The Danish Twin Apartment Study – Part II: Mathematical modeling of the relative strength of sources of indoor air pollution

Abstract This study deals with the modeling of air pollution in apartments from laboratory measurements of source strengths, using formaldehyde and Total Volatile Organic Compounds (TVOCs) as model pollutants. The sources in two test apartments were grouped into two: building-related sources and occupant-related sources. The measured source strengths and ventilation rates were used for the prediction of concentrations expected in the apartments. These predictions were compared to measurements in the apartment over 12 months. The conclusions were that the model predictions based on emission rates measured in the laboratory can be used to predict the long-term concentration of the two model pollutants in the apartments. Considering the measured differences in ventilation between the apartments, an occupant emission rate of between 0.2 and 0.3 mg/h/kg body weight could be estimated. Based on previous suggested limits of acceptable exposures of humans to VOCs, an acceptable average emission rate of VOCs from building materials in general was estimated to be about 30 (μ/m²/h. The modeling showed that during the first 200 days, building materials dominated the emissions. After this, sources relating to the occupants dominated. On average about half of the VOC pollution originated from the building materials.     

GaAs FET辐射退化研究

低噪声ＧａＡｓ ＦＥＴ和功率ＧａＡｓ ＦＥＴ经中子辐射都未发生致命性的通或断失效，直流偏置伏态下，其失效模式仅仅表现为源漏饱和电流ＩＤＳＳ的退化降低，据此提出了ＩＤＳＳ退化失效与快中子注量φｎ之间的解析关键式ｌｎｙ＝ａ＋ｂｌｎφ。     

Engineering Model of a Nonisobaric Heavily Laden Gas‐Particle Jet

An axisymmetrical model of a rapid nonisobaric heavily laden gas‐particle jet is developed. The model is based on the general functions for both axial and radial pressure distributions, which were discovered by a numerical study of rapid gas‐particle jets by the CFD code. The model equations were solved analytically. The results obtained by the model developed are in good agreement with those computed by the CFD code for a wide range of flow parameters.     

Air entrainment in fresh concrete with PFA

The results of a study into the influence of PFA on air entrainment in fresh concrete are discussed It is shown that the required dosage of AEA to produce an air content of 5.5 ± 0.5% in a PFA modified concrete mix is two-six times that required in the corresponding neat OPC concrete mix. The dosage of a vinsol based air entraining agent (AEA) required appears to be directly related to the PFA content of the mix. Similar direct relationships were obtained with a range of different PFAs. The dosage of an AEA based on the salt of a fatty acid appears to be sensitive to both PFA and OPC contents. For the type of PFA used, the variability of measured air content or the amount of air retained after continued agitation both indicated that vinsol based AEAs show the highest variability whilst fatty acid based AEAs show low variability. The between batch variability of air content was significantly improved by the addition of PFA regardless of the AEA used.     

强脉冲辐射场非平衡硬X辐射测量技术

本文介绍了强脉冲辐射场非平衡硬Ｘ辐射谱测量方法。文中对测量原理、关键定标技术进行了叙述。     

ANALYSIS OF EXPERIMENTAL AND NUMERICAL RESULTS OF A TURBULENT SWIRLING FLOW IN A TUBE

In many applications swirling flow is used to enhance heat and mass transfer. One of the problems of modelling a turbulent swirling flow is the choice of the turbulent closure model which is acceptable for engineering purposes. To evaluate which model performs best, numerical results are compared with experimental data. Local velocity measurements are carried out on a swirling flow in a circular tube. The measurement method is hot-wire anemometry combined with visualization techniques. The numerical analysis is carried out using the k-ε model and the Algebraic Stress Model. In the experiment a symmetrical swirl was observed, Comparing the experimental data with the numerical results shows that the Algebraic Stress Model represents the experimental data quite well, whereas the k-ε model fails.     

加速器磁场测量的霍尔多探头装置

描述了用于加速器磁场测量的霍尔多探头装置,它包括一个具有三只恒温盒(内有58只霍尔片)的测磁长臂,高精度磁场检定系统以及数据自动获取系统。分别叙述了霍尔片的定位、恒温、校准、数据采集、处理等内容。并提出了多探头装置测量中霍尔片稳定性的重要性。给出了在我们条件下的一些具体数据。本装置已应用在兰州重离子研究装置(HIRFL)的建造过程中,实践证明它能有效地高质量地满足加速器磁场测量的要求。     

RADIOACTIVE OR NATURAL TRACER。TECHNIQUES FOR LEAK DETERMINING OF DAM ABUTMENT

Infiltration and localization of preferential infiltration zones at the dam abutment are measured using radioactive tracer tests of flow in boreholes,meanwhile interconnection between boreholes and the energing water points is analysed.The theory and practice of radioactive tracer synthetic detective method are described to give methods and calculation formulae used under the condition of stable flow in single well to measure permeability coefficient and hydrostatic heads.Major single hole techniques including measurement for seepage line,velocity,rate of seepage flow and relationship of recharge of groundwater in aquifers are introduced briefly.The possibilities offered by natureal tracers are analysed,uincluding electric-conduct,pH-value and temperature of water as well as stable isotopes(D,^18O) and tritium.Furthermore,the sensibilities of this theory and methods were confirmed by detecting seepage flow field of Xinanjiang Dam.     

凝固过程中的颗粒推斥

颗粒推斥是材料在固液相变过程中的基础问题之一，界面自由能的传统理论难以解释在金属基复合材料制备过程中的颗粒推斥现象，作者提出了固液界面前沿的流体流动是颗粒推斥的主要原因之一，并给出颗粒滚动及颗粒速度两种作用机制，推导出颗粒推斥条件判据，并以实验验证流体流动的作用机制及颗粒推斥理论判据。     

回火过程应力场计算机模拟

回火过程应力场计算机模拟林家骝，杨振枢，于震宗，段贵明（清华大学）郭剑仁，史全兴，谢克仁（内蒙古第一机器厂）ＡＳｔｕｄｙｏｆＮｕｍｅｒｉｃａｌＳｉｍｕｌａｔｉｏｎｏｆＳｔｒｅｓｓＦｉｅｌｄｄｕｒｉｎｇＴｅｍｐｅｒｉｎｇ￥ＬｉｎＪｉａｌｉｕ；ＹａｎｇＺ...