Comparison of mass transfer efficiency in horizontal rotating packed beds and rotating biological contactors

In this study, the mass transfer efficiencies of a novel horizontal rotating packed (h‐RPB) bed and the conventional disc‐type rotating biological contactor (RBC) were studied at four speeds and seven submergences. Pall rings of two different sizes (25, 38 mm), superintalox saddles and a wiremesh spiral bundle were used as packings in the h‐RPB. Volumetric gas–liquid mass transfer coefficients were determined by unsteady state absorption of atmospheric oxygen in de‐aerated water. Power consumption per unit liquid volume has been found for all geometries tested. The oxygen transfer efficiency values for the h‐RPB were found to be 2–5 kg kWh^?1 and for the disc RBC were found to be 1–2 kg kWh^?1. The performance of the h‐RPB was also compared with other gas–liquid contactors such as surface aerators. The study proves that the h‐RPB is a energy efficient alternative to conventional contactors. Copyright © 2005 Society of Chemical Industry     

Drying Characteristics of Barley Grain Dried in a Spouted-Bed and Combined IR-Convection Dryers

A study was performed to determine the drying characteristics and quality of barley grain dried in a laboratory scale spouted-bed dryer at 30, 35, 40, and 45°C and an inlet air velocity of 23 m/s^-1, and in an IR-convection dryer under an infrared radiation intensity of 0.048, 0.061, 0.073, and 0.107 W cm^-2 at an air velocity of 0.5 m/s^-1. The results show that the first, relatively short, phase of a sharp decrease in the drying rate was followed by the phase of a slow decrease. The time of barley drying depended on temperature of inlet air in a spouted-bed dryer and on radiation intensities in an IR-convection dryer. Barley drying at 45°C in a spouted-bed dryer was accompanied by the lowest total energy consumption. The average specific energy consumption was lower and the average efficiency of drying was higher for drying in a spouted-bed dryer. The effective diffusivities were in the range 2.20-4.52 × 10^-11 m² s^-1 and 3.04-4.79 × 10^-11 m²/s^-1 for barley dried in a spouted-bed and in an IR-convection dryer, respectively. There were no significant differences in kernel germination energy and capacity between the two drying methods tested.     

大液相负荷下斜孔塔板的流体力学性能

针对大液相负荷气液传质操作 ,通过冷模实验 ,重新确定了普通斜孔塔板的液体力学性能 ,并给出了新的关联式。同时基于普通正排斜孔塔板在大液量操作条件下压降大 ,泄漏和雾沫夹带严重等缺点 ,沿用梯形导向浮阀的思想 ,提出了变正排为斜排的改进方案 ,并在相同条件下对两者的液体力学性能进行初步比较。证明了斜排斜孔塔板是一种适合大液体处理量且操作弹性较宽的塔板     

Study of Hydrodynamics,Mixing and Gas‐Liquid Mass Transfer in a Split‐Rectangular Airlift Reactor

Global hydrodynamic characteristics, liquid mixing and gas‐liquid mass transfer for a 63 L split‐rectangular airlift reactor were studied. Correlations for gas holdup and overall liquid circulation velocity were derived for the air‐water system as a function of the specific power input; these were compared to data and correlations for reactor volumes between 4.7 L and 4600 L. A partial recirculation of small bubbles in the riser was observed when U_gr > 0.03 m/s, which was attributed to the use of a single‐orifice nozzle as the gas phase distributor. The dimensionless mixing time and the overall axial dispersion coefficient were nearly constant for the range of gas flow rates studied. However, values of K_L/d_B were greater than those reported in previous studies and this is caused by the partial recirculation of the gas phase in the riser. While scale effects remain slight, the use of a gas distributor favouring this partial recirculation seems adequate for mass transfer in split‐rectangular airlift reactors.     

QH-2型扁环填料的流体力学和传质性能研究

在内径60 0填料塔中 ,用空气 富氧水系统对3 8和5 0QH 2型扁环填料的流体力学和传质性能进行了研究 ,得出计算其压降、液泛气速和传质单元高度的关联式。并与3 8鲍尔环、5 0鲍尔环和3 8环矩鞍填料进行了比较 ,结果表明 ,QH 2型扁环具有优良的流体力学和传质特性。     

内构件存在时提升管内流动及颗粒混合行为研究

he hydrodynamics and solids mixing behavior in a riser with blunt internals are studied. A uniform radial distribution for solids fraction and particle velocity achieves near the internals. The turbulent velocity of particles near the wall increases with the addition of the internals, with the lateral solids mixing enhanced significantly. Probability density distribution of particle velocity is bimodal in the riser with internals, which is similar to that in the conventional riser, indicating that no significant difference in the micro flow structure exists between the riser with internals and the conventional riser. At the same time, the axial solids mixing behavior changes insignificantly with the addition of internals. These results indicate that the micro flow structure in the riser is very stable, which changes insignificantly with the change of the bed structure.     

无资料小流域地区可能最大洪水计算研究

本文采用当地推理公式法,借鉴相近地区相似水文特征的洪峰流量经验公式估算无资料小流域河道最大可能洪水,用恒定流水面线法计算某核电厂厂址处由最大可能洪水产生的洪水位。用水力学方法计算可能最大洪水为既考虑河道内区间回水情况,同时也反映了河道的水力学特性,计算结果更接近实际情况。     

Optimal setpoint chasing in dynamic positioning of deep‐water drilling and intervention vessels

Conventional controller designs for dynamic positioning of ships and floating marine structures have so far been based on the principle on automatic positioning in the horizontal‐plane about desired position and heading co‐ordinates defined by the operator. A three degrees‐of‐freedom multivariable controller either of linear or nonlinear type, normally with feedback signals from surge, sway and yaw position and velocities, has been regarded as adequate for the control objective. For floating structures with small waterplane area such as semi‐submersibles, feedback from roll and pitch angular rotation velocity may also be included to avoid thrust‐induced roll and pitch motions that are caused by the hydrodynamic and the geometrical couplings between the horizontal and vertical planes. However, for certain marine operations this control philosophy may not be the most appropriate approach ensuring safety and cost effectiveness. For drilling and work‐over operations the main positioning objective is to minimize the bending stresses along the riser and the riser angle magnitudes at the well head on the subsea structure, and at the top joint as well. A positioning control strategy solely based on manual setting of the desired position co‐ordinates may not be the most optimal solution for these applications. In this paper a new hybrid dynamic positioning controller, that also accounts for riser angle offsets and bending stresses is proposed. It is shown that a significant reduction in riser angle magnitude can be achieved. Simulations with a drilling semi‐submersible demonstrate the effect of the proposed control strategy. Copyright © 2001 John Wiley & Sons, Ltd.     

Current variability in a wide and open lacustrine embayment in Lake Geneva (Switzerland)

Field measurements and numerical simulations were used to determine the effects of dominant meteorological conditions on the hydrodynamics of a wide (aspect ratio ~ 2), relatively deep (seasonally stratified) and open lake embayment (Vidy Bay, Lake Geneva). A three-dimensional hydrodynamic model (Delft3D-FLOW) was employed to simulate flow in the lake. High-resolution maps of wind, temperature and humidity (over the lake) were applied as input to drive the model. Because wind was the main force driving flow in the lake, currents in the embayment were investigated systematically for different wind conditions and seasonal stratification. Satisfactory model validation was achieved using drifter and moored measurements within the embayment. Markedly different circulation patterns were measured within the embayment, with the transition from one pattern to another occurring abruptly for small changes in wind direction. These distinct patterns resulted from relatively small changes in the large gyre of Lake Geneva's main basin, especially the angle between the current in front of the embayment and the embayment shoreline. The boundary between the embayment and the pelagic zone was defined by the largest gyre within the embayment. This study shows that, (i) in a large lake, complex current patterns can occur even within a minor embayment, and (ii) that these patterns can transition rapidly over a small range of wind directions. Near-shore gyre can occur for lengthy periods, which has implications for flushing of discharges within the embayment.     

TRANSPORT OF BICOMPONENT CONTAMINANT IN FREE-SURFACE WETLAND FLOW

This paper presents a theoretical analysis of a pulsed bicomponent contaminant emission into a free-surface wetland flow.The basic equations are for the bicomponent contaminant transport in the wetland flow under the combined action of advection,mass dispersion,and ecological reaction at the phase averaged scale.The effect of the ecological reaction is separated from the hydro-dynamic effect via a set of widely used transforms.The analytical solution for the evolution of the depth-averaged concentration is rigorously derived,with a limiting case covering the known solution for the single component contaminant transport.It is found that the depth-averaged species concentration of the bicomponent contaminant can approach an equilibrium state determined by the distri-bution coefficient.