膜片式流量调节阀

介绍了用于油田开采工艺的膜片式流量调节阀的结构及其特点,分析了调节阀出口压力、进口压力对其流量的影响。受力分析和现场使用表明:该阀流量恒定精度(即恒流偏差)取决于膜片有效面积S与阀心下端有效面积S′之比,此值为12,其恒流比偏差为0·03,说明该阀的流量恒定精度高;该阀不易被杂质卡死,稀油中直径1mm的砂粒能顺利通过,而不影响阀的功能;膜片式流量调节阀是没有高加工精度要求的部件,普通车床即可生产,因此造价较低。     

鸭池河水电站压力钢管外压稳定性设计

采用解析法和半解析有限元法分别对鸭池河水电站埋藏式加劲压力钢管进行外压稳定性计算。在计算分析过程中,考虑了初始缺陷因素对埋藏式加劲压力钢管抗外压稳定性的影响,使得计算结果更加接近于工程实际;从而为埋藏式加劲压力钢管的外压稳定性计算提出了一种更加行之有效的方法。     

The Role of Metastable Atoms in a Homogeneous Atmospheric Pressure Barrier Discharge in Helium

A one-dimensional fluid model for homogeneous atmospheric pressure barrier discharges in helium is presented by considering elementary processes of excitation and ionization including a metastable atom effect. Using this model we investigate the behaviours of the helium metastable atoms in discharges as well as their influence on the discharge characteristics. It is shown that the metastable atoms with a relatively high concentration during the discharge are mainly produced in the active phase of the discharge and dissolved in the off phase. It is also found that the metastable atom collisions can not only provide seed electrons for discharges but also influence the concentration of ions. A reduction of matestable atom density results in a drop in the charged particle densities and causes a qualitative change in the discharge patterns.     

压裂泵往复密封性能及机理研究

根据流体动压润滑理论，对压裂泵柱塞密封摩擦副的润滑机理进行了理论分析。在排出和吸入行程，柱塞密封摩擦副均能满足流体动压润滑的条件，即在柱塞与密封界面上能形成并保持一定厚度的油膜润滑密封，从而达到减小摩擦提高寿命的目的；建立了摩擦界面油膜厚度和泄漏量的计算公式。利用有限元法理论，对密封圈的压力沿轴向的分布规律、泄漏量与压力变化关系进行了模拟计算。对往复密封圈沿轴向压力分布、泄漏量随压力变化进行了测试；试验结果表明，建立的计算模型具有较高的计算精度，揭示了压裂泵的密封机理。     

硅尖阵列-敏感薄膜复合型阴极真空微电子压力传感器特性的测试

封装、测试了硅尖阵列-敏感薄膜复合型阴极的真空微电子压力传感器，在计算机模拟计算的基础上，对封装好的真空微电子压力传感器进行了实物测试，得出实物测试场发射电流曲线（开启电压低，发射电流曲线与计算机模拟曲线一样，电压45V时发射电流可达到86mA，平均每个硅尖为21μA）、压力特性曲线（呈线性变化，与计算机模拟计算的曲线相近）及灵敏度数据。电压1.5V即可测试并且其压力特性成线性变化，灵敏度为0.3μA/kPa。     

Evaporation and Evolution of Suspended Solution Droplets at Atmospheric and Reduced Pressures

Thermal history and solute precipitation behavior of suspended solution droplets of sodium chloride (NaCl), magnesium sulphate (MgSO₄), and zirconium hydroxychloride (ZrO(OH)Cl) evaporating at atmospheric and reduced pressures are studied. Experimental measurements on the variation of droplet diameter, solution concentration, and temperature during the evaporation period are presented and discussed. The results of solute precipitation behavior in solution droplets observed under an optical microscope are displayed and discussed. Results indicate that reducing the pressure (∼ 33 kPa) results in a change in the solution droplet evaporation rate, but the thermal histories of a particular solution droplet are similar at the atmospheric and reduced pressures. At atmospheric and reduced pressures used in this study, the d² law for solution droplets is valid at early stages of the evaporation and before the solute precipitation initiates. Drying of MgSO₄ and ZrO(OH)Cl solution droplets results in the formation of spherical particles, whereas drying of spherical NaCl solution droplets results in the formation of cubic particles.     

变压器和电抗器声级测量方法的对比分析

介绍了变压器、电抗器声级测量方法－－声压法和声强法，并对影响测量结果的各种因素进行了对比分析。     

p,V, T and derived thermodynamic data for toluene,trichloromethane, dichloromethane,acetonitrile, aniline,and n-dodecane

Experimentally determined p,V,T data are reported for toluene, trichloromethane, dichloromethane, acetonitrile, aniline, and n-dodecane at 278, 288, 298, 313, and 323 K, except for dichloromethane, for which the highest temperature was 298 K. At each temperature, measurements were done at pressures up to about 280 MPa or (for aniline and n-dodecane) at a lower pressure slightly below the freezing pressure at the temperature of measurement. Values of the isobaric expansivity isothermal compressibility and (for toluene, trichloromethane, dichloromethane, and acetonitrile) internal pressure, derived from the p,V,T data, are presented.     

进口VPSA制氧装置的流程特点及配置

详细介绍了进口的VPSA制氧装置的流程特点、工艺参数及主要设备的配置。实际运转证明 ,该制氧装置具有运行可靠、启动时间短、部分负荷性能优越、负荷转换速度快等优点 ,能满足金隆铜业有限公司的实际生产要求。     

雅克拉凝析气田高压脱水工艺的成功应用

雅克拉凝析气田位于新疆阿克苏境内，2005年11月29日建成投运的260×10⁴m³/d雅克拉集气处理站是目前中石化最大的高压凝析气处理装置。该站的高压分子筛脱水工艺为两塔流程，采用差压再生（吸附压力5.9 MPa、再生压力2.8 MPa）、再生气自动回收工艺技术，并采用时序控制程序自动切换，具有工艺简单可靠、自动化程度高、热能利用率高、脱水露点深度高、操作维护简单、投资较少、运行成本低等优点，自建成投产以来运行稳定，效果十分显著。该工艺装置的成功应用，对类似脱水装置设计、操作具有一定参考价值。