铁铝酸盐复合膨胀水泥化学预应力机理及其应用研究

本文阐述铁铝酸盐自应力混凝土的主要物理力学特征.研究了限制膨胀应变与配筋率之间的定量函数关系.通过正交试验和方差分析,确定了复合外加剂对其性能的影响.针对其在自应力管中的应用,提出多层中空圆柱理论计算模型,按弹性理论计算出自应力管初始应力分布规律.对比以前的线性理论计算误差,给出相应的修正系数.本文对类似的自应力混凝土,具有普遍的指导意义.     

Analysis of low load transients for the Vandellòs-II NPP: Application to operation and control support

The Technical University of Catalonia (UPC) has been jointly working with the Asociación Nuclear Ascó-Vandellòs (ANAV) for a number of years in order to establish, qualify and use best estimate (BE) models for the reactors under the control of ANAV. ANAV is the consortium that is responsible for operation of the Ascó and Vandellòs-II reactors. The reactors are Westinghouse-design three-loop PWRs with an approximate electrical power of 1000 MW. The existing integral plant models for each plant are currently used for many different purposes among which are support of plant operation and control. Quite a number of studies have been done in order to improve both safety and plant competitiveness. Most of these dynamic analyses were carried out in relation to transients starting at nominal full power or at least, very close to full power. This paper develops a specific use of the Vandellòs-II plant model for operation and control support at low power involving new ranges of system actuation parameters. It also examines scenarios that are somewhat different from those typically analysed. The study starts showing the results of an assessment case, which is a start-up test and provides some additional qualification, and subsequently attempts to establish calculations to support both an improvement in feed water controls and to set up operating recommendations for low-load manual operation of feed water turbo-pump. Both results hopefully, will produce an outcome, which leads to an improvement in safety and reduces reactor trip probability.     

卷边槽钢压杆考虑板组约束作用的屈曲系数

卷边槽钢压杆的局部屈曲具有相关性。《冷弯薄壁型钢结构技术规范》(GB50018-2002)提出适用于各种不同截面的板组约束系数的统一计算公式来考虑这种相关性。但由于板组组成的多样性,其是否合理,有待于进一步研究。借助ANSYS有限元分析软件,对卷边槽钢压杆局部屈曲进行分析,得到考虑板组约束作用的屈曲系数,并和国内外规范进行比较。结果表明,计算结果和英国规范吻合较好,我国规范偏于安全较多。借鉴英国规范的形式,给出考虑板组约束作用的屈曲系数的计算公式,这些公式可供进一步修订规范时参考。     

Heat transfer in YBaCuO thin film/sapphire substrate system

The thermal boundary resistance at the YBaCuO thin film/Al₂O₃ substrate interface was investigated. The transparency for thermal phonons incident on the interface as well as for phonons moving from the substrate was determined. We have measured a transient voltage response of current-biased films to continuously modulated radiation. The observed knee in the modulation frequency dependence of the response reflects the crossover from the diffusion regime to the contact resistance regime of the heat transfer across the interface. The values of transparency were independently deduced both from the phonon escape time and from the time of phonon return to the film which were identified with peculiarities in the frequency dependence. The results are much more consistent with the acoustic mismatch theory than the diffuse mismatch model.We are grateful to A. Elantev for helpful discussion. We acknowledge the financial support of the Russian Scientific Council on the HTS problem (Project No. 90462).     

Sound-velocity measurements for HFC-134a and HFC-152a with a spherical resonator

A spherical acoustic resonator was developed for measuring sound velocities in the gaseous phase and ideal-gas specific heats for new refrigerants. The radius of the spherical resonator, being about 5 cm, was determined by measuring sound velocities in gaseous argon at temperatures from 273 to 348 K and pressures up to 240 kPa. The measurements of 23 sound velocities in gaseous HFC-134a (1,1,1,2-tetrafluoroethane) at temperatures of 273 and 298 K and pressures from 10 to 250 kPa agree well with the measurements of Goodwin and Moldover. In addition, 92 sound velocities in gaseous HFC-152a (1,1-difluoroethane) with an accuracy of ±0.01% were measured at temperatures from 273 to 348 K and pressures up to 250 kPa. The ideal-gas specific heats as well as the second acoustic virial coefficients have been obtained for both these important alternative refrigerants. The second virial coefficients for HFC-152a derived from the present sound velocity measurements agree extremely well with the reported second virial coefficient values obtained with a Burnett apparatus.Paper dedicated to Professor Joseph Kestin.     

高精度合成地震记录制作技术研究

制作高精度的合成地震记录是精细储层描述的基础，本文在分析合成地震记录原理的基础上，从地震剖面的极性判断、平均速度的选取，反射系数的准确提取，子波的精确估算等方面对制作合成记录的要点进行了分析，通过提高以上四方面的精度，提高了制作合成地震记录的精度，并提出了一套可行的合成地震记录的检查方法。     

Drying of Chestnuts (Castanea sativa Mill.) after Osmotic Dehydration with Sucrose and Glucose Solutions

Chestnuts were dehydrated by using a combined method of osmotic dehydration followed by air drying. Samples were osmotically pretreated with sucrose (60% w/w) and glucose (56% w/w) for 8 h, air-dried at temperatures of 45, 55, and 65°C, at a relative humidity of 30% and at a velocity of 2.7 m·s^-1 and the experimental data of the drying kinetics were obtained. Whole samples were dried with different peelings: (a) removal of endocarp and pericarp (peeled) and (b) additionally the internal rough surface (cut). In all cases, cut chestnuts show greater drying rates than peeled samples, indicating that a significant mass transfer resistance in the layer nearest to the surface takes place. Peeled samples pretreated with sucrose solutions behave in a similar way to untreated samples. For the rest of the samples, the cut samples osmotically treated with sucrose solutions and all the samples treated with the glucose solution, the drying rates decrease during drying. Drying kinetics are successfully modeled by employing a diffusional model that takes the shrinkage into account. The effective coefficient of water diffusion was evaluated and correlated with temperature. The quality of the final product was monitored by color change. In spite of the fact that the total color difference is not modified by the osmotic treatment, the L*, a*, and b* color coordinates of cut samples treated with sucrose and glucose solutions do undergo changes; the L* and a* coordinates change less than the b*.     

Molecular Diffusion Coefficients of Organic Compounds in Water at Different Temperatures

Molecular (or tracer) diffusion coefficient data were obtained for 2-naphthol, benzoic acid, salicylic acid, camphor, and cinnamic acid in water at temperatures that differ significantly from ambient value. Experimental values were determined for the dissolution of 2-naphthol in water at 283 to 368 K, of benzoic acid in water at 283 to 338 K, of salicylic acid in water at 283 to 343 K, of camphor in water at 283 to 318 K, and of cinnamic acid in water at 283 to 318 K. Empirical correlations are presented for the prediction of molecular diffusion coefficient over the entire range of temperatures studied, and they are shown to predict the obtained data with very good accuracy.     

斜向波与长棱柱型浮式结构物相互作用的边界元模拟

采用第二类变形Bessel函数对斜向线性入射波与任意截面形状的长棱柱型浮式海洋结构物的相互作用问题进行了边界元法模拟,给出了常数元和线性元的奇异积分处理方法以及开边界的处理方式。对矩形和圆形结构物的水动力系数和波浪力进行了计算,并与解析解及有限元计算结果进行了比较。结果表明,本文方法能得到满意的结果,且未出现不规则频率现象。     

深井降水技术在火力发电厂复杂地质工程中的应用

文章介绍了深井降水技术在安庆发电厂复杂地质条件下的应用,分析了在复杂地质条件下大面积深基坑降水的工程经验,总结得出降水场地的地质条件决定了降水方案的选择,并结合主厂房深基坑降水的施工过程,对深井降水技术做进一步的阐述及探讨,为类似深基坑降水施工提供经验和技术依据.