分离式热管换热器在脱硫装置的应用

介绍了分离式热管换热器的工作原理及其在工业脱硫装置中的应用，并不其余热回收情况与传统的二次中热方法相比较，阐明了其节能及环保作用。     

Research on Marine Boiler＇s Pressurized Combustion and Heat Transfer

The effect of pressure on combustion and heat transfer is analyzed. The research is based on the basic combustion and heat transfer theorem. A correction for the heat calculation method for pressurized furnace is made on the basis of the normal pressure case. The correction takes the effect of pressurizing into account. The results show that the correction is reasonable and the method is applicable to combustion and heat transfer of the marine supercharged boiler.     

SUPMAX500系统在锅炉控制系统中的应用

针对动力厂35t/h锅炉的工艺控制要求，选用SUPMAX500集散控制系统。介绍了系统的软、硬件构成及其具体实施方法。     

Connecting the second exhaust-heat boiler to the operating first one under the conditions of flow circuits of combined-cycle plants with two gas-turbine units and one steam turbine

Problems arising with connecting the second exhaust-heat boiler to the first exhaust-heat boiler under load in the case of flow circuits of combined-cycle plants of type PGU-450 are considered. Similar problems exist for two-boiler single-turbine units of type PGU-325 and for two-boiler single-turbine units of traditional steampower plants with an output of 200–300 MW upon connection of the second furnace of a two-furnace boiler to the operating first furnace. Analysis of the temperature-induced stressed state and of the cyclic strength of thick-walled elements of the steam-water conduit of PGU-450 and of two-furnace boilers of two-boiler single-turbine units with an output of 200–300 MW (the check valve, the inlet header of the water economizer) is used for determining the steam temperature differences in the high-pressure conduits to the steam turbine and the order of connection of the second exhaust-heat boiler to the operating fist one. Modes of enabling a two-boiler single-turbine unit of a combined-cycle plant, which are most “rigid” from the standpoint of thermal strength, are determined. __________ Translated from élektricheskie Stantsii, No. 2, February 2006, pp. 11–17.     

基于遗传神经网络的电站锅炉飞灰含碳量预测

针对锅炉飞灰含碳置影响因素复杂．实时测量难度大．精度低，提出了一种基于遗传神经网络的预测方法，并用于某电厂，结果表明，该方法是有效的。     

55t/h锅炉技术改造成功经验

介绍了35t／h锅炉扩容改造为55t／h非标锅炉的技术成功经验。从增加锅炉的容积、受热面面积、燃烧器喷嘴改造三个方面介绍了对锅炉本体的改造，改造后实现了锅炉的水位、汽温及燃烧自动调节，提高了锅炉的热效率为以后的锅炉扩容改造提供了实践经验。     

湿法停炉保护优点多 建议采用YZ—101防腐阻垢剂作为湿法炉保护剂

介绍了湿法炉保护的作用原理,YZ—101防腐阻垢剂的使用方法、注意事项以及使用后所带来的经济效益。     

在65t/h锅炉上应用小型集散控制系统

针对湘钢６５ｔ／ｈ链条钢炉气煤混烧特点，设计了给水、燃烧、汽温调节，应用美国Ｈｏｎеｙｗеｌｌ９０００系列小型集散控制系统，保证了锅炉安全、经济运行，达到了节能目的。     

钢铁企业锅炉改造的可行性分析与实践

根据旧有锅炉存在的问题提出了改造方案，并对其进行可行性分析，选择了符合企业实际情况的改造方案，从而取得了良好的经济效益。     

锅炉炉膛红外成像温度实时检测系统研究

说明电厂锅炉炉膛温度及结焦直接影响锅炉正常运行及安全；给出了基于多探测器的锅炉反应温度红外成像实时测温系统的系统结构、系统原理、系统标定和温度测定方法。