连轧机用人字轮齿轴断裂失效分析

用宏观断口分析、化学检验、力学性能测定、低倍检查、金相组织及夹杂物评定鉴别、受力分析及强度寿命定量估算的方法，对人字轮被动齿轴端断裂失效原因进行分析，并提出改进措施。     

基于非线性规划的指数自回归模型的辨识

讨论了指数自回归模型的辨识问题，证明了该模型最小二乘估计的目标函数的非凸性，并给出了使该函数为凸的条件，最后给出了辨识该模型的算法及该算法的收敛性，并以数值例子加以说明。     

Electrochemical Aspects of Electroosmotic Dewatering of Clay Suspensions

An attempt is made to elucidate the electrochemical aspects of the electroosmotic dewatering (EOD) of clays as reported in some recent work, especially that on interrupted DC power electroosmotic dewatering published by Rabie, Mujumdar and Weber (2). These authors showed that the dewatering by EOD stops after the DC power has been on for several minutes or hours; on interruption of their power and on short-circuiting of the electrodes, conditions can be created again for some further dewatering by DC power EOD. This discovery, of Rabie et al. is interpreted as a fuel cell effect and it is shown that it affords clues to several other electrochemical strategies for the possible enhancement of the efficiency of the EOD by DC power.

Further, the open circuit potentials observed by Rabie et al. (2) on the interruption of DC power are given an electrochemical interpretation which leads to quantitative estimates in agreement with the experimental values.     

特高压快速接地开关的研制

特高压输电线路上,潜供电弧对线路产生的影响不容忽视,潜供电弧的顺利熄灭是实现单相自动重合闸的必要条件.稳态下潜供电流和恢复电压幅值是潜供电弧熄灭的两个决定性因素.快速接地开关作为重要的电器设备,越来越多的应用于电力系统中.快速接地开关除了在系统发生故障时接地外,还能快速关合潜供电流和降低恢复电压.本文根据750kV系统潜供电弧的特点和熄弧要求,研制了一种快速接地开关,着重对触头系统进行了研究,计算了触头压力、触头电动力及断口开距的大小,给出了快速接地开关整体设计思路和结构图.     

岩盐钻井水溶双井连通开采工艺的研究与推广

文章就全国井矿盐采区多年的开采工艺技术，进行了系统的研究与总结，并提出了岩盐钻井水溶开采双井连通的各种开采工艺及其关键技术，具有很强的适用性和推广价值。     

MHD simulation of high-current subsonic vacuum arc under different distributed axial magnetic fields

Based on two-temperature magnetic hydrodynamic (MHD) model, the influence of saddle-shaped distributed axial magnetic field (AMF, linearly increases along radial position) and bell-shaped distributed AMF (linearly decreases along radial position) on plasma loss and heat flux density to anode in subsonic high-current vacuum arc (HCVA) is simulated and analyzed. According to the simulation results, the saddle-shaped AMF can more effectively inhibit plasma loss from arc column than that of bell-shaped AMF. Comparisons between simulation results and experimental results further verify the correctness of model and simulation.     

电弧炉采用石灰石单渣冶炼工艺的研究

采用优质石灰石取代质量差的白灰 ,进行了单渣电弧炉熔炼。结果表明 ,钢水成本降低 ,钢水质量提高 ,取得了良好的效果。     

变压器事故原因分析

通过分析一次变压器事故的原因。指出变压器实际运行中存在的问题。并结合自己的工作经验提出科学的改进建议。     

滴注式直-压淬双排渗碳线的设计及应用

详细阐述了滴注式直-压淬两用双排气体渗碳自动线的组成单元，渗碳气氛、工艺柔性化、设计特点以及工艺调试；生产实践证明：自动线运行可靠．稳定，主要技术性能和指标达到或优于国家标准。     

钻机绞车滚筒体的窄间隙埋弧焊

针对钻机绞车滚筒体采用手工电弧焊工人劳动强度大、焊接效率低、质量不稳定及返修率高等问题,研制了钻机绞车滚筒体窄间隙埋弧焊专机。该专机由ESAB—A2埋弧焊电源和焊接小车、窄间隙焊头、滚轮架、防窜装置、旋转地线夹、三维焊接工作台、焊剂自动回收机组成。使用表明,采用该焊机焊接的滚筒体焊缝质量完全符合设计要求,合格率100%,焊接效率比原来提高6倍。每件滚筒体的焊接可降低人工成本约80%。