Comments on “Fully magnetic attitude control for spacecraft subject to gravity gradient”

The Lyapunov argument used in Wi niewski and Blanke, (Automatica 35 (1999) 1201) to establish asymptotic stability of a magnetic control law for an earth-orbiting spacecraft is incorrect. It is shown here that a small change to the assumed form of the control law can remedy the situation.     

Evaluation of influence of external magnetic disturbance on superconducting magnet taking conservation of linkage flux into account

External magnetic disturbance influences the quality of the image obtained with a magnetic resonance imaging (MRI) system because it causes magnetic resonance frequency drift. When a superconducting magnet in persistent current mode operation is exposed to external magnetic disturbance coil current varies to keep linkage flux constant. Conventional analysis is usually formulated with constant current and does not provide correct evaluation of drift of magnetic field in the magnet. This paper proposes a method of numerical analysis of magnetic field considering conservation of linkage flux in a superconducting magnet under a persistent current mode operation. This method is applied to evaluate drift of the magnetic field in a superconducting magnet for magnetic resonance imaging due to external magnetic disturbance. Analysis results show good agreement with the experimental results.     

MR imaging of focal liver lesions: comparison between turbo spin-echo and conventional spin-echo pulse sequences

The aim of this study was to compare conventional spin-echo (CSE)T ₂-weighted (T2W) images with turbo spin-echo (TSE) T2W pulse sequences in their ability to detect focal liver lesions. Seventy-eight consecutive patients with focal liver lesions were entered into this study. All patients were imaged using the gradient-echo (GE) sequence with the breath-hold technique forT ₁-weighted (T1W) images, and CSE and TSE sequences for T2W images. Qualitative evaluation included lesion detection (number of lesions detected) and conspicuity (extent of visualization of lesional borders); quantitative evaluation included the signal-to-noise (S/N) ratio and the contrast-to-noise (C/N) ratio. TSE showed the best performance in terms of lesion detection; however, the difference between TSE and CSE was significant only in the case of benign cysts (p<0.01). Conspicuity was higher with TSE and CSE, and lower with GE. The S/N and C/N ratios of the two T2W sequences were also comparable, and better than those of GE. However, the combined use of GE and TSE resulted in improved lesion detection. The results show that, because the acquisition time is greatly reduced with TSE sequences, these should be considered as first-line approach to magnetic resonance imaging of the liver for the study of focal lesions.     

氨基磺酸系高性能减水剂的研制开发

本文主要讨论了氨基磺酸系高性能减水剂的合成过程及后期混凝土试验情况。通过对反应温度、反应时间、溶液浓度和酸碱度、投料顺序及速度、第四单体的选择等反应条件的控制,合成具有最佳分子结构的最终产物,并通过红外光谱图和核磁共振谱图对合成主产物的分子结构进行了验证。同时,大量的混凝土试验说明氨基磺酸高性能减水剂具有优良的保坍性能。     

基于B点磁探针膛内电枢电弧长度与速度分布测量的计算机控制系统的研究

基于B点磁探针的测量原理，建立了电磁轨道炮膛内三维等离子体电枢电弧长度和电弧运动速度测量的数学模型，通过对该模型的分析给出了用于测量膛内电枢电弧长度和运动速度分布的相应推论。开发了用于测量膛内等离子体电枢电弧长度和速度的多通道计算机控制诊断系统，并进行了相应的试验研究。     

驻极体声传感器及其储电材料的现状

综述了驻极体声传感器及其储电材料近年来的迅猛发展。传统的FEP(tetrafluoroethylene—hexa—fluoropropylene copolymer)极体电容式声传感器及以铁电聚合物PVDF(poly vinylidene fluoride)家族为芯片的声传感器和超声抉能器仍焕发着青春活力。Si基微型驻极体声传感器的理论和实验研究已经日趋成熟，而用空间电荷型多孔聚合物驻极体压电薄膜为芯片可望研制出新一代声电和电声传感器、压力传感器和驱动器。     

Nuclear Magnetic Resonance Studies of Silicon Carbide Polytypes

The ²⁹Si MAS NMR spectra of the 2H, 4H, 6H, and 3C polytypes of silicon carbide are presented. An attempt is made to correlate differences in the chemical shifts with local atomic environment. The results of the analysis of the spectra of pure polytypes are used as a basic for the interpretation of the spectra of mixed polytypes and a discussion of the crystallinity and impurity levels of different samples. Carbon-13 chemical shifts obtained from spectra of the same polytypes are also tabulated.     

求解电缆自感系数的一个佯谬

用求自感系数的两个常用公式求解实心电缆自感系数时，如果不注意对公式中Φm及I的正确理解，将会得到不一致的“佯谬”结果。本文通过将实心电缆等效为许多细线圈的方法，用2种公式求解得到了一致的结果。     

Effect of Traveling Magnetic Field on Mould-Filling Length of the A357 Melt during Casting THin Walled Plate

In order to improver the mould filling ability ,the method for production of thin-walled castings in the traveling magnetic field was applied,The relationship between magnetic field density and input voltage as well as distance was investigated,and the mould filling length of A357 melt has been studied,The electromagnetic forces applied on the melt were also analyzed,The result shows that the mould-filling length of the melt increase rapidly with the increase of magnetic flux density,The mould filling lengths in gypsum upper mould and magnetic material upper mould were compared from the standpoint of application,It demonstrated that the steel upper mould is superior to gypsum mould.