10 kV 变配电所高压系统设计中 MOA 避雷器的选型

分析民用10 kV 变配电系统中的过电压保护,对无间隙氧化锌避雷器的保护原理、设置原则、参数选择进行阐述。以10 kV 小电阻接地系统与经消弧线圈接地系统的避雷器选择为例,阐述避雷器参数的选型。     

挤塑聚苯乙烯泡沫板外墙外保温系统施工要点及体会

文章以南京理工大学“十五”三期教工集资住宅为例,介绍了挤塑聚苯乙烯泡沫板（FWB）外墙外保温系统的施工工艺和质量控制要点,以及在施工实践中的一些体会。     

钛表面阳极化处理技术

通过对一台钛制设备阳极化处理工艺过程的详细介绍、氧化膜性能的考察及设备的跟踪调查,证明了阳极化处理后能提高钛制设备的硬度、耐磨性、耐蚀性和绝缘性。     

干式接地变压器的故障分析

本文介绍两台干式接地变压器相继故障,通过事故象征,进行全面分析,由于制造工艺欠佳等原因,造成运行中高压侧绕组匝间短路,确定了产品故障的根本原因.     

电气设备绝缘问题处理方法研究

本文通过对电气设备绝缘的基本概念的论述,说明绝缘对电气设备正常使用的重要性;通过对电气设备绝缘的测试方法与相关规定的对照论述,为实际应用提供了方便的平台.确保电气设备的安全运行.     

Experimental study on the performance of insulation materials in Mediterranean construction

It is well known that it is necessary to insulate the buildings to decrease the thermal demand and to decrease the use of heating and cooling. Due to the high cost of fossil fuels and to the necessity to reduce CO₂ emissions, and also due to the new building regulations more attention is paid to the insulation of buildings. Different insulation materials are available in the market. Usually, they are compared by their thermal conductivity and with theoretical calculations, but there are no experimental comparisons available, where the behavior of such insulation materials in a building is compared over time. This is why the authors started a comparison of three typical insulation materials, polyurethane, polystyrene, and mineral wool. For this purpose, four house-like cubicles were constructed (with a size of 2.4 m × 2.4 m × 2.4 m) and their thermal performance throughout the time was measured. The cubicles were built under a conventional Mediterranean construction system, differing only in the insulation material used. During 2008 and the first months of 2009 the performance of these cubicles was evaluated, and the results are presented in this paper.     

中央空调压缩机驱动电机绕组重绕时的维修工艺

中央空调用压缩机电机,工作条件十分恶劣。在电机大修更换绕组后,由于维修工艺达不到要求,运行时间极短即烧毁,导致维修失败的例子很多。可以说维修工艺水平,是空调压缩机电机更换绕组成功的关键,必须予以极大的注意。     

The temperature dependence of effective thermal conductivity of the samples of glass wool reinforced with aluminium foil

In this study, the temperature dependence of effective thermal conductivity (ETC) for samples of binary, ternary, and quadruple glass wools reinforced with aluminium foil was examined. The experiments were realized by the guarded hot plate in temperature differences of 5, 10 and 15 °C and the temperatures of 25 and 40 °C. The results revealed that in the case of reinforcing the aluminium foil, ETC increased with increasing the temperature or changing of temperature difference (5, and 15 °C). Also, an increase of additional layers decrease its' influence on low temperature. Consequently, reflectivity materials may increase or reduce ETC.     

Study of propagation phenomena in three-phase form wound machines operating at medium and high frequency

A three-phase model of asynchronous machines operating at medium or high frequencies is presented. It can be used to study the propagation of surge waves along the stator windings of induction form wound machines.The model is derived from an analogy with a three-phase transmission line. The use of time-space Clarke vectors allows the introduction of mutual coupling between phases. The analytical expressions for voltage waves are derived by means of the Laplace approach to the solution of hyperbolic partial differential equations.Some applicative examples confirm the model validity and can underline some aspects of the project of three-phase windings.     

绝缘拼接式磁性槽楔的结构和性能分析

提出了一种绝缘拼接式磁性槽楔的结构，分析了这种槽楔对电机的齿谐波、齿间漏磁、涡流的影响。只要合理地确定结构和参数，绝缘拼接式磁性槽楔不但能提高电机效率，还能提高电机负载能力。