏,限制了该项技术在油气开采领域的广泛应用。通过实验手段研究了微波加热前后砂岩岩样微观结构变化、微裂缝产生机理及特征。结果表明,砂岩在微波加热过程中容易产生微裂缝,且不同岩石的微波加热致裂机理不尽相同,主要包括:矿物失水收缩、颗粒粒间开裂和颗粒内部开裂,低渗透致密砂岩刚性颗粒的粒内开裂作用显著。微波加热产生的微裂缝具非定向特征,即使在应力的作用下有一部分裂缝会发生闭合,但仍有大量微裂缝可以起到增加渗透率的作用。井下微波加热的致裂作用有助于改善近井区域渗流能力,提高低渗透油气藏的开采效率。图4参15