同杆并架双回线基于电流突变量的综合选相

相电流差突变量选相元件在单回线故障中具有良好的选相性能，但在同杆双回线跨线故障中可能误选相。利用六序故障分量的分析方法，分析了相电流突变量在同杆双回线跨线故障中的幅值和相位特征，给出了其相位比相方程。在此基础上，提出了一种运用测量阻抗和方向元件相结合的综合选相方法，并给出了选相流程图。仿真结果表明，在双回线简单故障和跨线故障时，基于单回线单端电气量的同杆并架双回线综合选相方法具有较理想的选相性能。     

岩盐钻井水溶双井连通开采工艺的研究与推广

文章就全国井矿盐采区多年的开采工艺技术，进行了系统的研究与总结，并提出了岩盐钻井水溶开采双井连通的各种开采工艺及其关键技术，具有很强的适用性和推广价值。     

滴注式直-压淬双排渗碳线的设计及应用

详细阐述了滴注式直-压淬两用双排气体渗碳自动线的组成单元，渗碳气氛、工艺柔性化、设计特点以及工艺调试；生产实践证明：自动线运行可靠．稳定，主要技术性能和指标达到或优于国家标准。     

Layout-Specific Circuit Evaluation in 3-D Integrated Circuits

In this paper, we describe a comprehensive layout methodology for bonded three-dimensional integrated circuits (3D ICs). In bonded 3D integration technology, parts of a circuit are fabricated on different wafers, and then, the wafers are bonded with a glue layer of Cu or polymer based adhesive. Using our layout methodology, designers can layout such 3D circuits with necessary information on inter-wafer via/contact and orientation of each wafer embedded in the layout. We have implemented the layout methodology in 3DMagic. Availability of 3DMagic has led to interesting research with a wide range of layout-specific circuit evaluation, from performance comparison of 2D and 3D circuits to layout-specific reliability analyses in 3D circuits. Using 3DMagic, researchers have designed and simulated an 8-bit encryption processor mapped into 2D and 3D FPGA layouts. Moreover, the layout methodology is an essential element of our ongoing research for the framework of a novel Reliability Computer Aided Design tool, ERNI-3D.     

Lowpass and bandpass transadmittance filter using operational amplifier pole

A new topology simultaneously implementing lowpass (LP) and bandpass (BP) transadmittance filtering signals using a single operational amplifier (OA), one capacitor, and two resistors is presented. The input impedance is very high which is essential for cascading without employment of buffers. The circuit uses absolute minimum number of active and passive components. The filter employs pole-model of OA and as such has acquired suitability for extended frequency operation. The circuit permits separate adjustment of natural frequency (ω₀) and quality factor (Q) in an orthogonal manner. The circuit has low sensitivity figures unlike the reported single amplifier biquads. The PSPICE simulation results are included.     

掺Yb相移光纤光栅形成过程的分析

研究了用二次曝光法制作掺Yb相移光纤光栅的实验过程 ,并对相移光纤光栅制作过程中出现次峰的情况进行了理论分析。合理地解释了该现象     

双层堤基的井涌破坏与无害管涌

双层堤基水文地质结构特殊，堤基承压水常具独特的“渗而不流”特征。在“不流”条件下，堤后盖层薄弱处受超高承压水头顶裂破坏，产生的局部冒水孔实属承压自流井，由此形成的管涌实质为井涌。底部进水的承压井流影响范围不大，井涌的破坏范围更小，据此可区分出有害管涌与无害管涌。前者局限于堤脚附近，小范围压渗为首选方案；对后者，既无需专门防治，更不必追求根治。     

Monte-Carlo Simulation of Clocked and Non-Clocked QCA Architectures

We present a Monte Carlo simulation of two implementations of Quantum Cellular Automaton (QCA) circuits: one based on simple ground state relaxation and the other on the clocked cell scheme that has recently been proposed by Tóth and Lent. We focus on the time-dependent behavior of two basic circuits, a binary wire and a majority voting gate, and assess their maximum operating speed and temperature requirements for different sets of fabrication parameters.     

一种便于观测的信号抽样及复原方法

利用倍频器，将重复频率与连续信号ｔ（ｔ）的频率相同的方波进行若干次倍频后，对连续信号进行抽样，从而获得离散的抽样信号ｆｓ（ｔ），再利用有源低通滤波器使其复原成连续信号ｆ（ｔ）。避免了一般抽样器不便于观测的缺点。     

On the Realization of Current－Mode Continuous－Time Operational Transconductance Capacitance Filter

ＯｎｔｈｅＲｅａｌｉｚａｔｉｏｎｏｆＣｕｒｒｅｎｔ－ＭｏｄｅＣｏｎｔｉｎｕｏｕｓＴｉｍｅＯｐｅｒａｔｉｏｎａｌＴｒａｎｓｃｏｎｄｕｃｔａｎｃｅＣａｐａｃｉｔａｎｃｅＦｉｌｔｅｒ￥ＧｕｏＪｉｎｇｂｏａｎｄＨａｎＱｉｎｇｑｕａｎ（ＣｈａｎｇｃｈｕｎＰｏｓ...