Modeling and Analysis of a Long Thin Conducting Stripline

A long thin conducting stripline embedded in a dielectric and centered between two large conducting plates, i.e., the stripline environment, is considered. The stripline is modeled as infinitely long, infinitely thin, and perfectly conducting by first considering a stripline of finite length, thickness, and conductivity in a dielectric layer. Starting from Maxwell's equations and assuming that the current on the stripline is a propagating wave in length direction, asymptotic expressions for the fields inside and in the neighbourhood of the stripline are deduced. These expressions are used to model the stripline in the stripline environment, which leads to a boundary-value problem for the electric potential. This problem is solved by two different approaches, leading to integral equations for the current and for an auxiliary function describing the electric potential. A relation between the current and the auxiliary function is deduced, which is used to obtain asymptotic expressions for current and impedance. Results are compared with a numerical solution of the integral equation for the current and with results in literature.     

Stabilization of fixed modes in expansions of LTI systems

The objective of this note is to propose a method for stabilization of structurally fixed modes in expansions of LTI dynamic systems in the scope of overlapping decentralized control design based on the expansion/contraction framework, enabling successful design for a broader class of problems than considered so far. The method is based on a judicious choice of complementary matrices in the expanded space. Numerical examples are provided to illustrate simplicity and efficiency of the proposed approach.     

Operation of superconducting fault current limiter using vacuum interrupter driven by electromagnetic repulsion force for commutating switch

Using conventional high‐temperature superconducting wire, a model superconducting fault current limiter (SFCL) is made and tested. Solenoid coil using Bi2223 silver sheath wire is so made that inductance is as small as possible and a vacuum interrupter is connected in series to it. A conventional reactor coil is connected in parallel. When the fault current flows in this equipment, superconducting wire is quenched and current is transferred into the parallel coil because of voltage drop of superconducting wire. This large current in parallel coil actuates magnetic repulsion mechanism of vacuum interrupter. Due to opening of vacuum interrupter, the current in superconducting wire is broken. By using this equipment, current flow time in superconducting wire can be easily minimized. On the other hand, the fault current is also easily limited by large reactance of parallel coil. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(1): 52–61, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20315     

天津独流减河工程监控系统现地通信单元设计

提出一种配电网电容电流测量的新方法，在零序电压互感器的开口三角侧串联一个可调电感，通过注入一个变频恒流信号寻找配电网的谐振频率，改变可调电感的数值后寻找另一谐振频率，联立2个谐振方程求解电容电流，该方法消除了电压互感器漏抗对测量的影响。开发了配电网电容电流测量仪，经模拟试验和现场测试表明，该方法具有安全、快捷、准确等特点，适用于中性点不接地或经随调式消弧线圈接地配电网。     

Electrochemical mass transfer between an impinging jet and a rotating disk in a confined system

This paper presents the mass transfer results from an impinging liquid jet to a rotating disk. The mass transfer coefficients were measured using the electrochemical limiting diffusion current technique (ELDCT). Rotational Reynolds number (Re_r) in the range of 3.4 × 10⁴–1.2 × 10⁵, jet Reynolds number (Re_j) 1.7 × 10⁴–5.3 × 10⁴ and non-dimensional jet-to-disk spacing (H/d) 2–8 were taken into consideration as parameters. It was found that the jet impingement resulted in a substantial enhancement in the mass transfer compared to the case of the rotating disk without jet.     

Investigation on vapor-cooled current leads operating in a pulse mode

This paper describes transient numerical modeling for thermal characteristic of vapor-cooled current leads under pulse operation. The transient thermal analysis considers the temperature difference between a helium gas flow and a copper lead with temperature dependent properties of helium gas, copper and stainless steel. The numerical analysis was validated by an experiment with commercially available 100 A vapor-cooled current leads. A proper overloading factor calculation and the effect of intermediate cooling are presented for the current leads under pulse operation, which can significantly reduce heat input to a cryostat.     

Singular Trajectories in Multi-Input Time-Optimal Problems: Application to Controlled Mechanical Systems

This paper deals with the time-optimal control problem for a class of control systems which includes controlled mechanical systems with possible dissipation terms. The Lie algebras associated with such mechanical systems have certain special properties. These properties are explored and used in conjunction with the Pontryagin maximum principle to determine the structure of singular extremals and, in particular, time-optimal trajectories. The theory is illustrated by an application to a time-optimal problem for a class of underwater vehicles.     

阳平关砂金矿精选厂尾矿综合回收的研究

本文详细的介绍了陕西省阳平关砂金矿精选厂尾矿金和其他可利用的矿物综合回收方法和最佳分选流程。     

新型迷宫式气锚及其应用

新型迷宫式气锚将重力分离原理和离心分离原理有机地结合在一起，其基本型气锚主要由上、下两级组成。上级为离心式螺旋气锚，下级为重力分离式和离心分离式综合气锚，可使油气流经同一长度锚筒时，达到双倍的分离效果。可根据油井气量的大小（气液比值）组成任意级数，实现油气的高效分离。还可对低产能井、沉没度易出现负值的油井进行油气分离，维持油井一定时间的生产。现场28口井的应用表明，新型迷宫式气锚油气分离效果理想，能有效地提高泵效，平均泵效由原来的28．9％提高到43．8％。     

我国清洁代用燃料汽车发展状况

随着汽车数量的迅速增加，汽车排放的有害废气也急剧增加，人们的健康受到威胁，解决这一问题的最好办法是发展清洁代用燃料汽车。介绍了天然气汽车和液化石油气汽车的主要优点，分析了目前我国清洁代用燃料汽车的发展现状，阐述了近期适宜发展我国清洁代用燃料汽车的机遇和面临的困难。最后就提高人们的环保意识、修改和完善汽车尾气污染控制法及排放标准、清洁代用燃料汽车的有关标准和安全措施。对发展这种汽车应给予优惠政策以及零部件生产和车辆改装企业的管理等方面，提出了建议。