全文获取类型
收费全文 | 30093篇 |
免费 | 2641篇 |
国内免费 | 1555篇 |
专业分类
电工技术 | 2740篇 |
技术理论 | 2篇 |
综合类 | 2522篇 |
化学工业 | 3791篇 |
金属工艺 | 894篇 |
机械仪表 | 1484篇 |
建筑科学 | 3186篇 |
矿业工程 | 1376篇 |
能源动力 | 3950篇 |
轻工业 | 1228篇 |
水利工程 | 777篇 |
石油天然气 | 1884篇 |
武器工业 | 284篇 |
无线电 | 3844篇 |
一般工业技术 | 2199篇 |
冶金工业 | 1333篇 |
原子能技术 | 520篇 |
自动化技术 | 2275篇 |
出版年
2024年 | 121篇 |
2023年 | 460篇 |
2022年 | 811篇 |
2021年 | 985篇 |
2020年 | 1061篇 |
2019年 | 920篇 |
2018年 | 859篇 |
2017年 | 1061篇 |
2016年 | 1198篇 |
2015年 | 1272篇 |
2014年 | 1995篇 |
2013年 | 1955篇 |
2012年 | 2179篇 |
2011年 | 2345篇 |
2010年 | 1798篇 |
2009年 | 1860篇 |
2008年 | 1707篇 |
2007年 | 1874篇 |
2006年 | 1705篇 |
2005年 | 1351篇 |
2004年 | 1113篇 |
2003年 | 972篇 |
2002年 | 809篇 |
2001年 | 722篇 |
2000年 | 623篇 |
1999年 | 505篇 |
1998年 | 344篇 |
1997年 | 310篇 |
1996年 | 295篇 |
1995年 | 218篇 |
1994年 | 191篇 |
1993年 | 118篇 |
1992年 | 101篇 |
1991年 | 101篇 |
1990年 | 68篇 |
1989年 | 64篇 |
1988年 | 39篇 |
1987年 | 35篇 |
1986年 | 30篇 |
1985年 | 21篇 |
1984年 | 22篇 |
1983年 | 13篇 |
1982年 | 16篇 |
1981年 | 15篇 |
1979年 | 3篇 |
1978年 | 3篇 |
1959年 | 3篇 |
1956年 | 2篇 |
1955年 | 3篇 |
1951年 | 3篇 |
排序方式: 共有10000条查询结果,搜索用时 0 毫秒
101.
Alternative hydrocarbon solvents for cottonseed extraction 总被引:3,自引:0,他引:3
P. J. Wan D. R. Pakarinen R. J. Hron Sr. O. L. Richard E. J. Conkerton 《Journal of the American Oil Chemists' Society》1995,72(6):653-659
Hexane has been used for decades to extract edible oil from cottonseed. However, due to increased regulations affecting hexane
because of the 1990 Clean Air Act and potential health risks, the oil-extraction industry urgently needs alternative hydrocarbon
solvents to replace hexane. Five solvents,n-heptane, isohexane, neohexane, cyclohexane, and cylopentane, were compared with commercial hexane using a benchscale extractor.
The extractions were done with a solvent to cottonseed flake ratio of 5.5 to 1 (w/w) and a miscella recycle flow rate of 36
mL/min/sq cm (9 gal/min/sq ft) at a temperature of 10 to 45°C below the boiling point of the solvent. After a 10-min single-stage
extraction, commercial hexane removed 100% of the oil from the flakes at 55°C; heptane extracted 100% at 75°C and 95.9% at
55°C; isohexane extracted 93.1% at 45°C; while cyclopentane, cyclohexane, and neohexane removed 93.3, 89.4, and 89.6% at 35,
55, and 35°C, respectively. Each solvent removed gossypol from cottonseed flakes at a different rate, with cyclopentane being
most and neohexane least effective. Based on the bench-scale extraction results and the availability of these candidate solvents,
heptane and isohexane are the alternative hydrocarbon solvents most likely to replace hexane.
Presented in part at the AOCS Annual Meeting & Expo, Atlanta, Georgia, May 1994. 相似文献
102.
微波促进有机反应原理及微波有机合成仪 总被引:4,自引:0,他引:4
论述了微波促进有机反应的原理和微波加热的特点.对目前使用的家用微波炉和专用微波有机合成仪的性能进行了评价.指出微波促进有机反应需要解决的问题及我国应加强对该领域的研究. 相似文献
103.
本文对模拟的含酚废水,采用新型技术对乳状液膜法脱酚进行了进一步的探讨。对所采用的制乳设备———撞击流-旋转填料床对制乳率、提取设备———旋转填料床对脱酚率、破乳设备———无机微孔膜法破乳的重要参数(如透过压方式、膜孔径等对膜通量和破乳率的影响)进行了研究。并且讨论了破乳后的油相回用情况。实验结果表明:撞击流-旋转填料床的制乳效率可达99.90 %以上,脱酚率可达99%左右,且瞬间完成;膜孔径越小,破乳率越高,膜通量越小;外压内抽方式的破乳效果优于单外压方式的破乳效果。对于粒径为5~2 5 μm乳液,用膜孔径为2 .0 μm的SiC微孔膜,在外压为6 0kPa、内负压为30kPa的外压内抽破乳方式下破乳,破乳率可达96 .4 % ,膜通量可达90 0L·(m2 ·h) -1。 相似文献
104.
105.
Schaefer-Sindlinger A. Lappas I. Vogt C. D. Ito T. Kurachi H. Makino M. Takahashi A. 《Topics in Catalysis》2007,42(1-4):307-317
This paper will give an overview about the filter development for diesel particulate emission control in automotive applications.
The material development for passenger car diesel particulate filters led to new materials like silicon carbide while for
heavy duty applications still Cordierite plays a major role. But in the future other materials might also be used for passenger
cars. This paper will show the basic difference between both applications and describe the material design in terms of filter
properties (base material, back pressure aspects, filtration efficiency, coating impact). Current application on vehicles
with catalysed soot filters (CSF) with and without oxidation catalyst will be presented. Furthermore an outlook will be given
on materials for catalysed soot filters for the future. 相似文献
106.
采用高压催化剂性能评价实验装置,在压力分别为7.0,10.0和15.0MPa,温度分别为350,400和450℃条件下,在H2/N2为1.6-3.0范围内研究了H2/N2对A301,ZA-5和A110-2型催化剂的活性和合成塔出口氨浓度的影响。在压力和空速一定的条件下,最佳H2/N2随反应温度而异。在350,400和450℃下,最佳H2/N2分别为1.8-2.2,2.2-2.5和2.5-3.0。由此可见,合成氨反应的速率达到最大值时的最佳H2/N2值与反应的进程有关。为此提出了催化剂效率K(Catalysis efficiency)的概念来表征在催化剂作用下反应器出口氨浓度趋近平衡的程度,即K=CNH3/C^*NH3。根据实验结果,得到了最佳H2/N2与催化剂效率的定量关系:(H2/N2)m=1.5(1 CNH3/C^*NH3)=1.5(1 K)。由此可以根据催化剂在不同反应条件下的催化剂效率来确定最佳H2/N2。凡是会降低催化剂效率的因素,都会使最佳H2/N2降低。各种影响因素对最佳H2/N2的影响中,反应温度的影响最大,其次是空速和催化剂的活性,而压力和惰性气体含量的影响相对较小。在低温(低压)下合成氨,宜采用较低的H2/N2。 相似文献
107.
108.
J. H. M. Scholten 《Nutrient Cycling in Agroecosystems》1992,33(2):107-114
To increase the fertilizer-N efficiency in lowland rice (Oryza sativa L.) cultivation, new management practices are needed. Main cause of the present low efficiency is the low N recovery by plants, as a considerable part of the N applied is lost; deep placement techniques improve the recovery. A pneumatic injector, with which urea prills can be point-placed at a depth of 5–10 cm in paddy soils, was tested in 38 on-farm trials in 1989/90, mostly during the wet season. The experiments, located in Africa and Asia, focussed on differences in grain yield between conventional methods of broadcasting urea and injection by the pneumatic injector, at recommended N-rates. The study shows that the pneumatic injector is effective as a tool to improve the N fertilizer efficiency. The average yield increases per region, resulting from the use of the injector, ranged from about 250 to 1300 kg grain ha–1. The value of the yield increase would allow most farmers to recover the costs of the injector within one season, even if labour was hired to carry out the injections. The average labour requirement of the injector was 40 hours ha–1. In Indonesia, injection of prilled urea gave yields similar to those obtained with urea briquettes. 相似文献
109.
C. Tuve' R. Potenza M. Chiorboli M.G. Grimaldi F. La Rosa F. Raimondo M. Marinelli E. Milani A. Tucciarone G. Verona Rinati M. Donato G. Faggio G. Messina S. Santangelo G. Pucella 《Diamond and Related Materials》2006,15(11-12):1986
Polycrystalline (pCVD) and single crystal (scCVD) diamond films grown from Chemical Vapour Deposition (CVD), if sufficiently pure at Raman analysis, are very good materials for beam or flux monitors inside accelerators or nuclear reactors. This is because they are very hard to damage in high radiation fields and very resistant to high temperatures. Films of pCVD diamond are, however, not so good as spectroscopy detectors due to inhomogeneities induced by their growth in grains with the consequent presence of grain boundaries which worsen their energy resolution. The latter can be significantly improved by growing scCVD diamond films onto HPHT synthetic diamond substrates. We have shown that it is possible to measure the density of defects inside diamond specimens using as probes suitable penetrating nuclear radiations. With the preliminary results reported here we'll show that, bombarding CVD diamond films grown at Roma “Tor Vergata” with energetic protons and 4He, 6Li and 12C ions produced in the accelerators of Catania laboratories, the pulse height defects are higher than those in silicon detectors and likewise well described by a power law in the deposited energy. Furthermore, we'll show that pulse heights for the same particles seem to depend on the duration of the measurement, thus exhibiting a sort of depolarization of the insulator when exposed to the electric voltage which makes it a particle detector. 相似文献
110.
The design of barbotage‐rotation installation with different profiles of blades of the rotator has been created on the basis of modeling method. As a result of the complexity of aerohydrodynamic research in the system “gas–liquid” carried out on the aforementioned unit, certain recommendations on the improvement of the construction and operating conditions have been developed with a view to rise the effectiveness of dust removal. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 101: 3357–3360, 2006 相似文献