膦化合物对加氢催化剂的影响

丁辛醇装置丁醛加氢催化剂在装置扩能投产以后热点上移 (失活 )的速率较快 ,针对催化剂老化的原因进行分析、判断 ,找出原因 ,采用相应的解决措施 ,可延长催化剂使用寿命 ,增加装置效益     

硫含量对钴钼型耐硫脱氧剂的脱氧活性影响

研究了工艺气中硫含量对钴钼型耐硫脱氧剂脱氧活性的影响。通过常压微反 -色谱装置测定脱氧剂的本征脱氧活性 ,加压原粒度反应器测定脱氧剂的表观脱氧活性 ,结合实际经验确定了耐硫脱氧剂所需的最低硫含量。还讨论了温度、压力、空速对耐硫脱氧剂脱氧活性的影响。结果表明 ,耐硫脱氧剂完全能满足耐硫变换工艺的要求 ,而且有耐硫变换的作用 ,并对耐硫变换催化剂起到保护作用     

Performance of the polymer- and oxide-supported triphase catalysts and effect of ultrasound on their stabilities

In this study, several trialkylamines were immobilized on chloromethylated polystyrene (CMPS), silica gel, and alumina to prepare triphase catalysts for catalyzing the etherification reaction of allyl bromide (the organic reactant) and sodium phenolate (the aqueous reactant). The reactor was agitated mechanically or with the aid of ultrasonic vibration. Performances of the prepared catalysts were compared, and the effect of imposing ultrasound was investigated based on the activity, selectivity, and stability of the catalyst. Experimental results show that tri-n-propylamine is the best active species when CMPS is used as the support, while tri-n-butylamine is the best when SiO₂ and Al₂O₃ are employed as the supports. The CMPS-supported catalyst is far better than the SiO₂- and Al₂O₃-supported catalysts in activity and selectivity but not in stability. Imposing the ultrasound can effectively increase the reaction rate. Mechanical agitation at a low speed with the imposition of ultrasonic vibration not only results in a conversion slightly higher than the case with a high mechanical agitation speed without ultrasonic vibration, but also gives a constant stability for the CMPS-supported catalyst.     

Continuous hydrogen evolution from cyclohexanes over platinum catalysts supported on activated carbon fibers

The continuous production of hydrogen from cyclohexanes is achieved effectively using Pt/ACF (ACF = activated carbon fiber) catalysts in a fixed-bed flow reactor. The Pt catalysts are more effective than a Pd/ACF catalyst for the reaction. Besides cyclohexane, methylcyclohexane, 1,4-dimethylcyclohexane, and p-menthane can also be employed as hydrogen source in the reaction system.     

LY-8602系列催化剂的失活原因及对策

通过催化剂的评价及表征，对LY-8602系列催化剂在低硫裂解汽油加氢时的失活原因进行了研究，结果表明，其活性下降主要是催化剂的活性中心相Co-Mo-s遭到破坏，使催化剂表面的具有加氢活性的Mo^4 峰减小所致。采用新研制的高活性加氢催化剂LY-9702与LY-8602构成复合床催化剂，可以使加氢产品合格。     

Study on Reduction of Sulfur Content in FCC Gasoline

Reduction of sulfur content in FCC gasoline was studied in a fixed fluid bed (FFB) unit by using metal-modified LV-23 FCC catalyst. The results showed that the sulfur content in FCC gasoline could be reduced with LV-23 catalyst modified with zinc, palladium, zinc-palladium, zinc-cobalt, and zinc-nickel. Among these metals or metal combinations, palladium-containing catalyst was the most effective. Desulfufization of the heavy fraction of FCC gasoline was more effective than full-range gasoline under the same conditions with palladium-containing catalysts. A high reaction temperature was favorable to desulfurization, but it would reduce the yield of liquid product. After desulfurization reaction, the olefm content of product gasoline decreased while the aromatic and iso-alkane contents increased. Removal of thiophene and benzothiophene is higher.     

La改性的Ag/TS-1催化剂上丙烯选择氧化制环氧丙烷

在H2 和O2 混合气体存在下 ,在常压固定床、石英反应器上考察了La改性的Ag/TS - 1催化剂催化丙烯环氧化反应。研究结果表明 ,Ag和La负载在TS - 1上的先后顺序对丙烯环氧化反应有影响。H2 在丙烯气相氧化反应体系中起着重要的作用。     

长链烯烃-苯烷基化反应的分子筛催化剂再生性能的研究

通过热重分析和活性稳定性评定考察催化剂的再生性能。研究结果表明,进行氯气吹扫以及苯抽提后进行氮气吹扫两种预处理,导致失活催化剂的起燃点和烧焦反应活化能均有所提高,有利于控制烧焦反应速度。按苯抽提、氮气吹扫、烧焦的顺序,分三个阶段进行催化剂再生,再生催化剂的活性稳定性得到更充分的恢复。     

载体及反应条件对Pt/BaKL沸石催化剂芳构化性能的影响

研究了γ-Al_2O_3或SiO_2载体,以及反应条件对Pt/BaKL沸石催化剂芳构化性能的影响。发现经过碱化或负载Sn的γ-Al_2O_3作为载体,能够较好地保持该催化剂在正己烷芳构化反应中的高活性和高选择性,并有益于改善Pt/BaKL沸石催化剂的抗硫性能。     

CH_4、CO_2与O_2制合成气的研究 Ⅱ工艺条件的影响

在固定床反应器中考察了１２％Ｎｉ－５％ＲＥ－２％Ｃｕ－２％Ｌｉ／Ａｌ２Ｏ３（ｍａｓｓ）催化剂在ＣＨ４、ＣＯ２与Ｏ２催化氧化重整制合成气反应中催化剂粒径、工艺操作条件（空速与温度）及原料气配比对反应的影响，确定了较佳的操作条件：催化剂粒径２０～４０目，反应最佳温度为８００℃，ＳＶ＝４×１０４ｍｌ／（ｇ·ｈ）。同时看到在不同的原料气配比的条件下该催化剂的活性亦很稳定，不仅达到了反应平衡，且产物Ｖ（ＣＯ）／Ｖ（Ｈ２）比有很强的调变性。