柴达木盆地天然气中稀有气体同位素特征

为了确定柴达木盆地勘探新层系，测试并分析了该盆地5个油气田的8个天然气样品的氦、氩同位素比值，探讨了其在大地构造背景、大地热流和气源方面的示踪意义。研究结果如下：①柴达木盆地8个天然气样品³He/⁴He值分布在2.0×10^-8～5.48×10^-8的范围，总体平均为3.7×10^-8，均在10^-8量级，体现了典型的壳源成因氦同位素的特征。②据³He/⁴He计算的大地热流值较低，分布于41.2~48.2 mW/m²之间，平均44.9 mW/m²，低于东部地区大地热流平均值73 mW/m²，表明该盆地具有较稳定的构造背景。③根据天然气⁴⁰Ar/³⁶Ar的年代积累效应，结合烃源岩分布特征推测，柴达木盆地东部凹陷区伊克雅乌汝构造伊深1井天然气应源于上第三系；西部坳陷区尕斯油田尕斯8-6井和尕斯475井天然气应源于下第三系；碱山构造碱1井天然气应源于侏罗系，碱山构造碱2井的天然气应源于上第三系；北缘块断带南八仙油气田仙试1井的天然气应源于侏罗系；南八仙油气田仙试8井和马北构造马北1井的天然气可能主要源于侏罗系。     

Dielectric Resonators for the Measurement of Superconductor Thin Films Surface Impedance in Magnetic Fields at High Microwave Frequencies

We present the design and realization of cylindrical dielectric resonators operating in the 40–60 GHz frequency range, designed for the measurement of the surface resistance and of the surface reactance shift in High-T _c Superconductors (HTS) thin films in a dc magnetic field. The resonators are single tone, based on the TE ₀₁₁ mode, and multiple tone, the latter allowing in principle to exploit the simultaneous determination of the surface impedance at different frequencies. As an application example, we report the temperature and field dependencies of the effective surface impedance of some cuprate superconductors thin films. The results are compared with those obtained through the use of a standard metal cavity with a similar Q-factor and operating in the same frequency range. The comparison highlights a superior stability and a higher sensitivity, resulting in an increase of about two orders of magnitude in the resolution of the surface impedance measurement. By contrast, the dissipative part of the superconducting transition (above T/T _c = 0.97) is better studied with the metal cavity. We also present measurements in the vortex state in YBaCa₂Cu₃O_7−δ and Tl₂Ba₂CaCu₂O_8+x that show significantly different physics. PACS: 74.25 Nf.     

以外供液氮替代膨胀机的深度冷冻循环

介绍空分制氮装置采用膨胀机循环与液氮循环的两种工艺流程及能量平衡 ,示出了两种循环的实例比较。指出外供液氮可以作为冷源替代膨胀机 ,且单耗低、操作更方便 ,设备维护量更小、氮气提取率更高     

云南东川泥石流沟与非泥石流沟~(137)Cs示踪法物源研究

运用1 37Cs示踪法调查云南东川小江流域 6条泥石流沟、6条非泥石流沟和主河的泥沙来源。泥沙主要来源于冲沟侵蚀和滑坡崩塌堆积、坡耕地和草地。坡耕地和草地表层土壤1 37Cs平均含量分别为 0 9Bq m2 和1 98Bq m2 ,冲沟沟壁和滑坡崩塌堆积土体1 37Cs。作者通过 3种源地土体1 37Cs含量的比较 ,分析了细粒泥沙(<0 0 1mm)的来源。 6条泥石流沟冲沟侵蚀和重力侵蚀 (滑坡崩塌 )的相对产沙量变化于 90 2 %～ 1 0 0 % ,平均值为 95 1 % ,6条非泥石流沟的相对产沙量变化于 74 5 %～ 83 3% ,平均值为 78 9%。小江主河为 81 4 %。     

局部散射源参数估计的非线性算子方法

本文利用单次快摄数据的两个非线性算子估计局部散射源中心波达方向和角扩展,与多维参数搜索和其他低复杂性的局部散射源参数估计算法不同,非线性算子方法给出了单次快摄的局部散射源参数估计的闭式解,无需进行多维搜索和子空间分解。     

C51嵌套汇编子程序在阻抗测试仪研制中的应用

C51嵌套汇编子程序，充分发挥了两种语言自的优势，介绍了C51调用汇编子程序的接品规则，并通过阻抗测试仪程序开发的例子予以详细说明。     

膜-粉末炭反应器净化微污染源水

采用膜-粉末炭反应器处理微污染源水的试验结果表明,该工艺对水中的有机物具有较好的净化效果,在水温《10℃的条件下,处理可生化性很低的三家店水库水时对CODMn的去除率仍保持在65%左右;工艺对CODMn、UV254、UV410的去除效果依次增强.     

Effect of epitaxial realignment on the leakage behavior of arsenic-implanted,as-deposited polycrystalline Si-on-single crystal Si diodes

When dopants are indiffused from a heavily implanted polycrystalline silicon film deposited on a silicon substrate, high thermal budget annealing can cause the interfacial “native” oxide at the polycrystalline silicon-single crystal silicon interface to break up into oxide clusters, causing epitaxial realignment of the polycrystalline silicon layer with respect to the silicon substrate. Anomalous transient enhanced diffusion occurs during epitaxial realignment and this has adverse effects on the leakage characteristics of the shallow junctions formed in the silicon substrate using this technique. The degradation in the leakage current is mainly due to increased generation-recombination in the depletion region because of defect injection from the interface.     

沈阳太平洋广场空调冷热源方案比较

对一幢１１．５万ｍ＾２的四星级综合建筑的空调冷热源不同的蓄冷和取冷比较了四种方案，论证了其中直燃型溴化锂吸收式冷热水机组供冷供暖、小型燃油锅炉供蒸汽的方案最为合理。     

How to Control Robots Interacting with Dynamic Environment

The goal of this paper is to shed light on the control problem of constrained robot motion from the aspect of the dynamical nature of the environment with which the robot is in contact. Therefore, the criticism of traditional hybrid control which allows position/force feedback loops to split into independent control with respect to position and force, is not the main point we want to make. Reference to the papers written by the founders of hybrid control and their numerous followers served only to better understand the reason and motivation for suggesting a different approach to control of robots interacting with environment.The paper has a predominantly review character, based on recently published work. It also contains some new, unpublished results in the framework of the unified approach to the position/force control of robots, proposed by the present author and his co-workers. By pointing to the possibility of introducing an environment dynamics in the contact tasks of the machining type, the author emphasizes that the proposed dynamically interactive control can be applied to a completely different class of tasks, in which a contact is made between the system (constructions or structure) and very specific kinds of dynamic environments.