Breakdown characteristics of oil and paper insulation for a very fast transient voltage

This paper describes the dielectric breakdown characteristics of oil and oil‐impregnated paper for very fast transient (VFT) voltages. Blumlein circuits generate VFT voltages of 60 and 300 ns in a pulse width that simulates disconnecting switching surges in gas‐insulated switch gears. We measured the breakdown voltages of needle‐to‐plane, plane‐to‐plane oil gaps and several pieces of paper between plane electrodes for VFT and lightning impulse voltages. The measured data were formulated in V‐t characteristics and Weibull probability distributions. The inclination n of V‐t characteristics of insulating paper is 150, which is less than n = 13.7 of the plane‐to‐plane oil gap in the VFT time range. The shape parameters of Weibull distribution obtained in this study show that the scattering of breakdown voltages of paper is much less than that of oil. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(4): 16–24, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10043     

测厚仪的维护保养与检修排故

本文简单介绍了差动变压器式测厚仪的日常维护要点及常见故障排除方法。     

奎宁印迹聚合物的吸附与识别特性的研究

以奎宁为模板分子 ,利用分子印迹技术合成了一种新型的类似于人工受体的印迹聚合物 ,研究了它对奎宁和其它底物的吸附特性和选择性识别能力 ,并对其固相萃取性能做了初步的研究。     

MB8镁合金薄板的搅拌摩擦焊

针对我国航空航天工业常用的MB8镁合金。采用搅拌摩擦焊工艺进行焊接，对其焊缝的成形特点、组织特征和力学性能进行分析。结果表明，采用搅拌摩擦焊焊接镁合金效果良好。     

微晶合金在电流互感器中的应用

从微晶合金的性能特点出发，分析了其在电流互感器中的应用前景。     

Stopping power of swift neon ions in dependence on the charge state in the non-equilibrium regime

We report on measurements of charge changing cross-sections and energy losses in dependence on the initial and final charge state of Ne ions at an incident energy of 2 MeV/u penetrating thin carbon foils. Different initial charge states could be separated in energy by applying a high voltage in front of the carbon foils; the final charges and their energy loss were measured with a high-resolution magnetic spectrometer. We derived a consistent evolution of the charge state distribution solving the corresponding rate equations for the measured cross-sections. Including the charge state dependent energy losses, ΔE(q_i,q_f), stopping power values for frozen charge states, S(q), could be extracted. The experimental data are compared with different theoretical predictions.     

熔融-固相缩聚法中固相聚合对聚乳酸合成的影响

以L 乳酸单体为原料 ,熔融 -固相缩聚法合成了聚乳酸 ,重点研究了固相聚合的工艺条件。结果表明 ,绝对压力 60Pa ,氯化亚锡为催化剂 ,分段控温 ,可使聚乳酸的粘均分子量提高到固相聚合反应前的 5 3倍。通过对固相聚合产物的结晶度和熔点的分析 ,探讨了固相聚合的机理。     

气液固三相相平衡热力学模型与计算方法

原油中含有大量的高分子有机固相物质，因此，要准确地描述油气体系相平衡，必须对气液固三相相平衡进行研究，在对高分子有机烃类沥青沉降机理有了一定的认识的基础上，提出了大的交互作用系数，可以描述沥青与原油中轻质不相容性的程度。根据对油气烃类混合物体系的一般性认识与提出的沥青组分特征化方法，导出了与之相应的有其自身特殊性的气液沥青三相相平衡物料平衡方程组，用考虑沥青沉降三相闪蒸数值算法，对沥青沉降进行有效的理化模拟计算，此外，结合实例分析，给出了沥青质参考逸度的计算，饱和压力和沉降量的拟合方法。     

Acoustic emission method for research and control of friction pairs

One of the new physical methods that provides much information about the processes going on in a friction contact zone in real time is acoustic emission (AE). Basic experimental results of AE in friction are presented and analysed. Using AE signals we can get an indication about the state of the friction processes, about the quality of solid and liquid layers on the contacting surfaces in real time, sometimes about intensity of wear, changing of wear and friction regimes and so on. The influence of sliding velocity, load, roughness and some physical and mechanical properties of the body on the parameters of AE are also given. Some attention to the practical implementation of these techniques for control of capability for work of friction pairs in real conditions are given. Modern methods and devices enable condition monitoring of sliding and rolling bearings.     

化工软测量技术研究进展

详细说明了软测量技术的含义以及软测量系统的组成。在此基础上，介绍了软测量技术中基于机理分析建模、应用状态观测器建模、应用统计分析建模、神经元网络、模糊技术、以及支持向量机的智能建模等软测量建模理论方法和最新研究成果，之后介绍了小波分析、推断控制算法在软测量数据处理中的应用，最后介绍了基于虚拟仪器开发平台的软测量系统实现技术。