Improving performance of high-power indium gallium nitride/gallium nitride-based vertical light-emitting diodes by employing simple n-type electrode pattern

In this work, simple n-type electrode structures were used to enhance the electrical and optical performances of fully packaged commercially mass-produced vertical-geometry light-emitting diodes (VLEDs). The forward bias voltage of the VLED with a Y-pattern electrode increased less rapidly than that of VLEDs with a reference electrode. The VLEDs with the reference and Y-pattern electrodes exhibited forward voltages of 2.93±0.015 and 2.89±0.015 V at 350 mA and 3.77±0.015 and 3.53±0.015 V at 2000 mA, respectively. The VLEDs with the Y-pattern electrode resulted in a higher light output than the VLEDs with the reference electrode with increase in the drive current to 2000 mA. The emission images showed that the VLEDs with the Y-pattern electrode exhibited better current spreading behavior and lower junction temperatures than the VLEDs with the reference electrode. With increase in the current from 350 to 2000 mA, the VLEDs with the Y-pattern electrode experienced a 39.4% reduction in the wall plug efficiency, whereas the VLEDs with the reference electrode suffered from a 43.3% reduction.     

Characterizing physical habitat preferences and thermal refuge occupancy of brook trout (Salvelinus fontinalis) and Atlantic salmon (Salmo salar) at high river temperatures

Anthropogenic influences, including climate change, are increasing river temperatures in northern and temperate regions and threatening the thermal habitats of native salmonids. When river temperatures exceed the tolerance levels of brook trout and Atlantic salmon, individuals exhibit behavioural thermoregulation by seeking out cold‐water refugia – often created by tributaries and groundwater discharge. Thermal infrared (TIR) imagery was used to map cold‐water anomalies along a 53 km reach of the Cains River, New Brunswick. Trout and salmon parr did not use all identified thermal anomalies as refugia during higher river temperature periods (>21°C). Most small‐bodied trout (8–30 cm) were observed in 80% of the thermal anomalies sampled. Large‐bodied trout (>35 cm) required a more specific set of physical habitat conditions for suitable refugia, that is, 100% of observed large trout used 30% of the anomalies sampled and required water depths >65 cm within or adjacent to the anomaly. Densities of trout were significantly higher within anomalies compared with areas of ambient river temperature. Salmon parr were less aligned with thermal anomalies at the observed temperatures, that is, 59% were found in 65% of the sampled anomalies; and densities were not significantly different within/ outside anomalies. Salmon parr appeared to aggregate at 27°C, and after several events over 27°C variability in aggregation behaviour was observed – some fish aggregated at 25°C, others did not. We stipulate this is due to variances of thermal fatigue. Habitat suitability curves were developed for velocity, temperature, depth, substrate, and deep water availability to characterize conditions preferred by fish during high‐temperature events. These findings are useful for managers as our climate warms, and can potentially be used as a tool to help conserve and enhance thermal refugia for brook trout and Atlantic salmon in similar systems.     

面源红外诱饵对抗红外制导导弹干扰策略研究

面源红外诱饵使用的过程中,合理有效的干扰策略是干扰红外制导导弹的关键,针对这一问题,通过理论分析与仿真模拟相结合得到面源红外诱饵对抗红外制导导弹的干扰策略。首先以红外成像制导导弹为例,介绍红外制导导弹的仿真模型,然后将攻击过程分为锁定前与锁定后,以命中率为评价指标,得到两个阶段下的最佳干扰策略,包括诱饵的最佳释放时机、释放间隔以及载机应采取的机动动作等。     

红外探测技术的军事应用

主要针对目前雷达在现代战争中存在的致命弱点，提出了一种优势互补方案－将雷达作用距离远与红外探测系统被动接收、工作隐蔽等优点相结合，并详细论述雷达／红外区域防御系统中通信网工作原理及各站工作模式。     

红外光谱法用于快速测定车用柴油酸度等性质的研究

针对车用柴油酸度等性质测定过程繁琐，采用衰减全反射样品池测定车用柴油的红外光谱，用偏最小二乘法（PLS）建立红外光谱测定车用柴油酸度、密度、闪点和凝点的4个校正模型，验证标准误差分别为0.46 mg/(100 mL),0.77kg/m3,2.60 ℃,2.77 ℃，该方法符合标准方法再现性要求。与标准方法相比，该方法具有无需预处理、操作简单、测量快速、重复性好等优点。     

汽油烃类族组成测试方法对比

介绍了使用荧光指示剂吸附色谱法、多维气相色谱法的测定影响因素和近红外光谱快速法的分析特点以及三种方法在汽油族组成测定中的应用，并就三种方法对同一试样的测定结果进行了对比，找出各种测定方法容易产生误差的原因及分析对策。     

红外光谱法评价内燃机油高温清净性的研究

研究了内燃机油的红外光谱信息与其高温清净性能的相关性。根据内燃机油的红外光谱信息，采用量化自组织神经网络数学模型预测内燃机油的高温清净性能，在此基础上，建立了红外光谱快速检测内燃机油高温清净性能的方法。结果表明，预测结果的准确性、误差都能够满足对内燃机油高温清净性能测试的要求，红外光谱分析为快速检测内燃机油的高温清净性能提供了又一途径。     

AOTF红外光谱测量系统及其设计分析

介绍了一种以声光可调谐滤光器(AOTF)为色散元件的新型红外光谱测量系统。系统采用计算机控制下的直接数字频率合成(DDS)技术，实现电调谐波长扫描。采用双光束相关检测技术，改善了系统的信噪比。文中对红外光谱测量系统的有关设计问题进行了论述。     

玻璃微珠的表面化学镀银及红外辐射性能研究

采用化学镀方法在玻璃微珠表面镀银,考察了预处理条件、反应温度和反应时间等因素对玻璃微珠表面镀银的影响,并通过扫描电镜和X-射线衍射分析仪,对镀银后玻璃微珠的表面形貌和结构进行了观察和表征。将镀银玻璃微珠用于涂料中,考察了玻璃微珠在涂料中的应用及其红外辐射率的变化,探讨了化学镀条件对涂料红外辐射率的影响,结果表明,在控制反应温度和浓度的条件下,可使镀银玻璃微珠的红外辐射率由原来的1.02降为0.70,将其应用于涂料后,涂层的红外辐射率为0.80。     

单片机系统中减少功耗的几个实用技巧

本文介绍了单片机系统中通过改进软件设计减少LED功耗及三极管功耗的几个实用技巧。