Thermal design method of bayonet-tube evaporators and condensers

The paper describes an effectiveness-NTU design method of bayonet-tube evaporators and condensers. Including the effect of the wall superheat on the shell-side film coefficient, and using an energy balance on the tube, differential equations for the steady-state fluid temperatures are formulated. Because of the nonlinear nature of the governing equations, the fourth-order Runge-Kutta method is employed to the solution of the finite difference equations. The results are iterated with the combination of integration techniques. An upper bound to the numerical error being ±5% the fluid temperature distribution as well as the exchanger effectiveness are determined, and presented as a function of the Hurd number, the number of heat transfer units and the flow arrangement. For flow entering through the inner tube, the temperature distribution displays the occurrence of a minimum at a point other than the tube-tip of the exchanger. In an extension of the analysis, an effort is made to illustrate the deviation of the results obtained by uniform film coefficient from the present study, and the differences are outlined.     

Modified atmosphere packaging of a mixed prepared vegetable salad dish

The aim of this study was to design a modified atmosphere package for a mixed vegetable salad consisting of 75 g of cut carrot, 55 g of cut cucumber, 20 g of sliced garlic and 50 g of whole green pepper. Respiration data of all the components were combined with film permeability data to predict package atmospheres and design optimal packages for experimental testing for improved shelf-life of the produce. The optimal package avoided minimum O₂ and maximum CO₂ tolerance limits, and chilling injury temperatures for any component. A pouch form package made of 27 mm low density polyethylene developed a modified atmosphere of 2.0–2.1% O₂ and 5.5–5.7% CO₂, which was beneficial for all components and provided better quality retention than other test packages.     

Selecting a waste management option using a life-cycle analysis approach

Solid-waste management, and in particular the disposal of used packaging, is currently the subject of much topical debate. This is driven by both consumer and legislative pressures. Consumers see used packaging as a highly visible element of municipal solid waste, complaining of excessive packaging and low levels of recycling. Legislators, perhaps in pandering to the views expressed by consumer bodies, have been active within the CEC and individual Member States by introducing (or proposing) legislation or similar regulatory tools and targets to facilitate a greater diversion of used packaging from disposal by landfill to alternative solid-waste management practices, in particular recycling, which are widely accepted to have a lower impact on the environment. In this paper the relative environmental profiles of pursuing alternative solid-waste management practices to disposal by landfill are explored, focusing not just on solid waste per se but also on associated considerations of energy consumption and emissions, which are invariably overlooked as factors contributing to the environmental impact of solid-waste management practices.     

Prediction of Final Product Properties After Cocurrent Spray Drying

The effect of drying and atomization conditions on the physical properties of powders for agglomerate-like materials and skin-forming material are studied in this article. A neural model is used for powder bulk and tapped density predictions.     

清代皇家园林规划设计控制的量化研究——以圆明三园、清漪园为例

本文通过量化分析探索了清代皇家园林规划设计的控制规律及相关理论。     

暖通空调工程设计常见问题

通过对施工图审查工作进行总结，指出了暖通空调和防火防排烟设计中存在的问题及防火规范本身的一些不足。     

A limit analysis of nonlinear elastic lateral displacements of thin-walled reinforced and prestressed beams

An incremental iterative process based on direct energy minimization is presented for a limit analysis of nonlinear elastic lateral displacements and twists of reinforced and prestressed beams. Problems encountered with the constitutive relations are discussed and two possible material models are presented.