Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

LM2717型双降压直流/直流变换器的原理及其应用设计

LM2717是美国国家半导体公司推出的一款全新的高性能变换器,内含两个脉宽调制(PWM)直流/直流转换器,功能强大.介绍了该器件的主要参数、工作原理和引脚功能,讨论利用LM2717进行应用设计时选择外部器件的原则及设计中应注意的问题.     

Design and Manufacture of GeSi/Si Superlattice Nanocrystalline Photodetector

According to Maxwell＇s theory, the optical transmission characteristics in GeSi/Si superlattice nanocrystalline layer have been analyzed and calculated. The calculated result shows that when the total thickness L is 340 nm, the single mode lightwave can be transmitted only at periodic number M≥15.5. In addition, at the direction of transmission, when the transmission distance is larger than 500 μm, the lightwave intensity is decreased greatly. Based on the above parameters, the design and manufacture of GeSi/Si superlattice nanocrystalline photodetector are carried out.     

Measurement of the Metal Surface Acidity/Electronegativity of Pt(110)

In previous work, it has been found that a hydrogen-covered Pt(110) surface is acidic, but quantification of the acidity has not yet been done. In this paper a spectroscopic method is developed to measure the acidity of a metal surface for the first time. The technique involves measuring the intensity of the N–H stretch from the C₅H₄XNH⁺ that forms when hydrogen coadsorbs with pyridine, 2-fluoropyridine and 3-fluoropyridine. The Bethe approximation is then used to estimate the metal surface acidity/electronegativity (MSAEL). The proton affinity/MSAEL of Pt(110) has been determined to be 907 ± 4 kJ/mol at high coverage. This is the first time the MSAEL has been measured on a metal surface. Implications for fuel cell catalysis are discussed.     

The Application of Ozone for Water Treatment In The United Kingdom — Current Practive and Recent Research

Only two water works in the UK apply ozone at present as part of their treatment, onefor taste and odor control and theother forcolor removal. Forthetwo applicationus ozone was the most economical option at thetime theplants were installed andozone has been successful for the purpose for which it was designed.     

Durability of hygrothermally aged graphite/epoxy woven composite under combined hygrothermal conditions

The objective of this study was to examine the effects of hygrothermal aging on the durability of a graphite/epoxy woven composite material system. The study was part of a larger project in which the objective was to evaluate and model the effects of moisture, temperature, and combined hygrothermal conditions on the strength and life of a graphite/epoxy woven composite material system. The results presented here represent an extension of the work by Patel and Case (Int. J. Fatigue 22 (2000) 809).

The hygrothermal aging consisted of cyclical temperature and moisture variations which were meant to simulate mission conditions for an advanced subsonic aircraft. Durability studies were carried out on the aged material system in the form of fatigue and residual strength testing under humid and elevated temperature environments. Damage mechanisms and failure modes were determined through fatigue testing, residual strength testing, and nondestructive evaluation.

Changes in physical appearance, thermal analysis results, fracture surfaces, and moisture diffusion behavior all supported the idea that the material was affected by the aging process. However, experimental testing also showed that the initial and residual tensile properties of the aged material were virtually unaffected by the imposed environmental aging (as compared to unaged material testing results), except when tested at elevated temperature. At elevated temperature, both the dynamic stiffness and residual strength were noticeably reduced from that at room temperature.     

乙炔在磁稳定床中的选择性加氢研究

 制备了一种磁性Pd/Al₂O₃催化剂，采用磁稳定床考察了活性组分负载量、反应条件及CO浓度对乙炔加氢反应性能的影响。结果表明，当反应温度80℃、反应压力1.5MPa、空速9000h－1、磁场强度（H）25kA/m时，乙炔转化率为100％，乙烯选择性可达81％，具有优良的乙炔加氢活性和乙烯选择性，优于相同反应条件下的进口催化剂；250h稳定性实验结果表明，磁性Pd/Al2O3催化剂具有良好的初活性和乙烯选择性，催化剂性能稳定。     

Income, Time Effects and Direct Preferences in a Multimodal Choice Context: Application of Mixed RP/SP Models with Non-Linear Utilities

Transport problems typically involve at least two types of constraints, on income and on time. Therefore, the indirect utility function depends either on the income available after having subtracted the cost of the discrete alternative and on the free time left after having worked and travelled by each competing option. In the typical linear-in-the-attributes and in-the-parameters specification, that represents the first grade approximation of the indirect utility function, the effect of income and time constraints cancel out and only the cost and time of the alternatives matter in the comparison between them. From a microeconomic point of view this is equivalent to assume that income and time effects could be disregarded; which is not always the case. To account for these effects the utility function should include second order attributes; however, in non-linear utility functions it may not be easy to distinguish among several effects that could be relevant: direct preferences for good and leisure, and simple interactions between attributes other than income and time effects. This paper analyses these effects from a theoretical point of view focusing on the possible confounding problem in detecting income and time effects. We use a dataset collected for a modal choice context and containing both revealed and stated preference data, and estimate several NL models examining the effect of the different second-order terms on detecting income and time effects. We compared specifications including square cost and time attributes, interactions between time and cost, cost divided by the income available to be spent on free time, and time multiplied by free time. Our results confirm the strong effect of direct preferences for goods and leisure time on choice, and the potential confounding effect between quadratic attributes and other non-linear omitted terms. Finally, we also found that care should be taken in highlighting income and time effects using mixed data sources, since confounding effects can occur when non-linearities are accounted for in both data sets.     

降低氧化铝生产中熟料折合比的探讨

在氧化铝生产过程中，熟料折合比是烧结法一项重要的综合性指标，本文通过对熟料折合比的定义、计算公式的剖析，分析了生产过程中影响熟料折合比的主要因素，对有效降低熟料折合比的措施进行了探讨。