全文获取类型
收费全文 | 241114篇 |
免费 | 19623篇 |
国内免费 | 13255篇 |
专业分类
电工技术 | 35270篇 |
技术理论 | 22篇 |
综合类 | 27008篇 |
化学工业 | 11926篇 |
金属工艺 | 8149篇 |
机械仪表 | 19245篇 |
建筑科学 | 26768篇 |
矿业工程 | 10111篇 |
能源动力 | 8965篇 |
轻工业 | 5603篇 |
水利工程 | 7831篇 |
石油天然气 | 7024篇 |
武器工业 | 3894篇 |
无线电 | 23800篇 |
一般工业技术 | 12751篇 |
冶金工业 | 7478篇 |
原子能技术 | 2493篇 |
自动化技术 | 55654篇 |
出版年
2024年 | 804篇 |
2023年 | 2115篇 |
2022年 | 4340篇 |
2021年 | 5483篇 |
2020年 | 5868篇 |
2019年 | 4214篇 |
2018年 | 3976篇 |
2017年 | 5581篇 |
2016年 | 6613篇 |
2015年 | 7791篇 |
2014年 | 15137篇 |
2013年 | 12631篇 |
2012年 | 17798篇 |
2011年 | 18951篇 |
2010年 | 14462篇 |
2009年 | 14449篇 |
2008年 | 14696篇 |
2007年 | 18771篇 |
2006年 | 16876篇 |
2005年 | 15083篇 |
2004年 | 12246篇 |
2003年 | 11075篇 |
2002年 | 8450篇 |
2001年 | 7105篇 |
2000年 | 5922篇 |
1999年 | 4810篇 |
1998年 | 3571篇 |
1997年 | 2937篇 |
1996年 | 2566篇 |
1995年 | 2163篇 |
1994年 | 1799篇 |
1993年 | 1240篇 |
1992年 | 1027篇 |
1991年 | 748篇 |
1990年 | 583篇 |
1989年 | 494篇 |
1988年 | 360篇 |
1987年 | 209篇 |
1986年 | 129篇 |
1985年 | 145篇 |
1984年 | 134篇 |
1983年 | 121篇 |
1982年 | 87篇 |
1981年 | 69篇 |
1980年 | 69篇 |
1979年 | 51篇 |
1978年 | 36篇 |
1977年 | 28篇 |
1976年 | 27篇 |
1959年 | 27篇 |
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
51.
针对高可靠度机载多余度EWIS各组成部分寿命服从指数分布但参数未知的情况,提出采用无失效数据可靠度分析方法评估EWIS的可靠度水平。通过Monte-Carlo仿真方法对连接形式为“先并联、后串联”EWIS各组成部分寿命进行抽样,利用“最小最大值”方法获得系统寿命的抽样值,用概率纸检验法初步判断EWIS寿命是否服从威布尔分布,再用Pearson拟合优度检验法判断EWIS寿命是否服从威布尔分布。结合无故障飞行时间的样本值与EWIS寿命服从威布尔分布的假设,采用无失效数据分析方法评估EWIS的可靠度水平。研究方法对机载多余度EWIS无失效数据可靠度分析有一定的贡献。 相似文献
52.
马尔可夫跳变线性系统(MJLS)是一种具有多个模态的随机系统,系统在各个模态之间的跳变转移由一组马尔可夫链来决定。MJLS模型因其在表示过程中可以产生突变而更能精确的描述实际工程应用中的系统。近年来,MJLS的最优控制问题成为了研究的热点,动态规划、极大值原理以及线性矩阵不等式等成为了解决此类问题的主流方法。本文对MJLS最优控制领域的研究现状进行了综述。分别对一般情况下、带有噪声的情况下、带有时滞的情况下以及某些特定情况下的MLJS最优控制问题的国内外研究现状进行论述。最后进行了总结并提出MJLS最优控制领域未来值得关注的研究方向。 相似文献
53.
Insider trading is a kind of criminal behavior in stock market by using nonpublic information. In recent years, it has become the major illegal activity in China’s stock market. In this study, a combination approach of GBDT (Gradient Boosting Decision Tree) and DE (Differential Evolution) is proposed to identify insider trading activities by using data of relevant indicators. First, insider trading samples occurred from year 2007 to 2017 and corresponding non-insider trading samples are collected. Next, the proposed method is trained by the GBDT, and initial parameters of the GBDT are optimized by the DE. Finally, out-of-samples are classified by the trained GBDT–DE model and its performances are evaluated. The experiment results show that our proposed method performed the best for insider trading identification under time window length of ninety days, indicating the relevant indicators under 90-days time window length are relatively more useful. Additionally, under all three time window lengths, relative importance result shows that several indicators are consistently crucial for insider trading identification. Furthermore, the proposed approach significantly outperforms other benchmark methods, demonstrating that it could be applied as an intelligent system to improve identification accuracy and efficiency for insider trading regulation in China stock market. 相似文献
54.
匡红云 《上海第二工业大学学报》2019,(4):298-303
澳大利亚职业教育在全球享有较高的声誉,这与其坚持严格的"基于能力本位的评估"(competency based assessment, CBA)密不可分。介绍了澳大利亚CBA的内涵特征,并详细描述"准备评估、开发评估工具、开展评估、对评估结果进行评估"的CBA运作过程,关注评估工具的开发和后续常规系统性检查及完善,以期对我国的高等职业教育质量评估起到启示和借鉴作用。 相似文献
55.
Self-adaptive surface measurements that can reduce data redundancy and improve time efficiency are in high demand in many fields of science and technology. For this purpose, a system implemented with Gaussian process (GP) adaptive sampling is developed. The non-parametric GP model is applied to reconstruct the topography and guide the subsequent sampling position, which is determined from the inference uncertainty estimation. A criterion is proposed to terminate the GP adaptive measurement automatically without any prior model or data of the topography. Experiments on typical surfaces validate the intelligence, adaptability, and high accuracy of the GP method along with the stabilization of the automatic iteration termination. Compared with traditional raster sampling, data redundancy is reduced and the time efficiency is improved without sacrificing the surface reconstruction accuracy. The proposed method can be implemented in other systems with similar measurement principles, thus benefitting surface characterizations. 相似文献
56.
Donghai Xu Peng Feng Yang Wang Wanpeng Yang Yu Wang Shaoyan Sun 《American Institute of Chemical Engineers》2022,68(2):e17472
Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone. 相似文献
57.
《International Journal of Hydrogen Energy》2021,46(59):30267-30287
This work aims to improve the existing monitoring systems MS for two grid-connected PV stations GCPVS of URERMS ADRAR, to eliminate its limitations. This improvement consists of developing an MS which is used for two PV stations with different configurations. This MS contains new LabVIEW-based monitoring software for visualizing real-time measured data and evaluating GCPVS performance. In addition, it illustrates the 2D and 3D real-time relationships of PV system parameters, which allow us to understand the dynamic behavior of PV system components. This developed monitoring software synchronizes also the various data acquisition units DAU of GCPVS, allowing simultaneous data access.To perform a reliable performance analysis and a comparative study of different GCPVS based on accurate measurements, the sensor's calibration is performed with its DAU. The MS autonomy is ensured by integrating developed PV-UPS. A graphical user interface is provided for the evaluation of PV-UPS performance. 相似文献
58.
针对工业控制系统传统单一检测算法模型对不同攻击类型检测率和检测速度不佳的问题,提出一种优化支持向量机和K-means++算法结合的入侵检测模型。首先利用主成分分析法(PCA)对原始数据集进行预处理,消除其相关性;其次在粒子群优化(PSO)算法的基础上加入自适应变异过程避免在训练的过程中陷入局部最优解;然后利用自适应变异粒子群优化(AMPSO)算法优化支持向量机的核函数和惩罚参数;最后利用密度中心法改进K-means算法与优化后的支持向量机组合成入侵检测模型,从而实现工业控制系统的异常检测。实验结果表明,所提方法在检测速度和对各类攻击的检测率上得到明显提升。 相似文献
59.
ABSTRACT Design and implementation of an effective dissemination programme for decentralised renewable energy system necessitate an accurate estimate of its utilisation potential. Hence, in this study, an attempt has been made to develop frameworks to estimate the utilisation potential of decentralised renewable energy systems in the state of Uttarakhand in India. Estimations imply large resource, technical and economic potentials of the domestic solar water heater, solar home system, solar lantern, family size biogas plant and improved biomass cookstove in Uttarakhand. With higher impact on the purchasing power of households, prevailing soft loan scheme has been found to be more appropriate than a capital subsidy for promoting the usage of decentralised renewable energy systems. 相似文献
60.
《Measurement》2015
In the harmonic active power measurement, the highest uncertainties are generally introduced by the current and voltage transducers. In a previous paper, the authors showed that the current transformer (CT) can introduce significant errors in such measurement, especially if the phase shift between voltage and current is close to ±90°. In such condition the errors on harmonic power measurement are mainly due to the CT phase displacement. This paper shows that better results can be achieved with more linear transducers, such as the Rogowski coil current transducers (RCCTs), whose metrological performance in distorted condition can be improved, by means of a proper compensation method. The proposed method for RCCTs compensation is based on the frequency response and it allows to reduce the errors on harmonic power measurement, also for phase shift close to ±90°. The study is supported by several experimental tests. 相似文献