二元稀土系AB5型贮氢电极合金的放电容量与晶胞体积和4f电子浓度的关系

制备了6个系列通式为AαA‘1-αB5的RE(NiCoMnTi)5贮氢电极合金(其中，AαA‘1-α为La，Ce，Pr，Nd4个元素中任意2个的组合)，测定了它们在100次循环中的最大放电容量Cmax及部分合金的晶胞体积Vcell．结果表明：Cmax主要由Vcell决定，Cmax先随Vcell的增大而增加，在Vcell≈85．66x10^-^3。nm^3时达到一极大值，然后又随Vcell的增大而减小；同时，Cmax还与4f电子浓度ne4f／naRE有关，A侧具有相同4f电子浓度的合金其Cmax随4f电子浓度的变化趋势相似．     

Hyperhomocysteinemia and Cardiovascular Disease: Is the Adenosinergic System the Missing Link?

The influence of hyperhomocysteinemia (HHCy) on cardiovascular disease (CVD) remains unclear. HHCy is associated with inflammation and atherosclerosis, and it is an independent risk factor for CVD, stroke and myocardial infarction. However, homocysteine (HCy)-lowering therapy does not affect the inflammatory state of CVD patients, and it has little influence on cardiovascular risk. The HCy degradation product hydrogen sulfide (H₂S) is a cardioprotector. Previous research proposed a positive role of H₂S in the cardiovascular system, and we discuss some recent data suggesting that HHCy worsens CVD by increasing the production of H₂S, which decreases the expression of adenosine A_2A receptors on the surface of immune and cardiovascular cells to cause inflammation and ischemia, respectively.     

多孔纤维型重整微反应器的等效电阻网络建模

针对应用于重整制氢微反应器的复杂多孔金属纤维载体（PFS）的流速场高效分析难题,建立载体中随机微通道的等效电阻网络分析模型. 基于复杂随机纤维结构的统计网络模型,将纤维载体中三维联通的随机微通道结构及与之相连的进出口腔简化为规则的网络通道结构.借鉴基尔霍夫定律,建立纤维载体的等效电阻网络模型,并确定求解方法. 纤维载体流速场实例分析的结果表明,基于等效电阻网络模型求解的纤维载体流速场与计算流体力学(CFD)方法的结果之间的皮尔森相关系数约为98%,且求解效率约为CFD方法的2.9×10⁴倍. 研究成果为多孔纤维型重整制氢微反应器的设计制造提供了新的支撑方案.     

Structural stability of single-layered LaNi4.25Al0.75 film and its electrochemical hydrogen-storage properties

AB5-based hydrogen storage thin fdms （LaNi4.25Al0.75）, deposited on Cu substrate by dc magnetron sputtering were investigated in this study. X-ray diffraction （XRD） revealed that the microstructure of the layer was in crystal form. SEM and AFM analyses proved that the film appeared to be rather rough with numerous randomly sized pores of approximately 15-40 in nm diameter. Structural stability of the film was examined by the combined analyses of DSC, XRD, and SEM, which indicated that this film maintained its structural stability below 500 K or so, and a network structure was observed on the film after being heated at 700 K for 30 min. Electrochemical hydrogen-storage properties of the films were investigated by simulated battery tests. It was found that single-layered LaNi4.25A10.75 film exhibited electrochemical hydrogen-storage properties similar to typical AB5 alloys in bulk, and the maximum discharge capacity of the film was about 220 mAh/g. After 20 charge/discharge cycles, small needle-shaped aluminium oxide was formed on some fractions of the film surface.     

基于演化算法的奇偶校验器自动设计*

基于演化算法技术,提出一种新的设计思想,实现奇偶校验器的电路自动设计.实验证明,多目标演化算法具有较少的运算量和较高的效率,能自动设计出使用逻辑门数更少、延时更小的奇偶校验器.     

多样性制导分段进化的基因表达式编程

为了解决基于传统基因表达式编程（GEP）的函数挖掘及其改进算法仍然存在局部优化的缺陷这一问题,提出了以基因组多样性制导的分阶段进化挖掘算法DGGEP。给出了GEP 进化阶段和基因组多样性评估模式的定义;提出了描述进化阶段的进化因子概念和分阶段进化策略;采用动态遗传算子设计和群体规模控制方法,使进化更快速跳出局部最优。实验表明了新算法的有效性,能减少进化停滞代数65％以上,使群体的平均适应度提高12%以上。     

多孔普鲁士蓝类似物的合成及电催化析氧性能

采用一种简单易行的共沉淀法合成了前驱体镍铁普鲁士蓝类似物NiFe-PBA（NF）,然后通过溶剂热处理获得了镍铁普鲁士蓝纳米多孔材料（NFP）。通过XRD、SEM、TEM、XPS、BET及电化学方法对所得材料进行了结构表征和析氧性能测试。结果表明,NFP相对于前驱体NF,电化学比表面积增大、催化活性位点增多,电催化析氧反应（OER）性能显著提高。在浓度1 mol/L KOH水溶液中,达到10 mA/cm2电流密度时,NFP所需过电位仅为260 mV,比NF（320 mV）前驱体低18.75%,也优于大多数已报道的非贵金属催化剂和商用贵金属催化剂,显示出良好的应用前景。     

Hydrogen Sulfide Metabolite,Sodium Thiosulfate: Clinical Applications and Underlying Molecular Mechanisms

Thiosulfate in the form of sodium thiosulfate (STS) is a major oxidation product of hydrogen sulfide (H₂S), an endogenous signaling molecule and the third member of the gasotransmitter family. STS is currently used in the clinical treatment of acute cyanide poisoning, cisplatin toxicities in cancer therapy, and calciphylaxis in dialysis patients. Burgeoning evidence show that STS has antioxidant and anti-inflammatory properties, making it a potential therapeutic candidate molecule that can target multiple molecular pathways in various diseases and drug-induced toxicities. This review discusses the biochemical and molecular pathways in the generation of STS from H₂S, its clinical usefulness, and potential clinical applications, as well as the molecular mechanisms underlying these clinical applications and a future perspective in kidney transplantation.     

Microstructure evolution of cold-sprayed coating during deposition and through post-spraying heat treatment

The microstructural features of cold-sprayed coatings were investigated using Cu, Ti and Zn feedstocks by optical microscopy, scanning electron microscopy and transmission electron microscopy to reveal the microstructure evolution mechanisms in cold spray. Four typical effects including tamping, refinement, impact-induced fusion and annealing were examined on microstrueture. It is found that the microstructure of cold spray coating is remarkably influenced by spray materials. Ti coatings consist of evident porous layer and Cu coatings present a limited porous layer only near the surface. It is clear that the successive tamping effect and dynamic refinement of grains significantly influence the microstructure evolution of cold-sprayed coating. The tamping effect leads to the densification of porous coating layer gradually and the refinement effect leads to the formation of fine microstructure. It is considered that the large difference in the formation of porous layer is attributed to the dynamic impact pressure and hardenability of materials. It is also found that the impact-induced fusion during deposition of Zn coating can also modify the interfacial microstructure between particles in cold spray coating. Moreover, the nanocrystalline phase can be formed at the interfaces among particles resulting from the localized melting of the interfaces and tamping effect. Furthermore, the annealing treatment can modify the microstructure and property of a cold-sprayed coating.