制氢尾气二氧化碳回收装置设计

对制氢尾气二氧化碳的回收装置进行了简捷设计，流程分析，并对换热装置的换热量和传热面积给出了算法和有关数据。     

The initial behaviour of freshly etched copper in moderately acid, aerated chloride solutions

When freshly etched samples of various types of copper were exposed in moderately acid, aerated chloride solutions, two phenomena were observed. First the corrosion potential and the pH of the solution decreased over a shorter time, then the potential increased over a long period (600-1500 min), following an s-shaped pattern. Increase in pH during the second stage was avoided using a pH-stat. The corrosion rate increased little or not at all over the entire period. A tentative interpretation of the short-term behaviour is presented with some reservation. The long-term development of the potential suggests phase formation or transformation following the Avrami pattern. By suitable derivations it was possible to fit the development of potentials to the Avrami equation. Subsequent examinations by Auger spectroscopy proved the presence of thin layers of Cu₂O on the copper surfaces, increasing in thickness with exposure time. The dissolution kinetics can be described in terms of two parallel electrochemical reactions and a simultaneous non-electrochemical dissolution reaction.     

市内通信电缆绝缘电阻特殊要求的实现和措施

本文对市内通信电缆的各生产过程进行分析、研究和控制 ,从而提出了解决绝缘电阻特殊要求的方法 ,以及改进的措施。     

Thermal Shock Behavior of Porous Silicon Carbide Ceramics

Using the water-quenching technique, the thermal shock behavior of porous silicon carbide (SiC) ceramics was evaluated as a function of quenching temperature, quenching cycles, and specimen thickness. It is shown that the residual strength of the quenched specimens decreases gradually with increases in the quenching temperature and specimen thickness. Moreover, it was found that the fracture strength of the quenched specimens was not affected by the increase of quenching cycles. This suggests a potential advantage of porous SiC ceramics for cyclic thermal-shock applications.     

MIMO系统中的分组全分集全码率空时编码

针对未编码的多输入多输出（MIMO，Multi—Input Multi—Output）系统，提出一种复杂度适中的分组全分集全码率（GFDFR，Group—wise Full Diversity Full Rate）空时编码方案。该方案通过在发送端进行天线分组，各组独立编码，减小全分集全码率（FDFR，Full Diversity Full Rate）编码块的大小从而降低系统编解码复杂度；在频率选择性信道中，进一步对子载波分组进行独立编码，获得频率分集（或多径分集），以适中的复杂度在不降低系统分集度的情况下保证了信息的全码率传输，是一种在MIMO信道中极具实用价值的空时编码方案。     

宽带智能天线系统中的频率补偿技术

在无线通信中,智能天线系统在抑制窄带多径干扰方面具有得天独厚的优势,但是用于宽带无线通信系统中时,就需要采用频率补偿方法.重点介绍基于频谱分解、聚焦和插值算法的补偿技术,并对这3种频率补偿技术的性能进行比较,结果表明在应用补偿技术的系统中,系统性能有显著的改善,其中插值算法具有最优的性能.     

四倍频Nd：YAG激光在高压氢气中的喇曼频移研究

利用Nd:YAG固体激光器四倍频输出(266nm)在高压H₂中的受激喇曼散射获得多波长的激光输出。当泵浦能量一定时,通过改变H₂压力得到了最佳的能量输出,299nm波长的激光能量为3mJ,341nm波长的激光能量输出为6.1mJ,398nm波长的激光能量输出为2.8mJ,239nm波长的激光能量输出为0.8mJ,同时在477nm,595nm,218nm,200nm波段也有能量输出。     

Obtaining Characteristic 4f–4f Luminescence from Rare Earth Organic Chelates

We report a study of a series of heavy rare earth tris‐8‐hydroxyquinolines (REQ₃s), using UV‐visible absorption spectroscopy, infrared absorption spectroscopy, and photoluminescence (PL) measurements. We show that the heavy REQ₃s are all chemically similar to each other and to aluminium tris‐8‐hydroxyquinoline, at least in terms of the ligand behavior. Characteristic rare earth 4f–4f luminescence is only observed for ErQ₃ and YbQ₃ due to the relatively low energy of the ligand triplet state. We show that a triplet transfer mechanism cannot be responsible for the observed Yb 4f–4f luminescence observed in YbQ₃. Instead, an internal chemiluminescent process is shown to be energetically favorable. The thin film PL spectra of all the heavy REQ₃s are dominated by triplet emission, except for that of ErQ₃, for which transfer to the Er³⁺ ion represents an efficient alternative. The PL spectra of powder samples, which would be expected to consist of approximately equal amounts of both isomers, are dominated by singlet emission. This is in contrast to the results from the thin films, and suggests that the isomer which predominates in the thin films has a much higher intersystem crossing rate than the other isomer.     

UL简介与CCL认可

本文从六个方面对UL的基本知识作了一个简要的概述及CCL认可过程的介绍,希望能为业界同仁提供一个参考方向。     

非均相成核中间相炭微球的形成过程及其结构演变

以含有喹啉不溶物的煤焦油沥青为原料，在410℃、不同反应时间下获得一系列中间相炭微球(MCMB)和小于0．5μm的碳质颗粒(SCP)。通过对中间相沥青的软化点、族组成和MCMB、SCP的形貌及MCMB断面结构的分析，认为非均相成核MCMB的形成和生长过程不同于均相成核的融并生长过程，而是SCP碳质颗粒的构筑过程，我们称之为“球形基本单元构筑”过程。在MCMB生长过程中，体系的黏度对SCP的形成和MCMB的生长起着重要的作用。非均相成核MCMB的内部结构不是三种模型结构(“地球仪”型、“洋葱”型和“同心圆”型)中的任一种，而是炭层具有收缩点的复杂结构，并且球体的结构不具有“继承性”，即随着反应时间的延长而不断发生变化和调整。MCMB内部分子在球体生长过程中的主要变化趋势是分子的不断缩合长大，而不是分子片层的平行趋向。