榆林气田气井废弃条件的确定

榆林气田是典型的低渗透气田，要准确计算其采收率和可采储量，必需确定气井的废弃条件。传统方法对气井的废弃地层压力进行计算时，由于忽视了开发过程中产能方程的变化，造成计算结果存在一定的误差。根据气井废弃地层压力的相关理论和计算方法，考虑了对气井产能方程影响较大的参数的变化，结合榆林气田气井矿场实际，推导出了适合榆林气田计算气井任意时刻二项式方程系数的公式，进而得到气井废弃时的稳定二项式方程。根据垂直管流法计算得到废弃井底流压，从而得到可靠的气井废弃地层压力，再结合经济评价即可确定气井的废弃产量。实例计算表明，新方法实用、有效，更切合气田实际。     

用屏蔽暂堵技术封堵水平井裂缝性漏层

克拉玛依油田HW702水平井的大斜度段和水平段,将穿越纵向裂缝发育的二叠系佳木河组储层。为安全钻进和保护油层,用超细碳酸钙和磺化沥青复配后加入复合离子钻井液中成屏蔽暂堵的堵漏钻井液。室内用岩心试验,屏蔽暂堵后渗透率可降为0,暂堵深度小于3cm,可用酸化和射孔解堵。现场使用效果也很好,使HW702水平井顺利完钻,并获得工业油气流。     

机械锁定式地层测试技术研究与应用

机械锁定式测试技术操作简单，测试一次成功率高，资料录取准确全面，且测试结束后可直接进行封堵作业；解封时，机械锁紧产生一个向上的震击力，有利于解封，没有换位机构的测试阀在关井期间使管柱处于自由拉伸状态，有利于保护油管。在N阀上部管柱中加1-2根伸缩接头，便可用于海洋井测试。     

铅酸蓄电池的清洁生产

就中国铅酸蓄电池工业的可持续性发展与清洁生产问题进行了初步探讨,并就蓄电池正负极板水洗的清洁生产实例进行了介绍。     

东营凹陷古近系烃源岩超压特征及分布规律

统计分析1307口探井实测压力系数和83l口探井使用的钻井液密度数据，发现东营凹陷古近系沙三段、沙四段普遍存在异常超压，超压(压力系数1．1-1．5)主要出现在2100-3500m深度，强超压(压力系数大于1．5)主要出现在2800-3500m深度。东营凹陷沙三段、沙四段主力烃源岩超压平面分布具有北高南低、东高西低的总体特点，超压主要分布在洼陷带、断裂构造带和中央背斜带上。烃源岩压力系数等值线北部陡坡带比较密集，南部缓坡带相对稀疏。生油洼陷中心附近异常高压带的分布与生油洼陷基本一致，洼陷深陷区压力系数很大，向周围斜坡和构造高部位呈辐射状逐渐减小至正常，压力分布带与洼陷、边缘斜坡和构造较高部位的欠压实与压实带发育、分布规律的一致性很好。图3表l参9     

吐哈油田葡北3-12井超长封固段固井技术

葡北3-12注气井位于吐哈盆地葡北构造带中断葡北1号构造．井深为3610m。针对该区块地层承压能力低，易漏失，油气水窜严重，常规固井方法无法满足固井要求的问题，该井采用三段三凝制、常规水泥浆和泡沫水泥浆体系固井，并采用重钻井液顶替技术．降低施工压力。该技术能保证固井候凝过程中井底压力平衡，施工安全。现场应用表明，采用常规水泥浆和泡沫水泥浆固井技术．提高了低压易漏井、长封固井段的固井质量，解决了水泥返高不足的问题；并通过一次常规固井工艺实现了全井封固，简化了施工工艺，节约了成本，经济效益和社会效益十分显著。该井封固优质段累计达2600m，优质率达85％，固井结果良好。     

油基钻井液的推广及循环利用

针对普通水基钻井液在钻进中强、强水敏性油藏时会造成储层污染、产量降低的问题,指出了油基钻井液在钻进该类油藏时的优势和其成本高、对生态环境有污染的缺点。为了大面积推广应用油基钻井液,重点介绍了油基钻井液的特性和稳定性影响因素,并通过室内评价证明了油基钻井液在油层保护中的良好效果,着重阐述了油基钻井液在王庄油田的现场应用情况,并探讨了油基钻井液的循环利用技术。研究结果表明,油基钻井液不仅具有良好的油层保护效果,而且具有较好的社会经济效益。     

Microcalorimetry for characterization of film formation and cure of coatings and adhesives

A new microcalorimeter with eight parallel channels using robust, low cost sensors for characterization of coatings and adhesives is described and first experiments on coatings and adhesives are presented. The calorimetric sensors are based on thin glass plates (20 mm × 20 mm, thickness 150 μm) with heater and thermocouple sputtered on the surfaces (calorimetric active area of about 9 mm²). The setup allows heating and cooling experiments as well as isothermal measurements in the temperature-modulated mode with up to eight sensors in parallel. The measured quantities are the real (C^′_p) and imaginary part (C^″_p) of the complex heat capacity (), the related absolute value of the heat capacity () and the heat flow . An industrial computer (NI PXI system) with specific software for calibration and data recording controls the electronic components. Sensors can be embedded in a temperature controlled oven (heating and cooling by Peltier elements) or alternatively in a climatic cabinet with controlled temperature and humidity.

The method has been applied successfully to monitoring of film formation of aqueous polymer dispersions (styrene-acrylate copolymer) and curing of coatings.     

Methane/natural gas storage and delivered capacity for activated carbons in dry and wet conditions

Methane/natural gas storage and delivered capacity for three different activated carbons in dry and wet conditions were measured. In all tests the temperature of the bed was maintained constant at 277.15 K and pressure was increased up to 10 MPa. Natural gas storage capacity was less than methane storage capacity in dry conditions for all the three activated carbons tested, while the gas delivery was almost the same. One of activated carbon tested (NC120) showed the possibility of hydrate forming for pressures higher than 4 MPa but the amount of gas stored still was less than the amount stored in dry conditions over the whole range of pressure. The analysis of the gas delivered at each pressure steps shows that considerable amount of heavy components do not come out from the bed even at very low pressures in both dry and wet condition tests. Repeatability of the sorption/desorption processes - vital for possible commercial/industrial use - has been examined over various cycles.     

三探测器密度测井数据处理方法研究

数据处理方法研究是三探测器岩性密度测井研究的一个重要方面。在Monte Carlo模拟的基础上，提出了2种三探测器岩性密度测井求取地层光电吸收指数Pe和进行泥饼校正求取地层密度ρb的方法；就三探测器岩性密度测井仪DTLD—2的围岩补偿功能进行了研究。结果显示了用计算机模拟方法研究核测井问题可以节省建造实体物理模型的费用和人力，具有广泛的应用前景。